Rolling Stock The Recipient agrees that any procurement for rolling stock will comply with 49 U.S.C. § 5325 (Contract Requirements), 49 U.S.C. § 5323(j) (Buy America Requirements), 49 U.S.C. § 5323(m) (Pre-Award and Post Delivery Requirements), and 49 U.S.C. § 5318(e) (Bus Testing Requirements), and their implementing regulations.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
Mail Order Catalog Warnings In the event that, the Settling Entity prints new catalogs and sells units of the Products via mail order through such catalogs to California consumers or through its customers, the Settling Entity shall provide a warning for each unit of such Product both on the label in accordance with subsection 2.4 above, and in the catalog in a manner that clearly associates the warning with the specific Product being purchased. Any warning provided in a mail order catalog shall be in the same type size or larger than other consumer information conveyed for such Product within the catalog and shall be located on the same display page of the item. The catalog warning may use the Short-Form Warning content described in subsection 2.3(b) if the language provided on the Product label also uses the Short-Form Warning.
Private Placement Warrants and Working Capital Warrants The Private Placement Warrants and the Working Capital Warrants shall be identical to the Public Warrants, except that so long as they are held by the Sponsor or any Permitted Transferees (as defined below), as applicable, the Private Placement Warrants and the Working Capital Warrants: (i) may be exercised for cash or on a cashless basis, pursuant to subsection 3.3.1(c) hereof, (ii) may not be transferred, assigned or sold until thirty (30) days after the completion by the Company of an initial Business Combination (as defined below), and (iii) shall not be redeemable by the Company; provided, however, that in the case of (ii) the Private Placement Warrants and the Working Capital Warrants and any shares of Common Stock held by the Sponsor or any Permitted Transferees, as applicable, and issued upon exercise of the Private Placement Warrants and the Working Capital Warrants may be transferred by the holders thereof: (a) to the Company’s officers or directors, any affiliate or family member of any of the Company’s officers or directors, any affiliate of the Sponsor or to any member(s) of the Sponsor or any of their affiliates, officers, directors and direct and indirect equityholders; (b) in the case of an individual, by gift to a member such individual’s immediate family or to a trust, the beneficiary of which is a member of such individual’s immediate family, an affiliate of such individual or to a charitable organization; (c) in the case of an individual, by virtue of the laws of descent and distribution upon death of such person; (d) in the case of an individual, pursuant to a qualified domestic relations order; (e) by private sales or transfers made in connection with the consummation of an initial Business Combination at prices no greater than the price at which the Warrants were originally purchased; (f) in the event of the Company’s liquidation prior to consummation of the Company’s Business Combination; or (g) by virtue of the laws of the State of Delaware or the Sponsor’s limited liability company agreement upon dissolution of the Sponsor; provided, however, that, in each case these permitted transferees (the “Permitted Transferees”) must enter into a written agreement with the Company agreeing to be bound by the transfer restrictions in this Agreement.
Unbundled Digital Loops 2.3.1 BellSouth will offer Unbundled Digital Loops (UDL). UDLs are service specific, will be designed, will be provisioned with test points (where appropriate), and will come standard with OC and a DLR. The various UDLs are intended to support a specific digital transmission scheme or service. 2.3.2 BellSouth shall make available the following UDLs, subject to restrictions set forth herein:
Exclusion of Private Placement Warrants and Working Capital Warrants The Company agrees that the redemption rights provided in this Section 6 shall not apply to the Private Placement Warrants or the Working Capital Warrants if at the time of the redemption such Private Placement Warrants or the Working Capital Warrants continue to be held by the Sponsor or any Permitted Transferees, as applicable. However, once such Private Placement Warrants or Working Capital Warrants are transferred (other than to Permitted Transferees under Section 2.6), the Company may redeem the Private Placement Warrants and the Working Capital Warrants, provided that the criteria for redemption are met, including the opportunity of the holder of such Private Placement Warrants or the Working Capital Warrants to exercise the Private Placement Warrants and the Working Capital Warrants prior to redemption pursuant to Section 6.3. Private Placement Warrants and Working Capital Warrants that are transferred to persons other than Permitted Transferees shall upon such transfer cease to be Private Placement Warrants or Working Capital Warrants and shall become Public Warrants under this Agreement.
Spare Parts 14.1 As specified, the supplier may be required to provide any or all of the following materials, notifications, and information pertaining to spare parts manufactured or distributed by the supplier: (a) such spare parts as the purchaser may elect to purchase from the supplier, provided that this election shall not relieve the supplier of any warranty obligations under the contract and; (b) In the event of termination of production of the spare parts: (i) advance notification to the purchaser of the pending termination, in sufficient time to permit the purchaser to procure needed requirements and; (ii) Following such termination, furnishing at no cost to the purchaser, the blueprints, drawings, and specifications of the spare parts, if requested.
Wire Unbundled DS1 Digital Loop This is a designed 4-wire Loop that is provisioned according to industry standards for DS1 or Primary Rate ISDN services and will come standard with a test point, OC, and a DLR. A DS1 Loop may be provisioned over a variety of loop transmission technologies including copper, HDSL-based technology or fiber optic transport systems. It will include a 4-Wire DS1 Network Interface at the End User’s location.
Packaging Materials and Containers for Retail Sale 1. When packaging materials and containers in which a good is packaged for retail sales are classified in the Harmonized System with the good, they shall not be taken into account in determining whether all non-originating materials used in the production of the good undergo the applicable change in tariff classification set out in Annex 4.03. 2. When the good is subject to a requirement of regional value content, the value of these packaging materials and containers shall be taken into account as originating or non-originating materials, as the case may be, in calculating the regional value content of the good.
MEASURING EQUIPMENT 1. Seller will maintain and operate, atlts own, expense and atthe point of delivery of gas hereunder, a meter or meters and othernecessary equipment by which the volume of gas delivered hereunder shall be measured. Such meters and equipment shall remain the property of the Seller. 2. Buyer agrees lo furnish to Seller electricity for operating Seller's meters, at not cost to Seller. 3. Buyer hereby grants to Seller suitable rlghts-0f-way and easements necessary or Incidental for the installatioo, maintenance, operation and removal of pipeline and other facilities together with rights ofingress thereto and egress there from at all times and hereby agrees to deliver to Seller, for the sum of one dollar ($1.00), an appropriate instrument or grant defining such rights and easements located on Buyer's planlslte. 4. Buyer may install, maintain and operate such check measuring equipment, Including arecording gravltometer and calorimeter as it shall desire, provided that such equipment shall be so installed so as not to Interfere with the operation of Seller's measuring equipment at or near the point of deliver. However, all xxxxxxxx to the Buyer shall be based on the metering of the Seller, subject only to the provisions of Paragraph 8 of this Article. 5. Each party shall have the right to be present at the time of any installing, reading, cleaning, changing, repairing, Inspecting, testing, calibrating, or adjusting done In connection with the other's measuring equlpme!lt used in measuring deliveries hereunder and each party shall advise the other of any Intended major maintenance operation sufficiently in advance in order that the other party may conveniently have its representative present. 6. All installatioo of measuring equipmenL applying to or effecting deliveries hereunder, shall be rnade in such manner as to perrnit an accurate detenninalion of the quantity of gas delivered and ready verification of the accuracy of measurement Orifice meter Installations, If used, shall oonforrn lo the recommendation for design and lnstallatioo contained in the Gas Measurement Commiltee Report No. 3 to the American Gas Association published April, 1955, and any modificatioos and amendments thereof and shall include the use of flange connections. 7. Measurement on Seller's meter or meters shall be conclusive of both parties except where the meter Is defective or fails to register, or if found in E)rror, in either of which case Seller shall repair or replace the meter and the quantity of gas delivered while the meter was out of order or failed to register shall be estimated: (a) By using the registration of any check meter If installed and accurately registering, or, In the absence of (a): (b) By correcting the error If the percentage of error by calibration, test or mathematical calculation, or, in the absence of both (a) and (b) then: (c) By estimating the quantity of delivery from deliveries during periods under similar oonditions when the meter was registering actUrately; and an appropriate billing adjusbnentshall be made In accordance with the current Rules and Regulations governing gas systems issued by the Commission. 8. Seller will maintain its meters in .good order and to this end Wiii make periodic tests of its meters pursuant to the current Rules and Regulations governing gas systems issued by the Commission, or at such shorter intervals as seem to Seller desirable. lfBuyer Is dissatisfied with the accuracy at eny time, it may call upon Seller to have Iha meter tested in accordance with all regulatioos relating to such tests and results of such tesls as found in the current Rules and Regulations governing gas systems issued by the Commission. 9. Each party shall preserve all records for aperiod of at least two (2) years.
