Status of and Conservation Goals for the Covered Species Sample Clauses

Status of and Conservation Goals for the Covered Species 
AutoNDA by SimpleDocs

Related to Status of and Conservation Goals for the Covered Species

  • Proof of Compliance with Workers’ Compensation Coverage Requirements An XXXXX form is NOT acceptable proof of workers’ compensation coverage. In order to provide proof of compliance with the requirements of the Workers’ Compensation Law pertaining to workers’ compensation coverage, a contractor shall:

  • Proof of Compliance with Disability Benefits Coverage Requirements In order to provide proof of compliance with the requirements of the Workers’ Compensation Law pertaining to disability benefits, a contractor shall:

  • Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.

  • GEOGRAPHIC AREA AND SECTOR SPECIFIC ALLOWANCES, CONDITIONS AND EXCEPTIONS The following allowances and conditions shall apply where relevant: Where the company does work which falls under the following headings, the company agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.

  • Nondiscrimination - ADA Compliance Contractor agrees to comply with Title VI of the Civil Rights Act of 1964, with Section V of the Rehabilitation Act of 1973, and with all applicable requirements of federal and state civil rights and rehabilitation statutes, rules and regulations. Contractor also shall comply with the Americans with Disabilities Act (ADA) of 1990, as amended by the ADA Amendments Act (ADAAA) of 2008 and any subsequent amendments (42 U.S.C. § 12101, et seq.) (Pub No. 101-336), ORS 659A, and all regulations and administrative rules established pursuant to those laws. Contractor agrees to comply with ADA in its employment and nondiscrimination practices, and that it shall perform its contractual obligations consistent with ADA federal requirements/regulations, state disability and accessibility law and requirements, and applicable regulations and administrative rules established pursuant to those laws.

  • COMPLIANCE WITH ENERGY POLICY AND CONSERVATION ACT Contractor certifies that Contractor will be in compliance with mandatory standards and policies relating to energy efficiency which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act (Pub. L. 94-163, 89 Stat. 871). Attachment A NorMont Equipment Co. Sewer Cleaning, Hydro-Excavating, Inspection Equipment and Miscellaneous Services Contract No. SC01-21A H-GAC PRODUCT ITEM BASE OFFERING PRICES H-GAC Product Code Description Base Offered Price Envirosight

  • Health and Safety Provisions The Employer shall continue to make and enforce provisions for the occupational health, safety, and security of employees. The Employer will respond to suggestions on the subject from the Union and the parties undertake to consult with a view to adopting and expeditiously carrying out reasonable procedures and techniques designed or intended to prevent or reduce the risk of employment injury and employment-related chronic illness.

  • Criteria for Performance Assessment A. A teacher’s performance shall be assessed based on the criteria set forth in the evaluation instrument, Appendix D.

  • Certification of Meeting or Exceeding Tobacco-Free Workplace Policy Minimum Standards A. Grantee certifies that it has adopted and enforces a Tobacco-Free Workplace Policy that meets or exceeds all of the following minimum standards of:

  • ENERGY POLICY AND CONSERVATION ACT COMPLIANCE To the extent applicable, Supplier must comply with the mandatory standards and policies relating to energy efficiency which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act.

Time is Money Join Law Insider Premium to draft better contracts faster.