Transmission Characteristics Sample Clauses

Transmission Characteristics. 3.1 FM No. [XX] will be built [as a ring configuration].
AutoNDA by SimpleDocs
Transmission Characteristics. 3.1 At ***CLEC Acronym TXT***’s request, FM No. [XX] will be built [as a ring configuration with each party providing its own separate strands of fiber optic cable to the two FNIDs listed Section 2/as a flat configuration with each party providing its own strands of fiber optic cable to the one FNID listed in Section 2].
Transmission Characteristics. Unless otherwise mutually agreed to, or designated by GNAPs, the transmission interface shall be SONET (Synchronous Optical Network). The agreed upon interconnecting electronics requirements are as follows: Terminating equipment shall comply with SONET transmission requirements as specified in Telcordia Technologies (formerly Bellcore) document GR-253 CORE. The optical transmitters and receivers must provide adequate power for the end- to-end length of the fiber cable to be traversed. The End Point Fiber Meet system shall be built as a ring configuration. The optical transmission rate will be Unidirectional OC-48. The path switch protection shall be set as Non-Revertive. Verizon will provide four fibers of single-mode fiber cable via ultra SC connectors (two for the primary signal and two for the secondary signal) between the designated Verizon Central Office and the GNAPs-designated location. The design of the End Point Fiber Meet shall meet optical parameters of GR-253- CORE, Tables 4-3 through 4-11. Verizon and GNAPs shall provide Primary Reference Source traceable timing.
Transmission Characteristics 

Related to Transmission Characteristics

  • Transmission encryption All data transmissions of County PHI or PI outside the secure internal network must be encrypted using a FIPS 140-2 certified algorithm which is 128bit or higher, such as AES. Encryption can be end to end at the network level, or the data files containing PHI can be encrypted. This requirement pertains to any type of PHI or PI in motion such as website access, file transfer, and E-Mail.

  • Loop Transmission Types 3.1 Subject to the conditions set forth in Section 1 of this Attachment, Verizon shall allow CBB to access Loops unbundled from local switching and local transport, in accordance with this Section 3 and the rates and charges provided in the Pricing Attachment. Verizon shall allow CBB access to Loops in accordance with, but only to extent required by, Applicable Law. The available Loop types are as set forth below:

  • Data Transmission The procedures for transmitting load obligation data to PJM for DS Supplier’s DS Load shall be as set forth by PJM.

  • Transmission of business Where a business is transmitted from one employer to another, as set out in clause 4.4 - Redundancy, the period of continuous service that the employee had with the transmittor or any prior transmittor is deemed to be service with the transmittee and taken into account when calculating notice of termination. However, an employee shall not be entitled to notice of termination or payment in lieu of notice for any period of continuous service in respect of which notice has already been given or paid for.

  • Interconnection Points 8.5.1 The IP of a Party (“Receiving Party”) for Measured Internet Traffic delivered to the Receiving Party by the other Party shall be the same as the IP of the Receiving Party for Reciprocal Compensation Traffic under Section 7.1 above.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!