Supplementary Terms Other Contributions
SUPPLEMENTARY PREAMBLES For preambles see "Specifications of materials and methods to be used - PW 371" 1 Panes not exceeding 0,1 m2 m2 3 SMD2 Bill No. 11 GLAZING Item No Quantity Rate Amount SECTION 3 BILL NO. 12 PAINTWORK SUPPLEMENTARY PREAMBLES For preambles see "Specifications of materials and methods to be used - PW 371" ON FIBRE-CEMENT Prepare and brush to remove all loose contaminations, apply one coat primer and two coats PVA emulsion paint: 1 On fascias and barge boards m2 7 ON WOOD Undercoat and minimum 2 coat gloss enamel: 2 On doors (Internal) m2 7 3 On doors (External) m2 7 ON METAL Undercoat and minimum 2 coat gloss enamel: 4 On door frames m2 1 5 On gates (Measured over the full flat area of both sides) m2 8 6 On gutters and down pipes m 10 Spot prining defects in prime surface with zinc chromate primer and apply one universal undercoat and two coats EPWP, golden brown gloss enamel paint on steel: 7 On windows with burglar bars m2 3 Carried Forward to Summary of Section No. 3 Section No. 3 SMD2 Bill No. 12 PAINTWORK BVI CONSULTING ENGINEERS R SECTION SUMMARY - SMD2 1 EARTHWORKS 60 2 CONCRETE,FORMWORK AND REINFORCEMENT 62 3 MASONRY 65 4 WATERPROOFING 66 5 ROOF COVERINGS 68 6 CARPENTRY AND JOINERY 70 7 IRONMONGERY 72 8 METALWORK 73 9 PLASTERING 74 10 PLUMBING AND DRAINAGE 77 12 PAINTWORK 79 Carried to Final Summary Section No. 3 SMD2 BVI CONSULTING ENGINEERS Amount R No SECTION 4 BILL NO.1 EARTHWORKS (PROVISIONAL) SUPPLEMENTARY PREAMBLES For preambles see "Specifications of materials and methods to be used - PW 371" SITE CLEARANCE 1 Digging up and removing rubbish, debris, vegetation, xxxxxx, shrubs,xxxx and trees not exceeding 200mm girth, etc. m2 103 2 Stripping average 100mm thick layer of top soil and stockpiling on site m2 103 EXCAVATION,FILLING, ETC Excavation in earth not exceeding 2m deep: 3 Trenches m3 24 4 Pit m3 42 5 For aprons thickenning m3 5 Extra over trench and hole excavations in earth for excavation: 6 Soft rock m3 71 7 Hard rock m3 71 Extra over all excavations for carting away: 8 Surplus material from excavations and/or stock piles on site to a dumping site to be alocated by the Contractor m3 53 Carried Forward Section No. 4 MD6 Xxxx Xx. 1 EARTHWORKS BVI CONSULTING ENGINEERS R 9 Sides of trench and hole excavation not exceeding 1,5m deep. m2 112 10 Keeping excavations free of water other than subterranean water Item Earth filling obtained from the excavations and/or prescribed stock piles on site compacted to 93% ModAASHTO density: 11 Under floors, steps, pavings, etc. m3 12 12 Backfilling to trenches, holes, etc. m3 13 13 Compaction of ground surface under floors etc including scarifying for a depth of 150mm, breaking down oversize material, adding suitable material where necessary and compacting to 93% Mod AASHTO density m2 39 14 Compaction of ground surface to pits etc including scarifying for a depth of 150mm, breaking down oversize material, adding suitable material where necessary and compacting to 93% Mod AASHTO density m2 33 15 Compaction of ground surface to aprons etc including scarifying for a depth of 150mm, breaking down oversize material, adding suitable material where necessary and compacting to 93% Mod AASHTO density m2 54 16 Modified AASHTO Density tests No 5 Section No. 4 MD6 Bill No. 1 EARTHWORKS 17 Under floors etc including forming and poisoning shallow furrows against foundation walls etc, filling in furrows and ramming. m2 39 18 To bottom of concrate aprons m2 54 19 To bottoms and sides of trenches, etc. m2 92 MD6 Bill No. 1 EARTHWORKS
Supplementary labour (a) If the Employer wishes to engage supplementary labour to perform work performed by its Employees under this Agreement, the Employer must first consult in good faith with the affected Employees. (b) Following consultation and subject to this clause, the decision whether to engage supplementary labour is a decision of the Employer alone. Any dispute as to the application of this clause will be dealt with under the disputes settlement procedure under clause 10 of this Agreement. The Employer will ensure that all supplementary labour is engaged on lawful terms and conditions.
Supplementary Agreements II.13.1 Any amendment to the grant conditions must be the subject of a written supplementary agreement. No oral agreement may bind the parties to this effect. II.13.2 The supplementary agreement may not have the purpose or the effect of making changes to the agreement which might call into question the decision awarding the grant or result in unequal treatment of applicants. II.13.3 If the request for amendment is made by the beneficiary, he must send it to the Commission in good time before it is due to take effect and at all events one month before the closing date of the action, except in cases duly substantiated by the beneficiary and accepted by the Commission.
Description of Goods or Services and Additional Terms and Conditions The Contractor shall perform as set forth in Exhibit A. For purposes of this Contract, to perform and the performance in Exhibit A is referred to as “Perform” and the “Performance.”
Supplementary Card a card which is issued by the Bank to the client and/or other person nominated by the client and which is linked to the existing card account of the client;
Supplementary Agreement The parties stipulate and agree that the escrow provisions in this Section 6(b) (Escrow Establishment) of Attachment B (Facility Owned by Seller) and the Source Code Escrow Agreement and Proceeds Escrow Agreement are "supplementary agreements" as contemplated in Section 365(n)(1)(B) of the Code. In any voluntary or involuntary bankruptcy proceeding involving Seller, failure by Company to assert its rights to "retain its rights" to the intellectual property encompassed by the Source Code or the funds in the Proceeds Escrow, pursuant to Section 365(n)(1)(B) of the Code, under an executory contract rejected in a bankruptcy proceeding, shall not be construed as an election to terminate the contract by Company under Section 365(n)(1)(A) of the Code.
Fronting Fee and Documentary and Processing Charges Payable to L/C Issuer The Borrower shall pay directly to the L/C Issuer for its own account a fronting fee with respect to each Letter of Credit, at the rate per annum specified in the Fee Letter, computed on the daily amount available to be drawn under such Letter of Credit on a quarterly basis in arrears. Such fronting fee shall be due and payable on the tenth Business Day after the end of each March, June, September and December in respect of the most recently-ended quarterly period (or portion thereof, in the case of the first payment), commencing with the first such date to occur after the issuance of such Letter of Credit, on the Letter of Credit Expiration Date and thereafter on demand. For purposes of computing the daily amount available to be drawn under any Letter of Credit, the amount of such Letter of Credit shall be determined in accordance with Section 1.06. In addition, the Borrower shall pay directly to the L/C Issuer for its own account the customary issuance, presentation, amendment and other processing fees, and other standard costs and charges, of the L/C Issuer relating to letters of credit as from time to time in effect. Such customary fees and standard costs and charges are due and payable on demand and are nonrefundable.
Riders All Riders attached hereto and executed both by Landlord and Tenant shall be deemed to be a part hereof and hereby incorporated herein.
ADDENDA 5.1 Addenda are instruments issued by the Owners prior to the date for receipt of bids which modify or interpret the specification document by addition, deletion, clarification or correction. 5.2 Addenda notification will be made available to all registered vendors immediately via e-mail for inspection on-line. 5.3 No formal bid addendums will be issued later than forty-eight (48) hours prior to the date and time for receipt of formal bids, except an addendum withdrawing the invitation to bid, or an addendum which includes postponement of the bid.
