Stocking of Spare Parts Sample Clauses

Stocking of Spare Parts. As soon as reasonably possible after receipt of IAE’s request, Spirit shall provide IAE with information reasonably required to enable IAE to plan and organize the manufacture and stocking of Spare Parts.
AutoNDA by SimpleDocs
Stocking of Spare Parts. Upon request, New Air shall provide IAE with information reasonably required to enable IAE to plan and organize the manufacture and stocking of Spare Parts.
Stocking of Spare Parts. Promptly following receipt of IAE’s request, AAH shall provide IAE with information reasonably required to enable IAE to plan and organize the manufacture and stocking of Spare Parts.
Stocking of Spare Parts. Upon request, AWA shall provide IAE with information reasonably required to enable IAE to organize the manufacture and stocking of Spare Parts efficiently.
Stocking of Spare Parts. Upon request, Midway shall provide IAE with information reasonably required to enable IAE to organize the manufacture and stocking of Spare Parts efficiently.
Stocking of Spare Parts. Within a reasonable time following IAE's request, ACA shall provide IAE with information reasonably required to enable IAE to plan and organize the manufacture and stocking of Spare Parts.

Related to Stocking of Spare Parts

  • Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.

  • Reporting of Sales to TIPS by Vendor The Participation Fee that was published as part of the Solicitation and the fee published is the legally effective fee, along with any fee conditions stated in the Solicitation. Collection of the fees by TIPS is required under Texas Government Code §791.011 Et seq. Fees are due on all TIPS purchases reported by either Vendor or Member. Fees are due to TIPS upon payment by the Member to the Vendor, Reseller or Vendor Assigned Dealer. Vendor, Reseller or Vendor Assigned Dealer agrees that the participation fee is due to TIPS for all Agreement sales immediately upon receipt of payment including partial payment, from the Member Entity and must be paid to TIPS at least on a monthly basis, specifically within 31 calendar days of receipt of payment, if not more frequently, or as otherwise agreed by TIPS in writing and signed by an authorized signatory of TIPS. Thus, when an awarded Vendor, Reseller or Vendor Assigned Dealer receives any amount of payment, even partial payment, for a TIPS sale, the legally effective fee for that amount is immediately due to TIPS from the Vendor and fees due to TIPS should be paid at least on a monthly basis, specifically within 31 calendar days of receipt of payment, if not more frequently. Vendor is required to report all sales under the TIPS contract to TIPS. When a public entity initiates a purchase with a TIPS Awarded Vendor, if the Member inquires verbally or in writing whether the Vendor holds a TIPS Contract, it is the duty of the Vendor to verify whether or not the Member is seeking a TIPS purchase. Once verified, the Vendor must include the TIPS Contract number on any communications and related sales documents exchanged with the TIPS Member entity. To report sales, the Vendor must login to the TIPS Vendor Portal online at xxxxx://xxx.xxxx-xxx.xxx/vendors_form.cfm and click on the PO’s and Payments tab. Pages 3-7 of the Vendor Portal User Guide will walk you through the process of reporting sales to TIPS. Please refer to the TIPS Accounting FAQ’s for more information about reporting sales and if you have further questions, contact the Accounting Team at xxxxxxxxxx@xxxx-xxx.xxx. The Vendor or vendor assigned dealers are responsible for keeping record of all sales that go through the TIPS Agreement and submitting same to TIPS. Failure to render the participation fee to TIPS shall constitute a breach of this agreement with our parent governmental entity, Texas Education Service Center Region 8, as established by the Texas legislature and shall be grounds for termination of this agreement and any other agreement held with TIPS and possible legal action. Any overpayment of participation fees to TIPS by a Vendor will be refunded to the Vendor within ninety (90) days of receipt of notification if TIPS receives written notification of the overpayment not later than the expiration of six (6) months from the date of overpayment and TIPS determines that the amount was not legally due to TIPS pursuant to this agreement and applicable law. It is the Vendor’s responsibility to identify which sales are TIPS Agreement sales and pay the correct participation fee due for TIPS Agreement sales. Any notification of overpayment received by TIPS after the expiration of six (6) months from the date of overpayment will be non-refundable. Region 8 ESC and TIPS reserve the right to extend the six (6) month deadline to notify if approved by the Region 8 ESC Board of Directors. TIPS reserves all rights under the law to collect the fees due. Please contact TIPS at xxxx@xxxx-xxx.xxx or call (000) 000-0000 if you have questions about paying fees.

  • Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.

  • Spare Parts 14.1 As specified, the supplier may be required to provide any or all of the following materials, notifications, and information pertaining to spare parts manufactured or distributed by the supplier: (a) such spare parts as the purchaser may elect to purchase from the supplier, provided that this election shall not relieve the supplier of any warranty obligations under the contract and; (b) In the event of termination of production of the spare parts: (i) advance notification to the purchaser of the pending termination, in sufficient time to permit the purchaser to procure needed requirements and; (ii) Following such termination, furnishing at no cost to the purchaser, the blueprints, drawings, and specifications of the spare parts, if requested.

  • RECORDING OF SERVICE INSTRUCTIONS The Bank may (but shall not be obliged to) at its absolute discretion tape or otherwise record all Service Instructions, and the Account Holder agrees to the use of such tapes or recordings and any transcripts thereof which the Bank may make for any purpose that the Bank deems desirable, including their use as evidence in any proceedings against the Account Holder or any other person.

  • Spares Boeing will revise, as applicable, the customized Recommended Spares Parts List (RSPL) and Illustrated Parts Catalog (IPC).

  • Accessories, Spare Parts and Tools Accessories, spare parts and tools dispatched with a piece of equipment, machine, apparatus or vehicle, which are part of the normal equipment and included in the price thereof or which are not separately invoiced, shall be regarded as one with the piece of equipment, machine, apparatus or vehicle in question.

  • Scheduling of Vacation A) The Employer shall permit annual vacations to be taken during the entire year. B) The scheduling of vacations shall be subject to the operational requirements of the Employer. C) The selection of vacation and the posting of the approved vacation schedule shall be completed by December 31st of the preceding calendar year or any other date mutually agreed at the local level. Such local agreements shall be filed with the Union and Employer. D) Once the approved vacation schedule has been posted, it shall only be changed by mutual consent. E) Vacation entitlement accrued to June 30 (inclusive) shall be taken prior to January 1 in the following year unless otherwise required by operational necessity. Despite the above, where an employee’s vacation is cancelled by the Employer due to operational requirements, the employee may elect to carry over up to seven (7) days to be used no later than June 30 in the following year. Unused vacation shall be paid out at straight time rates by the last pay period of February of the following year. Payout shall not include any carryover of vacation pursuant to the above. F) Employees may, prior to the scheduling of vacations, request to have their vacations scheduled in accordance with either the principle of seniority or on a rotating basis. Where a consensus of employees cannot be reached as above, vacations shall be scheduled according to seniority on the basis that the employees with the most seniority shall have the first choice of vacation times. Employees failing to exercise their rights within the vacation selection time posted by the Employer shall forfeit their seniority rights in respect to choice of vacation time. G) Vacation time may be divided and shall be scheduled at a time mutually agreeable to the employee and the Employer, however, an employee who splits her vacation shall not receive her choice of when she wishes to take the subsequent portion of her vacation until all other employees in the unit or xxxx have made their first choice of vacation time.

  • Posting of Schedules The Employer shall post the weekly work schedule for all employees not later than Monday 6:00 p.m. and twenty-two (22) days in advance. An employee's schedule may be changed without notice in the event of absence of other staff due to sickness or accident or in the event of emergencies. In all other cases, at least twenty-four (24) hours' notice of any change must be given or four (4) additional hours' pay given in lieu of notice. All requests for time off for special personal events to be made to Management for their approval prior to the posting of the schedule, and will be granted wherever possible. It is understood that this clause does not apply to casual employees. There shall be a daily starting time for each employee. Daily hours of work for full time employees shall be consecutive, with the exception of meal periods.

  • Reporting of Sick Leave The employee will call in sick or returning in accordance with Article 14.05 to the designated employer for purposes of payment. For purposes of notification of absence, the employee will notify the appropriate home in accordance with Article 14.05 of their absence that shift.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!