Single Line Diagram and Connection Point Sample Clauses

Single Line Diagram and Connection Point. [To be inserted by the Parties] B.2 List of Facilities on the Property of the Other Party
Sample 1Sample 2Sample 3See All (9)
AutoNDA by SimpleDocs
Single Line Diagram and Connection Point. [To be inserted by the Parties] List of Facilities on the Property of the Other Party 1 The following facilities of the Customer are located on the property of the Distributor: [To be completed by the Parties] 2 The following facilities of the Distributor are located in the property of the Customer: [To be completed by the Parties] Metering Installation Diagram [To be inserted by the Parties] SCHEDULE C List of Other Contracts (section 3.4) The following other contracts have been or will be entered into by the Parties: [To be completed by the Parties] SCHEDULE D Technical and Operating Requirements (section 4.1(d)) The following technical and operating requirements apply to the Facility: [To be completed by the Parties] SCHEDULE E Billing and Settlement Procedures (section 5.3) The following provisions apply in relation to billing and settlement in relation to the Facility: [To be completed by the Parties] SCHEDULE F Contacts for Notice (section 12.1) [To be completed by the Parties – different contacts may be listed for different purposes] SCHEDULE G
Sample 1
Single Line Diagram and Connection Point. [To be inserted by the Parties] B.2 List of Facilities on the Property of the Other Party B.2.1 the following facilities of the Customer are located on the property of the Distributor: [To be completed by the Parties]
Sample 1
Single Line Diagram and Connection Point. B.1.2 As-Built Single Line Diagram (See following Page) B.2 List of Facilities on the Property of the Other Party
Sample 1
Single Line Diagram and Connection Point. See drawing <insert drawing number> - Dated <insert date>
Sample 1

Related to Single Line Diagram and Connection Point

  • Interconnection Points 8.5.1 The IP of a Party (“Receiving Party”) for Measured Internet Traffic delivered to the Receiving Party by the other Party shall be the same as the IP of the Receiving Party for Reciprocal Compensation Traffic under Section 7.1 above.

  • Demarcation Point 98.1 CenturyLink will designate the point of demarcation between CenturyLink’s equipment and CLEC’s collocated equipment, which point of demarcation shall be in or adjacent to its Collocation Space unless otherwise mutually agreed to by the Parties. At CLEC's request, CenturyLink will identify the location(s) of other possible demarcation points available to CLEC, and CLEC will designate from these location(s) the point(s) of demarcation between its collocated equipment and CenturyLink's equipment. CenturyLink will use its best efforts to identify the closest demarcation point to CLEC's equipment that is available.

  • NETWORK INTERCONNECTION METHODS 64.1 This Section sets forth the terms and conditions for Network Interconnection Methods (NIMs) provided between CenturyLink and CLEC for the Interconnection Facilities established between the Parties’ networks. Additionally, this Section describes the physical architecture for the Interconnection of the Parties’ facilities and equipment required for the transmission and routing of Local Traffic, ISP-Bound Traffic, IntraLATA LEC Toll Traffic, VoIP-PSTN Traffic, Transit Traffic and Jointly Provided Switched Access Service Traffic.

  • Interconnection Customer’s Interconnection Facilities The Interconnection Customer shall design, procure, construct, install, own and/or control the Interconnection Customer’s Interconnection Facilities described in Appendix A at its sole expense.

  • Utilization Scale STATE shall scale logs or portions of logs that are broken, wasted, or not removed by PURCHASER due to: (1) improper felling or bucking of the logs; (2) failure to remove the logs prior to deterioration; and (3) logs remaining on the timber sale area after completion of logging, provided the logs were merchantable prior to breakage or wastage. Material used to meet down material requirements in the section titled, "Reserved Timber," shall not be considered for utilization scale. PURCHASER shall pay for the logs at the contract price designated in Section 44. STATE shall notify PURCHASER of the volume of logs so scaled. Payment shall be considered due on such volume as if the logs were removed on the date of said notification. In the event PURCHASER disagrees with the findings made by STATE under this section, PURCHASER may furnish scaling by a third-party scaling organization acceptable to STATE. Costs and expenses of such third party shall be paid for by PURCHASER, and the findings of the third party shall be final.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Interconnection Facility Options The Intercarrier Compensation provisions of this Agreement shall apply to the exchange of Exchange Service (EAS/Local) traffic between CLEC's network and Qwest's network. Where either Party acts as an IntraLATA Toll provider, each Party shall xxxx the other the appropriate charges pursuant to its respective tariff or price lists. Where either Party interconnects and delivers traffic to the other from third parties, each Party shall xxxx such third parties the appropriate charges pursuant to its respective tariffs, price lists or contractual offerings for such third party terminations. Absent a separately negotiated agreement to the contrary, the Parties will directly exchange traffic between their respective networks without the use of third party transit providers.

Time is Money Join Law Insider Premium to draft better contracts faster.