Dewatering (a) Where the whole of a site is so affected by surface water following a period of rain that all productive work is suspended by agreement of the Parties, then dewatering shall proceed as above with Employees so engaged being paid at penalty rates as is the case for safety rectification work. This work is typically performed by Employees engaged within CW1, CW2 or CW3 classifications. When other Employees are undertaking productive work in an area or areas not so affected then dewatering will only attract single time rates.
(b) Where a part of a site is affected by surface water following a period of rain, thus rendering some areas unsafe for productive work, consistent with the Employer’s obligations under the OH&S Act, appropriate Employees shall assist in the tidying up of their own work site or area if it is so affected. Where required, appropriate Employees will be provided with the appropriate PPE. Such work to be paid at single time rates. Productive work will continue in areas not so affected.
(c) To avoid any confusion any ‘dewatering’ time which prevents an Employee from being engaged in their normal productive work is not included in any calculation for the purposes of determining whether an Employee is entitled to go home due to wet weather (refer clauses 32.4 and 32.5)
Load Shedding The systematic reduction of system demand by temporarily decreasing Load in response to a transmission system or area Capacity shortage, system instability, or voltage control considerations under the ISO OATT. Local Furnishing Bonds. Tax-exempt bonds issued by a Transmission Owner under an agreement between the Transmission Owner and the New York State Energy Research and Development Authority (“NYSERDA”), or its successor, or by a Transmission Owner itself, and pursuant to Section 142(f) of the Internal Revenue Code, 26 U.S.C. § 142(f). Locality. A single LBMP Load Zone or set of adjacent LBMP Load Zones within one Transmission District within which a minimum level of Installed Capacity must be maintained. Local Reliability Rule. A Reliability Rule established by a Transmission Owner, and adopted by the NYSRC to meet specific reliability concerns in limited areas of the NYCA, including without limitation, special conditions and requirements applicable to nuclear plants and special requirements applicable to the New York City metropolitan area. Locational Based Marginal Pricing (“LBMP”). A pricing methodology under which the price of Energy at each location in the NYS Transmission System is equivalent to the cost to supply the next increment of Load at that location (i.e., the short-run marginal cost). The short-run marginal cost takes generation Bid Prices and the physical aspects of the NYS Transmission System into account. The short-run marginal cost also considers the impact of Out-of-Merit Generation (as measured by its Bid Price) resulting from the Congestion and Marginal Losses occurring on the NYS Transmission System which are associated with supplying an increment of Load. The term LBMP also means the price of Energy bought or sold in the LBMP Markets at a specific location.
Storage The ordering agency is responsible for storage if the contractor delivers within the time required and the agency cannot accept delivery.
TOOL STORAGE 1. A company shall provide on all construction jobs in towns and cities, and elsewhere where reasonably necessary and practicable (or if requested buy the employee), a suitable and secure waterproof lock-up solely for the purpose of storing employees’ tools, and on multi-storey and major projects the company shall provide, where possible, a suitable lock-up for employees’ tools within a reasonable distance of the work area of large groups of employees.
2. Where an employee is absent from work because of illness or accident and has advised the company in accordance with Clause 33 – Personal Leave of the award, the company shall ensure that the employee’s tools are securely stored during his/her absence.
Catering Cafeteria style of serving meals will be acceptable, providing dishes are carried back by the Culinary Staff. The food shall be of good quality and have the approval of the Camp Committee of the Building and Construction Trades Council of Ontario. There shall be sufficient housekeeping staff supplied by the Culinary Workers to keep the bunkhouses clean, and beds shall be made up each day by such staff. Kitchen facilities, equipment and food supplies shall be subject to inspection by the duly authorized Camp Committee at any and all times and further all grievances shall be dealt with by said Committee.
Transporting Students 1. Employees shall not transport students except in accordance with School Board rules. The Board shall adopt a school board policy outlining the teacher’s and the Board’s responsibilities and liabilities. Said policy shall be included in all school handbooks beginning with the 2004-05 school year.
2. Teachers will not be required to transport pupils to and from activities which take place away from the school grounds.
Blasting Blasting shall be permitted only for road construction purposes unless advance permission is obtained from Forest Service. Whenever the Industrial Fire Precaution Level is II or greater, a fire security person equipped with a long handled round point No. 0 or larger shovel and a 5 gallon backpack pump can filled with water, will stay at location of blast for 1 hour after blasting is done. Blasting may be suspended by Forest Service, in areas of high rate of spread and resistance to control. Fuses shall not be used for blasting. Explosive cords shall not be used without permission of Forest Service, which may specify conditions under which such explosives may be used and precautions to be taken.
Violence in the Workplace (a) The parties agree that violence shall be defined as any incident in which an employee is abused, threatened or assaulted while performing his or her work. The parties agree it includes the application of force, threats with or without weapons and severe verbal abuse. The parties agree that such incidents will not be condoned. Any employee who believes he/she has been subjected to such incident shall report this to a supervisor who will make every reasonable effort to rectify the situation. For purposes of sub-article (a) only, employees as referred to herein shall mean all employees of the Employer notwithstanding Article 2.12.
(b) The Employer agrees to develop formalized policies and procedures in consultation with the Joint Health and Safety Committee to deal with workplace violence. The policy will address the prevention of violence and the management of violent situations and support to employees who have faced workplace violence. These policies and procedures shall be communicated to all employees. The local parties will consider appropriate measures and procedures in consultation with the Joint Health and Safety Committee to address violence in the workplace, which may include, among other measures and procedures:
i) Alert employees about a person with a known history of aggressive and responsive behaviours and their known triggers by means of:
A) electronic and/or other appropriate flagging systems,
B) direct verbal communication / alerts (i.e. shift reports),
ii) Communicate and provide appropriate training and education,
iii) Reporting all incidents of workplace violence,
iv) Long-term care home wide violence risk assessments.
(c) The Employer will report all incidents of violence as defined herein to the Joint Health and Safety Committee for review.
(d) The Employer agrees to provide training and information on the prevention of violence to all employees who come into contact with potentially aggressive persons. This training will be done during a new employee’s orientation and updated as required.
(e) Subject to appropriate legislation, and with the employee’s consent, the Employer will inform the Union within three (3) days of any employee who has been subjected to violence while performing his/her work. Such information shall be submitted in writing to the Union as soon as practicable.
Towing Contractor shall meet all requirements set forth in Title 46 CFR, Part 15 for Towing Assistance. Unless otherwise specified in the work request, Purchasers require a dead-ship tow plan to be approved by the Coast Guard in accordance with the Puget Sound Harbor Safety Committee for vessels over 50-feet, unless the Coast Guard deems the plan unnecessary. Contractor is responsible to obtain a tow plan and provide Purchaser with an approved copy at least one (1) business day prior to the tow. The plan is located on the Puget Sound Harbor Safety Committee’s website under the Safety Plan link on the left side of the page (xxxx://xxxxx.xxx/about). This site will have the most update version of the plan.
Weapons We have a zero tolerance of the possession of weapons (sword, knives etc) or firearms (guns etc) in the Room, Building or Common Property. If You are found in possession of weapons, firearms or implements associated with their use in the Room, Building or Common Property We will immediately terminate this agreement and inform the relevant UNSW and legal authorities.
