Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning):
1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises.
2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated.
3. If capacity exists, provide "side-door" porting through the switch.
4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch).
2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases.
2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
Asset Dispositions, etc The Borrower will not, and will not permit any of its Subsidiaries to, sell, transfer, contribute or otherwise convey, or grant options, warrants or other rights with respect to, all or substantially all of the assets of (a) the Borrower or (b) the Subsidiaries of the Borrower, taken as a whole, except sales of assets between or among the Borrower and Subsidiaries of the Borrower.
PROPOSED MOBILITY PROGRAMME The proposed mobility programme includes the indicative start and end months of the agreed study programme that the student will carry out abroad. The Learning Agreement must include all the educational components to be carried out by the student at the receiving institution (in table A) and it must contain as well the group of educational components that will be replaced in his/her degree by the sending institution (in table B) upon successful completion of the study programme abroad. Additional rows can be added as needed to tables A and B. Additional columns can also be added, for example, to specify the study cycle-level of the educational component. The presentation of this document may also be adapted by the institutions according to their specific needs. However, in every case, the two tables A and B must be kept separated, i.e. they cannot be merged. The objective is to make clear that there needs to be no one to one correspondence between the courses followed abroad and the ones replaced at the sending institutions. The aim is rather that a group of learning outcomes achieved abroad replaces a group of learning outcomes at the sending institution, without having a one to one correspondence between particular modules or courses. A normal academic year of full-time study is normally made up of educational components totalling 60 ECTS* credits. It is recommended that for mobility periods shorter than a full academic year, the educational components selected should equate to a roughly proportionate number of credits. In case the student follows additional educational components beyond those required for his/her degree programme, these additional credits must also be listed in the study programme outlined in table A. When mobility windows are embedded in the curriculum, it will be enough to fill in table B with a single line as described below: Component code (if any) Component title (as indicated in the course catalogue) at the sending institution Semester [autumn / spring] [or term] Number of ECTS* credits Mobility window … Total: 30 Otherwise, the group of components will be included in Table B as follows: Component code (if any) Component title (as indicated in the course catalogue) at the sending institution Semester [autumn / spring] [or term] Number of ECTS* credits Course x … 10 Module y … 10 Laboratory work … 10 Total: 30 The sending institution must fully recognise the number of ECTS* credits contained in table A if there are no changes to the study programme abroad and the student successfully completes it. Any exception to this rule should be clearly stated in an annex of the Learning Agreement and agreed by all parties. Example of justification for non-recognition: the student has already accumulated the number of credits required for his/her degree and does not need some of the credits gained abroad. Since the recognition will be granted to a group of components and it does not need to be based on a one to one correspondence between single educational components, the sending institution must foresee which provisions will apply if the student does not successfully complete some of the educational components from his study programme abroad. A web link towards these provisions should be provided in the Learning Agreement. The student will commit to reach a certain level of language competence in the main language of instruction by the start of the study period. The level of the student will be assessed after his/her selection with the Erasmus+ online assessment tool when available (the results will be sent to the sending institution) or else by any other mean to be decided by the sending institution. A recommended level has been agreed between the sending and receiving institutions in the inter-institutional agreement. In case the student would not already have this level when he/she signs the Learning Agreement, he/she commits to reach it with the support to be provided by the sending or receiving institution (either with courses that can be funded by the organisational support grant or with the Erasmus+ online tutored courses). All parties must sign the document; however, it is not compulsory to circulate papers with original signatures, scanned copies of signatures or digital signatures may be accepted, depending on the national legislation. * In countries where the "ECTS" system it is not in place, in particular for institutions located in partner countries not participating in the Bologna process, "ECTS" needs to be replaced in all tables by the name of the equivalent system that is used and a weblink to an explanation to the system should be added. The section to be completed during the mobility is needed only if changes have to be introduced into the original Learning Agreement. In that case, the section to be completed before the mobility should be kept unchanged and changes should be described in this section. Changes to the mobility study programme should be exceptional, as the three parties have already agreed on a group of educational components that will be taken abroad, in the light of the course catalogue that the receiving institution has committed to publish well in advance of the mobility periods and to update regularly as ECHE holder. However, introducing changes might be unavoidable due to, for example, timetable conflicts. Other reasons for a change can be the request for an extension of the duration of the mobility programme abroad. Such a request can be made by the student at the latest one month before the foreseen end date. These changes to the mobility study programme should be agreed by all parties within four to seven weeks (after the start of each semester). Any party can request changes within the first two to five-week period after regular classes/educational components have started for a given semester. The exact deadline has to be decided by the institutions. The shorter the planned mobility period, the shorter should be the window for changes. All these changes have to be agreed by the three parties within a two-week period following the request. In case of changes due to an extension of the duration of the mobility period, changes should be made as timely as possible as well. Changes to the study programme abroad should be listed in table C and, once they are agreed by all parties, the sending institution commits to fully recognise the number of ECTS credits as presented in table C. Any exception to this rule should be documented in an annex of the Learning Agreement and agreed by all parties. Only if the changes described in table C affect the group of educational components in the student's degree (table B) that will be replaced at the sending institution upon successful completion of the study programme abroad, a revised version should be inserted and labelled as "Table D: Revised group of educational components in the student's degree that will be replaced at sending institution". Additional rows and columns can be added as needed to tables C and D. All parties must confirm that the proposed amendments to the Learning Agreement are approved. For this specific section, original or scanned signatures are not mandatory and an approval by email may be enough. The procedure has to be decided by the sending institution, depending on the national legislation.
Proposed Goods and Services Proposed Goods and Services pdf D/M/WBE Certification OPTIONAL No response Warranty No response
Superior Proposal (a) Each party agrees and acknowledges that from and after the date hereof until the close of business on April 28, 1997, if Assignor receives a Superior Proposal, Assignor may (i) furnish any information requested by the Offering Party with respect to such Superior Proposal (other than the contents of this Agreement or any Ancillary Agreement), (ii) participate in negotiations with such Offering Party regarding such Superior Proposal or (iii) enter into one or more letters of intent, term sheets or agreements with respect to any Superior Proposals; provided, however, that if Assignor proposes to take any of the actions specified in clause (iii) hereof, Assignor shall give Assignee prior written notice setting forth Assignor's proposed actions.
(b) Not later than the close of business on May 12, 1997, Assignor shall require each Offering Party with whom it is still engaged in discussions to submit a final binding offer, subject only to acceptance by Assignor. Not later than the close of business on May 16, 1997, Assignor shall (i) determine whether any such offer constitutes a Superior Proposal, (ii) if there is more than one Superior Proposal, select which Superior Proposal Assignor intends to accept and (iii) provide written notice to Assignee setting forth all the material terms and conditions of such selected Superior Proposal ("SP Notice").
(c) After receipt of the SP Notice, Assignee shall have five (5) days to notify Assignor of its agreement to modify this Agreement and any Ancillary Agreement as necessary to acquire the Transferred Interests at the same price and under the same terms and conditions as set forth in the SP Notice ("Assignee Acceptance Notice"); provided further, however, if under the terms set forth in the SP Notice Assignor is proposing to accept property (other than cash or promissory notes), Assignee shall have the right to substitute cash in an amount equal to the value of such other property.
(d) If Assignor does not give an SP Notice to Assignee on or before May 16, 1997, or if Assignee gives an Assignee Acceptance Notice to Assignor in accordance with subsection (c) hereof, neither Assignor nor Assignee shall thereafter have any right to terminate this Agreement pursuant to Section 15(c).
Presentation of Potential Target Businesses The Company shall cause each of the Initial Shareholders to agree that, in order to minimize potential conflicts of interest which may arise from multiple affiliations, the Initial Shareholders will present to the Company for its consideration, prior to presentation to any other person or company, any suitable opportunity to acquire an operating business, until the earlier of the consummation by the Company of a Business Combination or the liquidation of the Company, subject to any pre-existing fiduciary obligations the Initial Shareholders might have.
Data Disposition When the contracted work has been completed or when the Data is no longer needed, except as noted above in Section 5.b, Data shall be returned to DSHS or destroyed. Media on which Data may be stored and associated acceptable methods of destruction are as follows: Data stored on: Will be destroyed by:
Superior Proposals Notwithstanding anything to the contrary set forth in this Section 5.3, from the date hereof until the Company’s receipt of the Requisite Stockholder Approval, the Company and the Special Committee may, directly or indirectly through one or more of their Representatives (including the Advisor), contact the Person or group of Persons making such Acquisition Proposal to clarify the terms and conditions thereof so as to determine whether such Acquisition Proposal constitutes, or could reasonably be expected to result in, a Superior Proposal, participate or engage in discussions or negotiations with, furnish any non-public information relating to the Company Group to, or afford access to the business, properties, assets, books, records or other non-public information, or to any personnel, of the Company Group pursuant to an Acceptable Confidentiality Agreement to any Person or its Representatives that has made or delivered to the Company an Acquisition Proposal after the date hereof, in each case with respect to an Acquisition Proposal that did not result from any material breach of Section 5.3(a); provided, however, that prior thereto, the Special Committee has determined in good faith (after consultation with its financial advisor and outside legal counsel) that (i) such Acquisition Proposal either constitutes a Superior Proposal or is reasonably expected to lead to a Superior Proposal, and (ii) the failure to take the actions contemplated by this Section 5.3(b) would be inconsistent with its fiduciary duties pursuant to applicable law; and provided further, however, that the Company will promptly (and in any event within 24 hours) make available to Parent any non-public information concerning the Company Group that is provided to any such Person or its Representatives that was not previously made available to Parent; and provided further, however, that if any such Person or its Representatives is a competitor of the Company Group, the Company Group shall not provide any information that in the good faith determination of the Company constitutes commercially sensitive non-public information to such Person in connection with any actions permitted by this Section 5.3(b) other than in accordance with “clean room” or other similar procedures designed to limit any potential adverse effect on the Company from sharing such information.
Pro Forma Treatment Each Disposition of all or substantially all of a line of business, and each Acquisition, by the Borrower and its Subsidiaries that is consummated during any Measurement Period shall, for purposes of determining compliance with the financial covenants set forth in Section 7.11 and for purposes of determining the Applicable Rate, be given Pro Forma Effect as of the first day of such Measurement Period.
Loop Testing/Trouble Reporting 2.1.6.1 Telepak Networks will be responsible for testing and isolating troubles on the Loops. Telepak Networks must test and isolate trouble to the BellSouth portion of a designed/non-designed unbundled Loop (e.g., UVL-SL2, UCL-D, UVL-SL1, UCL-ND, etc.) before reporting repair to the UNE Customer Wholesale Interconnection Network Services (CWINS) Center. Upon request from BellSouth at the time of the trouble report, Telepak Networks will be required to provide the results of the Telepak Networks test which indicate a problem on the BellSouth provided Loop.
2.1.6.2 Once Telepak Networks has isolated a trouble to the BellSouth provided Loop, and had issued a trouble report to BellSouth on the Loop, BellSouth will take the actions necessary to repair the Loop if a trouble actually exists. BellSouth will repair these Loops in the same time frames that BellSouth repairs similarly situated Loops to its End Users.
2.1.6.3 If Telepak Networks reports a trouble on a non-designed or designed Loop and no trouble actually exists, BellSouth will charge Telepak Networks for any dispatching and testing (both inside and outside the CO) required by BellSouth in order to confirm the Loop’s working status.
2.1.6.4 In the event BellSouth must dispatch to the end-user’s location more than once due to incorrect or incomplete information provided by Telepak Networks (e.g., incomplete address, incorrect contact name/number, etc.), BellSouth will xxxx Xxxxxxx Networks for each additional dispatch required to repair the circuit due to the incorrect/incomplete information provided. BellSouth will assess the applicable Trouble Determination rates from BellSouth’s FCC or state tariffs.
