Stature Calculation. The measurements taken in Sections 1 and 2 shall then be compared to the values shown in Annex 18, Table 1. Interpolation between the values shown in the table is allowed at one-centimetre intervals. For each measurement, the corresponding stature at the nearest whole lower centimetre shall be calculated. Maximum stature For the measurements B, C, D, E2, F2 and G2, the measured value must be greater than or equal to the value shown in the table to meet the stature requirement. For example to declare a stature of 105 cm the measured sitting height after applying tolerances must be greater or equal to 61.8 cm. The maximum stature is the smallest stature calculated from the measurements B, C, D, E2, F2 and G2. Minimum stature For the measurements E1, F1 and G1, the measured value must be less than or equal to the value shown in the table to meet the stature requirement. For example to declare a stature of 100 cm, the measured shoulder height after applying tolerances must be less than or equal to 32.4 cm. The minimum stature is the largest stature calculated from the measurements E1, F1 and G1."
Appears in 3 contracts
Stature Calculation. The measurements taken in Sections 1 and 2 shall then be compared to the values shown in Annex 18, Table 1. Interpolation between the values shown in the table is allowed at one-centimetre intervals. For each measurement, the corresponding stature at the nearest whole lower centimetre shall be calculated. Maximum stature For the measurements B, C, D, E2, F2 and G2, the measured value must be greater than or equal to the value shown in the table to meet the stature requirement. For example to declare a stature of 105 cm the measured sitting height after applying tolerances must be greater or equal to 61.8 cm. The maximum stature is the smallest stature calculated from the measurements B, C, D, E2, F2 and G2. Minimum stature For the measurements E1, F1 and G1, the measured value must be less than or equal to the value shown in the table to meet the stature requirement. For example to declare a stature of 100 cm, the measured shoulder height after applying tolerances must be less than or equal to 32.4 cm. The minimum stature is the largest stature calculated from the measurements E1, F1 and G1.". Annex 19 Assessment volumes for i-size support-legs and support-leg feet Figure 1 Side view of the support leg dimension assessment volume (dimensions in mm) Key:
Appears in 2 contracts
