Superheterodyne Transmission using an Electronic LO Source Sample Clauses

Superheterodyne Transmission using an Electronic LO Source. The superheterodyne transmission is ensured by applying a carrier offset of 10 GHz to the baseband signals generated in the AWG. As a first step an electronic stable frequency synthesiser is used to generate the 8.33 GHz LO signal. In addition to the transmission described in section 4, a back-to-back transmission is carried out and will be referred to as the reference measurement. This measurement is realized by directly connecting the transmitter and the receiver using a variable attenuator. The input power in the receiver remains the same as in the case of the 10-meter transmission, namely -43 dBm. The results of the 10-meter transmission in comparison to the reference measurement can be seen in Fig. 7. The quality of the transmission is evaluated in terms of EVM. Following modulation formats were successfully transmitted: QPSK, 16-QAM, 32-QAM and 64-QAM.
AutoNDA by SimpleDocs

Related to Superheterodyne Transmission using an Electronic LO Source

  • WASHINGTON’S ELECTRONIC BUSINESS SOLUTION (WEBS). Contractor represents and warrants that it is registered in Washington’s Electronic Business Solution (WEBS), Washington’s contract registration system and that, all of its information therein is current and accurate and that throughout the term of this Master Contract, Contractor shall maintain an accurate profile in WEBS.

  • Transmission encryption All data transmissions of County PHI or PI outside the secure internal network must be encrypted using a FIPS 140-2 certified algorithm which is 128bit or higher, such as AES. Encryption can be end to end at the network level, or the data files containing PHI can be encrypted. This requirement pertains to any type of PHI or PI in motion such as website access, file transfer, and E-Mail.

  • Electronic Access Access by the Customer to certain systems, applications or products of Bank shall be governed by this Agreement and the terms and conditions set forth in Annex A Electronic Access.

  • Data Transmission Control Except as necessary for the provision of the Cloud Services in accordance with the Agreement, Personal Data must not be read, copied, modified or removed without authorization during transfer. Where data carriers are physically transported, adequate measures are implemented at SAP to provide the agreed-upon service levels (for example, encryption and lead-lined containers). Measures: • Personal Data in transfer over SAP internal networks is protected according to SAP Security Policy. • When data is transferred between SAP and its customers, the protection measures for the transferred Personal Data are mutually agreed upon and made part of the relevant agreement. This applies to both physical and network based data transfer. In any case, the Customer assumes responsibility for any data transfer once it is outside of SAP-controlled systems (e.g. data being transmitted outside the firewall of the SAP Data Center).

  • Data Transmission The procedures for transmitting load obligation data to PJM for DS Supplier’s DS Load shall be as set forth by PJM.

  • Loop Transmission Types 3.1 Subject to the conditions set forth in Section 1 of this Attachment, Verizon shall allow CBB to access Loops unbundled from local switching and local transport, in accordance with this Section 3 and the rates and charges provided in the Pricing Attachment. Verizon shall allow CBB access to Loops in accordance with, but only to extent required by, Applicable Law. The available Loop types are as set forth below:

  • Electronic Notice to Borrower Unless another delivery method is required by Applicable Law, Lender may provide notice to Borrower by e-mail or other electronic communication (“Electronic Communication”) if: (i) agreed to by Xxxxxx and Xxxxxxxx in writing; (ii) Borrower has provided Lender with Borrower’s e-mail or other electronic address (“Electronic Address”); (iii) Lender provides Borrower with the option to receive notices by first class mail or by other non-Electronic Communication instead of by Electronic Communication; and (iv) Lender otherwise complies with Applicable Law. Any notice to Borrower sent by Electronic Communication in connection with this Security Instrument will be deemed to have been given to Borrower when sent unless Lender becomes aware that such notice is not delivered. If Xxxxxx becomes aware that any notice sent by Electronic Communication is not delivered, Xxxxxx will resend such communication to Borrower by first class mail or by other non-Electronic Communication. Xxxxxxxx may withdraw the agreement to receive Electronic Communications from Lender at any time by providing written notice to Xxxxxx of Xxxxxxxx’s withdrawal of such agreement.

  • Electronic Links The Participating Institutions and the Authorized Users may provide hyperlinks from the Participating Institutions’ and the Authorized Users’ web page(s) or website(s) to individual units of content within the Licensed Materials.

  • Firm Point-To-Point Transmission Service “Non-Firm Point-To-Point Transmission Service” shall mean Point-To-Point Transmission Service under the Tariff that is reserved and scheduled on an as-available basis and is subject to Curtailment or Interruption as set forth in Tariff, Part II, section 14.7. Non-Firm Point-To-Point Transmission Service is available on a stand-alone basis for periods ranging from one hour to one month. Non-Firm Sale:

  • Electronic Record Search The Reporting Financial Institution must review electronically searchable data maintained by them for any of the following indicia:

Time is Money Join Law Insider Premium to draft better contracts faster.