Compliance with Data Privacy and Security Laws and Standards Contractor shall comply with all applicable State and federal data privacy and data security laws, rules, and regulations.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
CONFIDENTIALITY AND PRIVACY POLICIES AND LAWS The Contractor shall comply to the extent applicable with all State and Authorized User policies regarding compliance with various confidentiality and privacy laws, rules and regulations, including but not limited to the IRS Publication 1075, Family Educational Rights and Privacy Act (FERPA), the Health Insurance and Portability Act of 1996 (HIPAA) and the Health Information Technology for Economic and Clinical Health Act (HITECH). Contractor shall cooperate in executing a written confidentiality agreement under FERPA and/or a Business Associate Agreement (HIPAA/HITECH) or other contractual provisions upon request by the State or any Authorized User.
Limitation on Out-of-State Litigation - Texas Business and Commerce Code § 272 This is a requirement of the TIPS Contract and is non-negotiable. Texas Business and Commerce Code § 272 prohibits a construction contract, or an agreement collateral to or affecting the construction contract, from containing a provision making the contract or agreement, or any conflict arising under the contract or agreement, subject to another state’s law, litigation in the courts of another state, or arbitration in another state. If included in Texas construction contracts, such provisions are voidable by a party obligated by the contract or agreement to perform the work. By submission of this proposal, Vendor acknowledges this law and if Vendor enters into a construction contract with a Texas TIPS Member under this procurement, Vendor certifies compliance.
Certification of Compliance with the Energy Policy and Conservation Act When appropriate and to the extent consistent with the law, Vendor certifies that it will comply with the Energy Policy and Conservation Act (42 U.S.C. 6321 et seq; 49 C.F.R. Part 18) and any mandatory standards and policies relating to energy efficiency which are contained in applicable state energy conservation plans issued in compliance with the Act. Does Vendor agree? Yes
Provisions for Covered Entity to Inform Business Associate of Privacy Practices and Restrictions (a) Covered Entity shall notify Business Associate of any limitation(s) in the notice of privacy practices of Covered Entity under 45 CFR 164.520, to the extent that such limitation may affect Business Associate’s use or disclosure of protected health information.
Policy and Procedures If the resident leaves the facility due to hospitalization or a therapeutic leave, the facility shall not be obligated to hold the resident’s bed available until his or her return, unless prior arrangements have been made for a bed hold pursuant to the facility’s “Bed Reservation Policy and Procedure” and pursuant to applicable law. In the absence of a bed hold, the resident is not guaranteed readmission unless the resident is eligible for Medicaid and requires the services provided by the facility. However, the resident may be placed in any appropriate bed in a semi-private room in the facility at the time of his or her return from hospitalization or therapeutic leave provided a bed is available and the resident’s admission is appropriate and meets the readmission requirements of the facility.
COMPLIANCE WITH HEALTH, SAFETY, AND ENVIRONMENTAL REGULATIONS The Contractor, it’s Subcontractors, and their respective employees, shall comply fully with all applicable federal, state, and local health, safety, and environmental laws, ordinances, rules and regulations in the performance of the services, including but not limited to those promulgated by the City and by the Occupational Safety and Health Administration (OSHA). In case of conflict, the most stringent safety requirement shall govern. The Contractor shall indemnify and hold the City harmless from and against all claims, demands, suits, actions, judgments, fines, penalties and liability of every kind arising from the breach of the Contractor’s obligations under this paragraph.
Confidentiality and Data Protection 12.1 Buyer undertakes that it shall not at any time disclose to any person any confidential information concerning (i) the business, affairs, customers, clients or suppliers of Seller or any of its affiliates and (ii) the operations, processes, product information, recipes and formulae, know-how, designs, trade secrets of Seller or any of its affiliates, except as permitted by Condition 12.2 (“Confidential Information”).
Policy and Procedure Every employee has the right to work in an environment free of discrimination and harassment. This right includes the responsibility to eliminate harassment in our workplace, either as a participant or as an observer. This policy and procedure outlines the commitment of Chrysler Canada Inc. to ensure a harassment-free workplace as required under the Ontario Human Rights Code and will act as a guide to employees in adhering to legal and social guidelines regarding the recognition and prevention of harassment. This policy exists to underline the seriousness of workplace harassment and to establish that there is no acceptable level of harassment at Chrysler Canada Inc. Employees who feel that they are being harassed are encouraged to seek protection under this policy. Harassment, discrimination or solicitation, whether verbal, physical or environmental is not acceptable and will not be tolerated. (c05)
