Site Calibration. In case Site Calibration revealed to be necessary according to the conclusions of 5.2.2 of this Part J-2-A, the IE will perform that Site Calibration in accordance to Annex C of [Ref.1] for each of the TWT requiring it. The Site Calibration works, involving the installation of met mast/s in the position of the TWT, will be scheduled in a manner that does not interfere on the civil works of the wind farm. The IE will propose a detailed schedule for the acceptance of the Parties. The IE will report periodically including information of the status of completion of the Site Calibration according to [Ref.1]. It will be aimed at the completion of representative measurement sectors which allows for the execution of the subsequent Power Curve Test in a reasonable amount of time. In case the Site Calibration must be extended for that purpose, the Parties will collaborate in the definition of the best solution which allows the completion of the measurements and causes the lowest impact on the execution of the wind farm works. The IE will issue a Site Calibration report according to [Ref.1], which will be shared between the involved parties. Regarding the procedure of site calibration, the requirements of points C.7 and C.8 of Annex C of IEC61400-12-1 Ed.2 should be met, especially the points related to: - Convergence check - Correlation check for linear regression - Change in correction between adjacent wind direction bins If these conditions are not met, the site calibration procedure will be carefully reviewed and, under consideration of the IE, uncertainties might be reviewed.
Appears in 4 contracts
Samples: Membership Interest Purchase, Project Development and Construction Management Agreement, Membership Interest Purchase, Project Development and Construction Management Agreement, Membership Interest Purchase, Project Development and Construction Management Agreement
