OBLIGATIONS AND ACTIVITIES OF CONTRACTOR AS BUSINESS ASSOCIATE 1. Contractor agrees not to use or further disclose PHI County discloses to Contractor other than as permitted or required by this Business Associate Contract or as required by law.
Obligations and Activities of Business Associate Business Associate agrees to:
Obligations and Activities of Business Associates (1) Business Associate agrees not to use or disclose PHI other than as permitted or required by this Section of the Contract or as Required by Law.
Third-Party Certifications and Audits Upon Customer’s written request at reasonable intervals, and subject to the confidentiality obligations set forth in the Agreement and this DPA, Data Processor shall make available to Customer (or Customer’s independent, third-party auditor that is not a competitor of Data Processor) a copy of Data Processor’s then most recent third-party audits or certifications, as applicable (provided, however, that such audits, certifications and the results therefrom, including the documents reflecting the outcome of the audit and/or the certifications, shall only be used by Customer to assess compliance with this DPA and/or with applicable Data Protection Laws and Regulations, and shall not be used for any other purpose or disclosed to any third party without Data Processor’s prior written approval and, upon Data Processor's first request, Customer shall return all records or documentation in Customer's possession or control provided by Data Processor in the context of the audit and/or the certification). With respect to audits and inspections, the parties shall discuss in good faith and agree on the scope, timing and details of the audits and inspections. To the extent that Data Processor’s obligations in this section involve more than 8 hours/man of work, Customer shall bear the costs and expenses of complying with this clause.
Mergers and Acquisitions The Borrower will not, and will not permit any of its Subsidiaries to, become a party to any merger or consolidation, or agree to or effect any asset acquisition or stock acquisition (other than the acquisition of assets in the ordinary course of business consistent with past practices) except the merger or consolidation of one or more of the Subsidiaries of the Borrower with and into the Borrower, or the merger or consolidation of two or more Subsidiaries of the Borrower.
Definitions and Acronyms For purposes of this Agreement, certain terms have been defined in the body of the Agreement to encompass meanings that may differ from, or be in addition to, the normal connotation of the defined word. Unless the context clearly indicates otherwise, any term defined or used in the singular shall include the plural. The words "shall" and "will" are used interchangeably throughout this Agreement and the use of either connotes a mandatory requirement. The use of one or the other shall not mean a different degree of right or obligation for either Party. A defined word intended to convey its special meaning is capitalized when used. Other terms that are capitalized, and not defined in this Agreement, shall have the meaning in the Act. For convenience of reference, Attachment 11 provides a list of acronyms used throughout this Agreement.
Continuing Nature of Representations and Warranties The representations and warranties set forth in this Section are made as of the Effective Date and deemed made continually throughout the Term. If at any time during the Term, any Party obtains actual knowledge of any event or information which causes any of the representations and warranties in this Article 7 to be materially untrue or misleading, such Party shall provide the other Party with written notice of the event or information, the representations and warranties affected, and the action, if any, which such Party intends to take to make the representations and warranties true and correct. The notice required pursuant to this Section shall be given as soon as practicable after the occurrence of each such event.
Exclusions and Limitations of Liability TO THE MAXIMUM EXTENT PERMITTED UNDER APPLICABLE LAW, (a) NONE OF THE 8x8 PARTIES SHALL BE LIABLE UNDER THE AGREEMENT FOR ANY INCIDENTAL, CONSEQUENTIAL, SPECIAL, PUNITIVE, EXEMPLARY, OR COVER DAMAGES; LOSS OF PROFITS, REVENUES, OR GOODWILL; OR LOSS OR INTERRUPTION OF BUSINESS, WHETHER FROM BREACH OR REPUDIATION OF CONTRACT, BREACH OF WARRANTY, NEGLIGENCE, TORT, STRICT LIABILITY, OR OTHERWISE AND (b) THE MAXIMUM LIABILITY OF THE 8x8 PARTIES UNDER THE AGREEMENT, WHETHER ARISING FROM A THEORY OR CLAIM OF BREACH OR REPUDIATION OF CONTRACT, BREACH OF WARRANTY, NEGLIGENCE, TORT, STATUTORY DUTY, OR OTHERWISE, SHALL IN NO CASE EXCEED THE TOTAL AMOUNT OF SERVICE FEES PAYABLE UNDER THE AGREEMENT FOR THE TWELVE- (12-) MONTH PERIOD PRECEDING THE FIRST INCIDENT OUT OF WHICH THE LIABILITY AROSE. THE FOREGOING EXCLUSION AND LIMITATION SHALL APPLY REGARDLESS OF WHETHER EITHER PARTY WAS ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR THE FAILURE OF THE ESSENTIAL PURPOSE OF ANY LIMITED REMEDY, AND ON A CUMULATIVE (RATHER THAN PER-INCIDENT) BASIS. CUSTOMER ACKNOWLEDGES AND AGREES THAT THE PRICING AND OTHER TERMS UNDER THE AGREEMENT ARE BASED ON THE FOREGOING EXCLUSION AND LIMITATION.
Information Acquisition Connecting Transmission Owner and Developer shall each submit specific information regarding the electrical characteristics of their respective facilities to the other, and to NYISO, as described below and in accordance with Applicable Reliability Standards.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
