PRODUCT SUBSTITUTION In the event a specified manufacturer’s Product listed in the Contract becomes unavailable or cannot be supplied by the Contractor for any reason (except as provided for in the Savings/Force Majeure Clause) a Product deemed in writing by the Commissioner to be equal to or better than the specified Product must be substituted by the Contractor at no additional cost or expense to the Authorized User. Unless otherwise specified, any substitution of Product prior to the Commissioner’s written approval may be cause for cancellation of Contract.
Substitution of Equipment In the event the Computer is inoperable, ASL has a limited number of spare laptops for use while the Computer is being repaired or replaced. This agreement remains in effect for such a substitute. The Student may NOT opt to keep a broken Computer or to avoid using the Computer due to loss or damage.
Substitution of Engines Upon the occurrence of an Event of Loss with respect to an Engine under circumstances in which an Event of Loss with respect to the Airframe has not occurred, Owner shall promptly (and in any event within 15 days after such occurrence) give the Mortgagee written notice of such Event of Loss. The Owner shall have the right at its option at any time, on at least 5 Business Days' prior notice to the Mortgagee, to substitute, and if an Event of Loss shall have occurred with respect to an Engine under circumstances in which an Event of Loss with respect to the Airframe has not occurred, shall within 60 days of the occurrence of such Event of Loss substitute, a Replacement Engine for any Engine. In such event, immediately upon the effectiveness of such substitution and without further act, (i) the replaced Engine shall thereupon be free and clear of all rights of the Mortgagee and the Lien of this Trust Indenture and shall no longer be deemed an Engine hereunder and (ii) such Replacement Engine shall become subject to this Trust Indenture and be deemed part of the Aircraft for all purposes hereof to the same extent as the replaced Engine. Such Replacement Engine shall be an engine manufactured by Engine Manufacturer that is the same model as the Engine to be replaced thereby, or an improved model, and that is suitable for installation and use on the Airframe, and that has a value, utility and remaining useful life (without regard to hours and cycles remaining until overhaul) at least equal to the Engine to be replaced thereby (assuming that such Engine had been maintained in accordance with this Trust Indenture). The Owner's right to make a replacement hereunder shall be subject to the fulfillment (which may be simultaneous with such replacement) of the following conditions precedent at the Owner's sole cost and expense, and the Mortgagee agrees to cooperate with the Owner to the extent necessary to enable it to timely satisfy such conditions:
(i) an executed counterpart of each of the following documents shall be delivered to the Mortgagee:
(A) a Trust Indenture Supplement covering the Replacement Engine, which shall have been duly filed for recordation pursuant to the Act or such other applicable law of the jurisdiction other than the United States in which the Aircraft of which such Engine is a part is registered in accordance with Section 4.02(e), as the case may be;
(B) a full warranty xxxx of sale (as to title), covering the Replacement Engine, executed by the former owner thereof in favor of the Owner (or, at the Owner's option, other evidence of the Owner's ownership of such Replacement Engine, reasonably satisfactory to the Mortgagee); and
(C) UCC financing statements covering the security interests created by this Trust Indenture (or any similar statements or other documents required to be filed or delivered pursuant to the laws of the jurisdiction in which such Aircraft may be registered) as are deemed necessary or desirable by counsel for the Mortgagee to protect the security interests of the Mortgagee in the Replacement Engine;
(ii) the Owner shall cause to be delivered to the Mortgagee an opinion of counsel to the effect that the Lien of this Trust Indenture continues to be in full force and effect with respect to the Replacement Engine and such evidence of compliance with the insurance provisions of Section 4.06 with respect to such Replacement Engine as Mortgagee shall reasonably request;
(iii) the Owner shall have furnished to Mortgagee an opinion of Owner's aviation law counsel reasonably satisfactory to Mortgagee and addressed to Mortgagee as to the due filing for recordation of the Trust Indenture Supplement with respect to such Replacement Engine under the Act or such other applicable law of the jurisdiction other than the United States in which the Aircraft is registered in accordance with Section 4.02(e), as the case may be; and
(iv) the Owner shall have furnished to Mortgagee a certificate of a qualified aircraft engineer (who may be an employee of Owner) certifying that such Replacement Engine has a value and utility and remaining useful life (without regard to hours and cycles remaining until overhaul) at least equal to the Engine so replaced (assuming that such Engine had been maintained in accordance with this Trust Indenture). Upon satisfaction of all conditions to such substitution, (x) the Mortgagee shall execute and deliver to the Owner such documents and instruments, prepared at the Owner's expense, as the Owner shall reasonably request to evidence the release of such replaced Engine from the Lien of this Trust Indenture, (y) the Mortgagee shall assign to the Owner all claims it may have against any other Person relating to any Event of Loss giving rise to such substitution and (z) the Owner shall receive all insurance proceeds (other than those reserved to others under Section 4.06(b)) and proceeds in respect of any Event of Loss giving rise to such replacement to the extent not previously applied to the purchase price of the Replacement Engine as provided in Section 4.05(d).
Combination Products If a LICENSED PRODUCT is sold to any third party in combination with other products, devices, components or materials that are capable of being sold separately and are not subject to royalties hereunder (“OTHER PRODUCTS,” with the combination of products being referred to as “COMBINATION PRODUCTS” and the Other Product and Licensed Product in such Combination Product being referred to as the “COMPONENTS”), the NET SALES of such LICENSED PRODUCT included in such COMBINATION PRODUCT shall be calculated by multiplying the NET SALES of the COMBINATION PRODUCT by the fraction A/(A+B), where A is the average NET SALES price of such LICENSED PRODUCT in the relevant country, as sold separately, and B is the total average NET SALES price of all OTHER PRODUCTS in the COMBINATION PRODUCT in the relevant country, as sold separately. If, in any country, any COMPONENT is not sold separately, NET SALES for royalty determination shall be determined by the formula [C / (C+D)], where C is the aggregate average fully absorbed cost of the Licensed Product components during the prior Royalty Period and D is the aggregate average fully absorbed cost of the other essential functional components during the prior Royalty Period, with such costs being determined in accordance with generally accepted accounting principles. To the extent that any SUBLICENSE INCOME relates to a COMBINATION PRODUCT or is otherwise calculated based on the value of one or more licenses or intellectual property rights held by the COMPANY, an AFFILIATE or SUBLICENSEE, COMPANY shall determine in good faith and report to THE PARTIES the share of such payments reasonably attributable to COMPANY’s or such AFFILIATE’s sublicense of the rights granted hereunder, based upon their relative importance and proprietary protection, which portion shall be the SUBLICENSE INCOME. THE PARTIES shall have the right to dispute such sharing determination in accordance with the dispute provisions of the AGREEMENT.
Loss Mitigation and Consideration of Alternatives (i) For each Single Family Shared-Loss Loan in default or for which a default is reasonably foreseeable, the Assuming Institution shall undertake reasonable and customary loss mitigation efforts, in accordance with any of the following programs selected by Assuming Institution in its sole discretion, Exhibit 5 (FDIC Mortgage Loan Modification Program), the United States Treasury's Home Affordable Modification Program Guidelines or any other modification program approved by the United States Treasury Department, the Corporation, the Board of Governors of the Federal Reserve System or any other governmental agency (it being understood that the Assuming Institution can select different programs for the various Single Family Shared-Loss Loans) (such program chosen, the “Modification Guidelines”). After selecting the applicable Modification Guideline for each such Single Family Shared-Loss Loan, the Assuming Institution shall document its consideration of foreclosure, loan restructuring under the applicable Modification Guideline chosen, and short-sale (if short-sale is a viable option) alternatives and shall select the alternative the Assuming Institution believes, based on its estimated calculations, will result in the least Loss. If unemployment or underemployment is the primary cause for default or for which a default is reasonably foreseeable, the Assuming Institution may consider the borrower for a temporary forbearance plan which reduces the loan payment to an affordable level for at least six (6) months.
(ii) Losses on Home Equity Loans shall be shared under the charge-off policies of the Assuming Institution’s Examination Criteria as if they were Single Family Shared-Loss Loans.
(iii) Losses on Investor-Owned Residential Loans shall be treated as Restructured Loans, and with the consent of the Receiver can be restructured under terms separate from the Exhibit 5 standards. Please refer to Exhibits 2(a)(1)-(2) for guidance in Calculation of Loss for Restructured Loans. Losses on Investor-Owned Residential Loans will be treated as if they were Single Family Shared-Loss Loans.
(iv) The Assuming Institution shall retain its loss calculations for the Shared Loss Loans and such calculations shall be provided to the Receiver upon request. For the avoidance of doubt and notwithstanding anything herein to the contrary, (x) the Assuming Institution is not required to modify or restructure any Shared-Loss Loan on more than one occasion and (y) the Assuming Institution is not required to consider any alternatives with respect to any Shared-Loss Loan in the process of foreclosure as of the Bank Closing if the Assuming Institution can document that a loan modification is not cost effective and shall be entitled to continue such foreclosure measures and recover the Foreclosure Loss as provided herein, and (z) the Assuming Institution shall have a transition period of up to 90 days after Bank Closing to implement the Modification Guidelines, during which time, the Assuming Institution may submit claims under such guidelines as may be in place at the Failed Bank.
Third Party Components The Products and Services may contain third party components (including open source software) subject to separate license agreements. To the limited extent a third party license expressly supersedes this XXXX, such third party license governs Customer’s use of that third party component.
Substitution of Receipts At the request of a Holder, the Depositary shall, for the purpose of substituting a certificated Receipt with a Receipt issued through any book-entry system, including, without limitation, DRS/Profile, or vice versa, execute and Deliver a certificated Receipt or deliver a statement, as the case may be, for any authorized number of ADSs requested, evidencing the same aggregate number of ADSs as those evidenced by the relevant Receipt.
Payment for Forest Products Delivered Purchaser agrees to pay the State for delivered forest products at the following rate: $0.00/MBF $250.00/MBF for incorrect species delivery* $20/mbf for Utility logs (Adjusted Gross). Purchaser agrees to increase the above delivered payment rate as approved by the State in the event the location of delivery is changed per the G-026.2 clause. Purchaser will not be billed for any delivered logs that are scaled as containing metal. *When two or more log sorts from this project are delivered to the same destination, the species contained in them are not eligible for the species price reduction. Forest Products delivered that do not meet the sorting specifications in G-022.2 are considered mis-sorts. Purchaser receiving mis-sort Forest Products is required to pay the State at the bid price under this contract. However, when mis-sorted Forest Products amount to more than 5% of the total delivered sort volume, Purchaser may request approval for payment reduction for delivered volume exceeding the mis-sort threshold. Requests for payment reduction must be submitted to the State in writing prior to contract expiration. Eligibility for mis-sort payment reduction is subject to State approval and shall be determined by the State’s delivered product analysis. Forest Products determined by the State eligible for mis-sort price reduction are not eligible for any other price adjustments. Payment reduction for Forest Products deemed mis-sorted will be calculated as follows: Payment Reduction = (B x M) x R M = Mis-sorted volume exceeding threshold excluding utility R = Reduction factor* 0.2 for diameter mis-sort 0.3 for high quality mis-sort *Logs eligible for payment reduction based on multiple reduction factors will be calculated at the higher payment reduction factor. Third-party scaling organization information is required to determine Xxxxxxxx mbf for payment reduction purposes. Value will be derived from the applicable sort value as described in this contract. Scale information for determining mis-sort payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for mis-sorts shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code Forest Products delivered that do not meet preferred log length specifications or multiples or combinations of preferred lengths and Forest Products delivered not meeting manufacturing standards as described in clause G-024.2 are considered mis- manufactured. Purchaser receiving mis-manufactured Forest Products is required to pay the State at the bid price under this contract. However, when mis-manufactured Forest Products amount to more than 8% of the total delivered sort volume, Purchaser may request approval for payment reduction for delivered volume exceeding the mis-manufacture threshold. Requests for payment reduction must be submitted to the State in writing prior to contract expiration. Eligibility for mis-manufacture payment reduction is subject to State approval and shall be determined by the State’s delivered product analysis. Forest Products determined by the State eligible for mis-manufacture price reductions are not eligible for any other price adjustments. Payment reduction for Forest Products deemed mis-manufactured will be calculated as follows: Payment Reduction = (B x M) x (0.2) Where: B = Bid rate from P-028.2 clause M = Mis-manufactured volume exceeding threshold excluding utility Third-party scaling organization information is required to determine Xxxxxxxx mbf for payment reduction purposes. Value will be derived from the applicable sort value as described in this contract. Scale information for determining mis-manufacture payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for mis-manufacture shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
Method of Selecting Types and Interest Periods for New Advances The Borrower shall select the Type of Advance and, in the case of each Eurodollar Advance, the Interest Period applicable thereto from time to time. The Borrower shall give the Administrative Agent irrevocable notice (a "Borrowing Notice") not later than 11:00 a.m. (Chicago time) on the Borrowing Date of each Floating Rate Advance and not later than 11:00 a.m. (Chicago time) three Business Days before the Borrowing Date for each Eurodollar Advance, specifying:
(i) the Borrowing Date, which shall be a Business Day, of such Advance,
(ii) the aggregate amount of such Advance,
(iii) the Type of Advance selected, and
(iv) in the case of each Eurodollar Advance, the Interest Period applicable thereto. Not later than noon (Chicago time) on each Borrowing Date, each Lender shall make available its Loan or Loans in funds immediately available in Chicago to the Administrative Agent at its address specified pursuant to Article XIII. The Administrative Agent will make the funds so received from the Lenders available to the Borrower at the Administrative Agent's aforesaid address.
Substitution of Key Personnel Consultant has represented to City that certain key personnel will perform and coordinate the Services under this Agreement. Should one or more of such personnel become unavailable, Consultant may substitute other personnel of at least equal competence upon written approval of City. In the event that City and Consultant cannot agree as to the substitution of key personnel, City shall be entitled to terminate this Agreement for cause. As discussed below, any personnel who fail or refuse to perform the Services in a manner acceptable to the City, or who are determined by the City to be uncooperative, incompetent, a threat to the adequate or timely completion of the Project or a threat to the safety of persons or property, shall be promptly removed from the Project by the Consultant at the request of the City. The key personnel for performance of this Agreement are as follows: Xxxxx Xxxxx.
