Water Supply The system may or may not meet state and local requirements. It is the right and responsibility of Buyer to determine the compliance of the system with state and local requirements. [For additional information on this subject, request the “Water Supply and Waste Disposal Notification” form.]
Power Supply The source of power for the VAS shall either be the vehicle battery or a rechargeable battery. Where provided, an additional rechargeable or non-rechargeable battery may be used. These batteries shall by no means supply energy to other parts of the vehicle electrical system.
Bidder Supplied Samples The Commissioner reserves the right to request from the Bidder/Contractor a representative sample(s) of the Product offered at any time prior to or after award of a contract. Unless otherwise instructed, samples shall be furnished within the time specified in the request. Untimely submission of a sample may constitute grounds for rejection of Bid or cancellation of the Contract. Samples must be submitted free of charge and be accompanied by the Bidder’s name and address, any descriptive literature relating to the Product and a statement indicating how and where the sample is to be returned. Where applicable, samples must be properly labeled with the appropriate Bid or Contract reference. A sample may be held by the Commissioner during the entire term of the Contract and for a reasonable period thereafter for comparison with deliveries. At the conclusion of the holding period the sample, where feasible, will be returned as instructed by the Bidder, at the Bidder’s expense and risk. Where the Bidder has failed to fully instruct the Commissioner as to the return of the sample (i.e., mode and place of return, etc.) or refuses to bear the cost of its return, the sample shall become the sole property of the receiving entity at the conclusion of the holding period.
Direct Contracting Goods and works which the Association agrees meet the requirements for Direct Contracting may be procured in accordance with the provisions of said procurement method.
Product Supply 5.1 In the event that Eisai notifies Radius of its desire to purchase bulk substance of Compound from Radius, Radius shall supply Eisai with all amount of such bulk substance of Compound, which meets specifications for the Product determined by Radius in the course of its Development activities pursuant to this Agreement, required by Eisai for commercial sales of Product in Japan With respect to Eisai clinical development activities for Product in Japan, upon Eisai’s request, Radius shall supply Eisai the bulk substance of Compound for * Confidential Treatment Requested by the Registrant. Redacted Portion Filed Separately with the Commission. the conduct of the Eisai Development activities in the amounts and at the times determined by the SC, having reference to the quantity of the bulk substance of Compound required for clinical trials in Japan. Radius shall charge [*] for applicable bulk substance of Compound. Radius shall ship such bulk substance of Compound, FOB point of manufacturing.
5.2 In the event that Eisai notifies Radius of its desire to purchase Semi-Product from Radius which meets specifications determined by Radius in the course of its Development activities pursuant to this Agreement, Radius shall supply Eisai with all amount of Semi-Product required by Eisai for commercial sales of Product in Japan. With respect to Eisai clinical development activities for Product in Japan, upon Eisai’s request, Radius shall supply Eisai Semi-Product for the conduct of the Eisai Development activities in the amounts and at the times determined by the SC, having reference to the quantity of Semi-Product required for clinical trials in Japan. Radius shall charge [*] for Semi-Product. Radius shall ship such Semi-Product, FOB point of manufacturing.
5.3 The Parties agree that they shall, in good faith, discuss, negotiate and execute necessary agreements containing mutually acceptable terms, including but not limited to, a supply agreement for either bulk substance of Compound or Semi-Product as well as a quality control agreement of either bulk substance of Compound or Semi-Product, in the event that Eisai notifies Radius as set forth in Article 5.1 or 5.2.
5.4 As manufacturer of the Product, Radius shall be responsible for: (a) the control of the quality of the Product promoted and sold under the Radius trademarks; as provided in Article 2.3; and (b) ensuring that all bulk substance of Compound or Semi-Product supplied to Eisai pursuant to this Article 5 shall be manufactured in accordance with the applicable good manufacturing practices (GMP) and shall meet the then applicable specifications for the bulk substance of Compound or Semi-Product; and Radius warrants that all bulk substance of Compound or Semi-Product supplied to Eisai pursuant to this Article 5 shall be manufactured in accordance with the applicable GMP and * Confidential Treatment Requested by the Registrant. Redacted Portion Filed Separately with the Commission. shall meet the then applicable specifications for the bulk substance of Compound or Semi-Product and will be free from defects in material and workmanship. Radius shall resolve any product liability issues in the Territory relating to the Product and shall resolve any product liability issues in Japan relating to the Product or the bulk substance of Compound or Semi-Product, as the case may be, supplied to Eisai pursuant to this Article 5 in the event and to the extent related to a breach of the warranty set forth in Article 5.4(b) at its own expense and subject to Article 5.5.
5.5 Radius’ obligations with respect to product liability in the Territory and Japan shall include the following responsibilities, each to be taken at Radius’ expense:
(a) Radius shall report, at its expense, to appropriate authorities, in accordance with local requirements, all adverse events related to use of the Product in the Territory or Japan. Eisai shall provide to Radius, upon Radius’ request, reasonable assistance in connection with the reporting of all of adverse events, responding to safety queries and assessing safety issues, in each case, to the extent related to the Product in Japan. Adverse events shall be recorded in a single, centralized database, which shall be held and owned by Radius. Radius will provide, upon request by Eisai, any safety information in Radius’ control and reasonably required by Eisai in connection with the development and commercialization of the Product in Japan and all reasonable assistance in responding to safety queries related to the Product and in assessing safety issues related to the Product in Japan. Details of safety reporting activities relating to the Product will be addressed in a pharmacovigilance contract, which the Parties shall enter into after the Effective Date.
(b) In the event that (i) Radius determines that an event, incident, or circumstance may result in the need for a recall or other removal of the Product or any lot or lots thereof from the market; (ii) any regulatory authority in the Territory threatens to remove a Product from the market; or (iii) any regulatory authority in the Territory requires distribution of a “Dear Doctor” letter or its equivalent regarding the use of Product, Radius shall promptly advise Eisai in writing, and shall provide Eisai with copies of all relevant correspondence, notices and the like. Notwithstanding anything the contrary herein, Radius shall have final authority to make all decisions relating to any recall, market withdrawal or other corrective action with respect to the Product in the Territory. After establishing SC pursuant to Article 3.5, all decisions relating to any recall, market withdrawal or other corrective action with respect to the Product shall be decided by the SC as set forth in Article 3.6; provided that in the event that the Parties take different positions with respect to recall, market withdrawal or other corrective action with respect to the Product, then Radius shall have the right to cease supplying bulk substance of Compound or Semi-Product to Eisai for Japan if, after good faith discussions with Eisai, Radius reasonably believes that that continued supply to Eisai exposes Radius to liability as a result of its decision with respect to the Territory. If Radius elects to cease supply, it will terminate supply in an orderly manner, as soon as practical and in accordance with a schedule agreed to by Eisai and Radius. In the event of a recall, market withdrawal or other corrective action with respect to the Product in Japan, and at Radius’ request, Eisai shall provide reasonable assistance to Radius, at Radius’ cost and expense, in conducting any such recall, market withdrawal or other corrective action with respect to the Product in Japan.
5.6 THE WARRANTY IN SECTION 5.4(b) IS IN LIEU OF ANY OTHER WARRANTY WITH RESPECT TO THE PRODUCT, BULK SUBSTANCE OF COMPOUND OR SEMI-PRODUCT SUPPLIED BY RADIUS HEREUNDER, WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL (INCLUDING, WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE).
All-Requirements Power Supply The service under which the Competitive Supplier provides all of the electrical energy, capacity, reserves, and ancillary services, transmission services, transmission and distribution losses, congestion management, and other such services or products necessary to provide firm power supply to Participating Consumers at the Point of Delivery.
Third Party Suppliers If Licensee wishes to obtain the Compound, Product and/or Licensed Product from a Third Party source, Licensee shall notify Pfizer through MPP of the intended source prior to making any commitments to purchase the Compound, Product and/or Licensed Product. Pfizer will determine at its sole discretion whether and on what terms to grant a license to the intended source to produce the Compound, Product and/or Licensed Product or inform Licensee whether such license already exists.
Project Contracts Prior to the delivery of this Lease, the Company may have entered into a contract or contracts with respect to the acquisition and/or construction of the Improvements. Those contracts, and any such contracts entered into by the Company after delivery of this Lease are hereinafter referred to as the “Project Contracts.” Prior to the delivery hereof, certain work has been or may have been performed on the Improvements pursuant to said Project Contracts or otherwise. Subject to the Lender’s rights in the Project Contracts, the Company hereby conveys, transfers and assigns to the Issuer all of the Company’s rights in, but not its obligations under the Project Contracts and the Issuer hereby designates the Company as Issuer’s agent for the purpose of executing and performing the Project Contracts. After the execution hereof, the Company shall cause the Project Contracts to be fully performed by the contractor(s), subcontractor(s) and supplier(s) thereunder in accordance with the terms thereof, and the Company covenants to cause the Improvements to be acquired, constructed and/or completed in accordance with the Project Contracts. Any and all amounts received by the Issuer, the Trustee or the Company from any of the contractors or other suppliers by way of breach of contract, refunds or adjustments shall become a part of and be deposited in the Project Fund.
Auction Schedule The Auction Agent shall conduct Auctions in accordance with the schedule set forth below. Such schedule may be changed by the Auction Agent with the consent of the Company, which consent shall not be withheld unreasonably. The Auction Agent shall give notice of any such change to each Broker-Dealer. Such notice shall be received prior to the first Auction Date on which any such change shall be effective. Time Event ---- ----- By 9:30 A.M. Auction Agent advises the Company and the Broker-Dealers of the Reference Rate and the Maximum Applicable Rate as set forth in Section 2.2(e)(i) hereof.
OGS Centralized Contract Terms and Conditions have been renumbered as depicted in the following chart: Current Amended Section Title 4.25 4.26 Severability 4.26 4.27 Entire Agreement
