Underground Tanks If underground or other storage tanks storing Hazardous Materials located on the Premises or the Project are used by Tenant or are hereafter placed on the Premises or the Project by Tenant, Tenant shall install, use, monitor, operate, maintain, upgrade and manage such storage tanks, maintain appropriate records, obtain and maintain appropriate insurance, implement reporting procedures, properly close any underground storage tanks, and take or cause to be taken all other actions necessary or required under applicable state and federal Legal Requirements, as such now exists or may hereafter be adopted or amended in connection with the installation, use, maintenance, management, operation, upgrading and closure of such storage tanks.
Underground Storage Tanks In accordance with the requirements of Section 3(g) of the D.C. Underground Storage Tank Management Act of 1990, as amended by the District of Columbia Underground Storage Tank Management Act of 1990 Amendment Act of 1992 (D.C. Code § 8-113.01, et seq.) (collectively, the “UST Act”) and the applicable D.C. Underground Storage Tank Regulations, 20 DCMR Chapter 56 (the “UST Regulations”), District hereby informs the Developer that it has no knowledge of the existence or removal during its ownership of the Property of any “underground storage tanks” (as defined in the UST Act). Information pertaining to underground storage tanks and underground storage tank removals of which the D.C. Government has received notification is on file with the District Department of the Environment, Underground Storage Tank Branch, 00 X Xxxxxx, X.X., Xxxxx Xxxxx, Xxxxxxxxxx, X.X., 00000, telephone (000) 000-0000. District’s knowledge for purposes of this Section shall mean and be limited to the actual knowledge of Xxxxxx Xxxxx, Property Acquisition and Disposition Division of the Department of Housing and Community Development, telephone no. (000) 000-0000. The foregoing is set forth pursuant to requirements contained in the UST Act and UST Regulations and does not constitute a representation or warranty by District.
Underground Facilities All underground pipelines, conduits, ducts, cables, wires, manholes, vaults, tanks, tunnels, or other such facilities or attachments, and any encasements containing such facilities, including without limitation those that convey electricity, gases, steam, liquid petroleum products, telephone or other communications, cable television, water, wastewater, storm water, other liquids or chemicals, or traffic or other control systems.
Underground Utilities Any required ground digging or subsurface work shall be done in accordance with Chapter 556, Florida Statutes. It shall be the responsibility of CONTRACTOR to have all underground utilities located before any work begins (Sunshine State One Call 0-000-000-0000). The repairs of any damaged underground utilities as a result of the work being performed by CONTRACTOR shall be the responsibility of CONTRACTOR. The proper utility company shall be contacted immediately to expedite the repairs, if damage has occurred. CONTRACTOR will notify the COUNTY and provide a written explanation of the incident within two (2) days of the damage to any underground utilities.
UNDERGROUND LOCATIONS Prior to the Company commencing any work the Customer must advise the Company of the precise location of all underground services on the site and clearly xxxx the location. The underground mains and services the Customer must identify include, but are not limited to, telephone cables, fibre optic cables, electrical services, gas services, sewer services, pumping services, sewer connections, sewer sludge mains, water mains, irrigations pipes, oil pumping mains and any other services that may be on site. Whilst the Company will take all care to avoid damage to any underground services the Customer agrees to indemnify the Company in respect of all any liability claims, loss, damage, cost and fines as a result of damage to services not precisely located and notified pursuant to this clause.
System Upgrade Facilities and System Deliverability Upgrades Connecting Transmission Owner shall design, procure, construct, install, and own the System Upgrade Facilities and System Deliverability Upgrades described in Appendix A hereto. The responsibility of the Developer for costs related to System Upgrade Facilities and System Deliverability Upgrades shall be determined in accordance with the provisions of Attachment S to the NYISO OATT.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.
Standard Hazard and Flood Insurance Policies For each Mortgage Loan (other than a Cooperative Loan), the Master Servicer shall maintain, or cause to be maintained by each Servicer, standard fire and casualty insurance and, where applicable, flood insurance, all in accordance with the provisions of this Agreement and the related Servicing Agreement, as applicable. It is understood and agreed that such insurance shall be with insurers meeting the eligibility requirements set forth in the applicable Servicing Agreement and that no earthquake or other additional insurance is to be required of any Mortgagor or to be maintained on property acquired in respect of a defaulted loan, other than pursuant to such applicable laws and regulations as shall at any time be in force and as shall require such additional insurance. Pursuant to Section 4.01, any amounts collected by the Master Servicer, or by any Servicer, under any insurance policies maintained pursuant to this Section 9.16 or any Servicing Agreement (other than amounts to be applied to the restoration or repair of the property subject to the related Mortgage or released to the Mortgagor in accordance with the applicable Servicing Agreement) shall be deposited into the Collection Account, subject to withdrawal pursuant to Section 4.02. Any cost incurred by the Master Servicer or any Servicer in maintaining any such insurance if the Mortgagor defaults in its obligation to do so shall be added to the amount owing under the Mortgage Loan where the terms of the Mortgage Loan so permit; provided, however, that the addition of any such cost shall not be taken into account for purposes of calculating the distributions to be made to Certificateholders and shall be recoverable by the Master Servicer or such Servicer pursuant to Section 4.02.
Maintenance of PMI Policy and/or LPMI Policy; Claims The Servicer shall comply with all provisions of applicable state and federal law relating to the cancellation of, or collection of premiums with respect to, PMI Policies, including, but not limited to, the provisions of the Homeowners Protection Act of 1998, and all regulations promulgated thereunder, as amended from time to time. With respect to each Mortgage Loan (other than LPMI Loans) with a loan to value ratio at origination in excess of 80%, the Servicer shall maintain or cause the Mortgagor to maintain (to the extent that the Mortgage Loan requires the Mortgagor to maintain such insurance) in full force and effect a PMI Policy, and shall pay or shall cause the Mortgagor to pay the premium thereon on a timely basis, until the LTV of such Mortgage Loan is reduced to 80%. In the event that such PMI Policy shall be terminated, the Servicer shall obtain from another Qualified Insurer a comparable replacement policy, with a total coverage equal to the remaining coverage of such terminated PMI Policy, at substantially the same fee level. The Servicer shall not take any action which would result in noncoverage under any applicable PMI Policy of any loss which, but for the actions of the Servicer would have been covered thereunder. In connection with any assumption or substitution agreements entered into or to be entered into with respect to a Mortgage Loan, the Servicer shall promptly notify the insurer under the related PMI Policy, if any, of such assumption or substitution of liability in accordance with the terms of such PMI Policy and shall take all actions which may be required by such insurer as a condition to the continuation of coverage under such PMI Policy. If such PMI Policy is terminated as a result of such assumption or substitution of liability, the Servicer shall obtain a replacement PMI Policy as provided above. The Servicer shall take all such actions as are necessary to service, maintain and administer the LPMI Loans in accordance with the LPMI Policy and to perform and enforce the rights of the insured under such LPMI Policy. Except as expressly set forth herein, the Servicer shall have full authority on behalf of the Trust Fund to do anything it reasonably deems appropriate or desirable in connection with the servicing, maintenance and administration of the LPMI Policy. The Servicer shall not modify or assume a Mortgage Loan covered by the LPMI Policy or take any other action with respect to such Mortgage Loan which would result in non-coverage under the LPMI Policy of any loss which, but for the actions of the Servicer, would have been covered thereunder. If the LPMI Insurer fails to pay a claim under the LPMI Policy as a result of breach by the Servicer of its obligations hereunder or under the LPMI Policy, the Servicer shall be required to deposit in the Custodial Account on or prior to the next succeeding Remittance Date an amount equal to such unpaid claim from its own funds without any right to reimbursement from the Trust Fund. The Servicer shall cooperate with the LPMI Insurer and the Master Servicer and shall use its best efforts to furnish all reasonable aid, evidence and information in the possession of the Servicer to which the Servicer has access with respect to any LPMI Loan; provided, however, notwithstanding anything to the contrary contained in any LPMI Policy, the Servicer shall not be required to submit any reports to the LPMI Insurer until a reporting date that is at least 15 days after the Servicer has received sufficient loan level information from the Seller, the Master Servicer or the LPMI Insurer to appropriately code its servicing system in accordance with the LPMI Insurer’s requirements. In connection with its activities as servicer, the Servicer agrees to prepare and present, on behalf of itself and the Trustee, claims to the insurer under any PMI Policy or LPMI Policy in a timely fashion in accordance with the terms of such PMI Policy or LPMI Policy and, in this regard, to take such action as shall be necessary to permit recovery under any PMI Policy or LPMI Policy respecting a defaulted Mortgage Loan. Any amounts collected by the Servicer under any PMI Policy or LPMI Policy shall be deposited in the Custodial Account, subject to withdrawal pursuant to Section 3.04.
Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Subloop that may diminish the capability of the Loop or Subloop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the BellSouth’s TR 73600 Unbundled Local Loop Technical Specification. 2.5.2 BellSouth will remove load coils only on copper Loops and Subloops that are less than eighteen thousand (18,000) feet in length. 2.5.3 For any copper loop being ordered by NewPhone which has over six thousand (6,000) feet of combined bridged tap will be modified, upon request from NewPhone, so that the loop will have a maximum of six thousand (6,000) feet of bridged tap. This modification will be performed at no additional charge to NewPhone. Loop conditioning orders that require the removal of bridged tap that serves no network design purpose on a copper Loop that will result in a combined total of bridged tap between two thousand five hundred (2,500) and six thousand (6,000) feet will be performed at the rates set forth in Exhibit A. 2.5.4 NewPhone may request removal of any unnecessary and non-excessive bridged tap (bridged tap between zero (0) and two thousand five hundred (2,500) feet which serves no network design purpose), at rates pursuant to BellSouth’s SC Process as mutually agreed to by the Parties. 2.5.5 Rates for ULM are as set forth in Exhibit A. 2.5.6 BellSouth will not modify a Loop in such a way that it no longer meets the technical parameters of the original Loop type (e.g., voice grade, ADSL, etc.) being ordered. 2.5.7 If NewPhone requests ULM on a reserved facility for a new Loop order, BellSouth may perform a pair change and provision a different Loop facility in lieu of the reserved facility with ULM if feasible. The Loop provisioned will meet or exceed specifications of the requested Loop facility as modified. NewPhone will not be charged for ULM if a different Loop is provisioned. For Loops that require a DLR or its equivalent, BellSouth will provide LMU detail of the Loop provisioned. 2.5.8 NewPhone shall request Loop make up information pursuant to this Attachment prior to submitting a service inquiry and/or a LSR for the Loop type that NewPhone desires BellSouth to condition. 2.5.9 When requesting ULM for a Loop that BellSouth has previously provisioned for NewPhone, NewPhone will submit a SI to BellSouth. If a spare Loop facility that meets the Loop modification specifications requested by NewPhone is available at the location for which the ULM was requested, NewPhone will have the option to change the Loop facility to the qualifying spare facility rather than to provide ULM. In the event that BellSouth changes the Loop facility in lieu of providing ULM, NewPhone will not be charged for ULM but will only be charged the service order charges for submitting an order.
