Security and Safety A. The Contractor warrants it is and shall remain in compliance with all applicable local, state and federal laws, regulations, codes and ordinances relating to fire, construction, building, health, food service and safety, including but not limited to the Hotel and Motel Fire Safety Act of 1990, Public Law 101-391. The Judicial Council may terminate this Agreement, pursuant to the termination for cause provision set forth herein, without penalty or prejudice if the Contractor fails to comply with the foregoing requirements. B. The Contractor shall assure that each Attendee is advised of all the appropriate precautions that should be taken to provide for the Attendee’s safety while on the Property. The Contractor shall take every reasonable precaution to provide for the security of Attendees and their belongings. C. The Contractor shall immediately advise the Judicial Council’s staff of any known problems that involve the Attendees during the Program including, but not limited to, assaults, burglaries, accidents, and/or illnesses.
Health, Safety and Security 14.1 The Employer recognizes a responsibility to provide an environment intended to protect the health, safety and security of Members as they carry out their responsibilities. To that end, the Employer agrees: (a) to maintain a Joint Health and Safety Committee (the JHSC) with broad representation drawn from all sectors of the University, including at least one (1) person appointed by the Association; (b) to cooperate with the Association in making every reasonable provision for the safety, health and security of Members; (c) to take reasonable measures to maintain the security of the buildings and grounds while at the same time maintaining reasonable access for Members who have a need for such access at times other than during regular working hours; (d) to ensure that the Association has the right to appoint at least one (1) person to any representative committee whose terms of reference specifically include the health, safety or security of Members as they carry out their responsibilities; (e) to comply with the Occupational Health and Safety Act, R.S.O. 1990, and relevant regulations thereto, as amended from time to time (the “Act”); (f) that Members may refuse unsafe work pursuant to and in accordance with the relevant provisions of the Act for so doing; (g) that Members report any known or potential dangers to their Xxxx; (h) In addition, the Employer agrees: i) to provide Members with health and safety training, personal protective equipment, and access to health and safety programs, policies and procedures; ii) to provide resources for the JHSC; iii) to compensate a CASBU Member who is eligible to be, and serves as, the person appointed by the Association to the JHSC when that service is outside the period of the Member’s contract; iv) to provide training for the person appointed by the Association to the JHSC directly related to their duties and responsibilities in connection with the JHSC; v) to recognize a JHSC Member’s right to be present during workplace safety testing and audits and receive written copies of any reports and recommendations from the testing/audits and a copy of a draft report if one is provided to the Employer; vi) to recognize a JHSC Member’s right to have advance notice when advance notice is given by the Ministry of Labour of any Ministry of Labour inspection and to accompany a Ministry of Labour Inspector during an inspection and receive a copy of any report produced by the inspector. 14.2 The parties agree that all personal communications must adhere to the Personal Harassment and Discrimination Policy and the Nipissing University Acceptable Use Policy. Effective June 10, 2006, universities are subject to the Freedom of Information and Protection of Privacy Act (FIPPA). All records in the custody and control of the University will be subject to FIPPA with exceptions as defined by the Act. Persons may request and have a right to access University information or records. A record is defined under the Act as any record of information however recorded, whether in printed or electronic form, film, or otherwise and includes drafts, post-it notes, margin notes, hard drive files, emails, voice mails, electronic agendas, address books, and recording devices. 14.3 Unless required under FIPPA, and for the purposes of this Article, files are documents under a Member’s control and stored on University property, either in paper or electronic form. Such files do not include the Member’s official file in the Xxxx’x office nor the Personnel File of the Member in the Human Resources office. 14.4 On termination of a Member’s employment for any reason other than cause, the Employer will permit, by appointment only, accompanied access for a period of fifteen (15) working days (or longer with the agreement of the Xxxx) by the former Member or the Member’s executors to the Member’s files, whether in paper or electronic format. The purpose of the allowed access is for transferring required documents to other faculty, the Chair, or the Xxxx. Where files are not required to support continued student academic needs or ongoing operational requirements, the former Member or designate may remove or destroy their personal files. Items that are clearly of a personal nature or are owned by the former Member such as furniture, pictures, books, etc., may be removed at this time.
Data Security and Privacy Plan As more fully described herein, throughout the term of the Subscription Agreement, Vendor will have a Data Security and Privacy Plan in place to protect the confidentiality, privacy and security of the Protected Data it receives from the District. Vendor’s Plan for protecting the District’s Protected Data includes, but is not limited to, its agreement to comply with the terms of the District’s Bill of Rights for Data Security and Privacy, a copy of which is set forth below and has been signed by the Vendor. Additional components of Vendor’s Data Security and Privacy Plan for protection of the District’s Protected Data throughout the term of the Subscription Agreement are as follows: (a) Vendor will implement all state, federal, and local data security and privacy requirements including those contained within the Subscription Agreement and this Data Sharing and Confidentiality Agreement, consistent with the District’s data security and privacy policy. (b) Vendor will have specific administrative, operational and technical safeguards and practices in place to protect Protected Data that it receives from the District under the Subscription Agreement. (c) Vendor will comply with all obligations contained within the section set forth in this Exhibit below entitled “Supplemental Information about a Subscription Agreement between [Xxxxx-Fultonville Central School District] and [Vendor Name].” Vendor’s obligations described within this section include, but are not limited to: (i) its obligation to require subcontractors or other authorized persons or entities to whom it may disclose Protected Data (if any) to execute written agreements acknowledging that the data protection obligations imposed on Vendor by state and federal law and the Subscription Agreement shall apply to the subcontractor, and (ii) its obligation to follow certain procedures for the return, transition, deletion and/or destruction of Protected Data upon termination, expiration or assignment (to the extent authorized) of the Subscription Agreement. (d) Vendor has provided or will provide training on the federal and state laws governing confidentiality of Protected Data for any of its officers or employees (or officers or employees of any of its subcontractors or assignees) who will have access to Protected Data, prior to their receiving access. (e) Vendor will manage data security and privacy incidents that implicate Protected Data and will develop and implement plans to identify breaches and unauthorized disclosures. Vendor will provide prompt notification to the District of any breaches or unauthorized disclosures of Protected Data in accordance with the provisions of Section 5 of this Data Sharing and Confidentiality Agreement.
Safety and Security Contractor is responsible for maintaining safety in the performance of this Agreement. Contractor shall be responsible to ascertain from the District the rules and regulations pertaining to safety, security, and driving on school grounds, particularly when children are present.
Safety and Security Procedures Contractor shall maintain and enforce, at the Contractor Work Locations, industry-standard safety and physical security policies and procedures. While at each Court Work Location, Contractor shall comply with the safety and security policies and procedures in effect at such Court Work Location.
Fraud, Waste, and Abuse Contractor understands that HHS does not tolerate any type of fraud, waste, or abuse. Violations of law, agency policies, or standards of ethical conduct will be investigated, and appropriate actions will be taken. Pursuant to Texas Government Code, Section 321.022, if the administrative head of a department or entity that is subject to audit by the state auditor has reasonable cause to believe that money received from the state by the department or entity or by a client or contractor of the department or entity may have been lost, misappropriated, or misused, or that other fraudulent or unlawful conduct has occurred in relation to the operation of the department or entity, the administrative head shall report the reason and basis for the belief to the Texas State Auditor’s Office (SAO). All employees or contractors who have reasonable cause to believe that fraud, waste, or abuse has occurred (including misconduct by any HHS employee, Grantee officer, agent, employee, or subcontractor that would constitute fraud, waste, or abuse) are required to immediately report the questioned activity to the Health and Human Services Commission's Office of Inspector General. Contractor agrees to comply with all applicable laws, rules, regulations, and System Agency policies regarding fraud, waste, and abuse including, but not limited to, HHS Circular C-027. A report to the SAO must be made through one of the following avenues: ● SAO Toll Free Hotline: 1-800-TX-AUDIT ● SAO website: xxxx://xxx.xxxxx.xxxxx.xx.xx/ All reports made to the OIG must be made through one of the following avenues: ● OIG Toll Free Hotline 0-000-000-0000 ● OIG Website: XxxxxxXxxxxXxxxx.xxx ● Internal Affairs Email: XxxxxxxxXxxxxxxXxxxxxxx@xxxx.xxxxx.xx.xx ● OIG Hotline Email: XXXXxxxxXxxxxxx@xxxx.xxxxx.xx.xx. ● OIG Mailing Address: Office of Inspector General Attn: Fraud Hotline MC 1300 P.O. Box 85200 Austin, Texas 78708-5200
COMPLIANCE WITH HEALTH, SAFETY, AND ENVIRONMENTAL REGULATIONS The Contractor, it’s Subcontractors, and their respective employees, shall comply fully with all applicable federal, state, and local health, safety, and environmental laws, ordinances, rules and regulations in the performance of the services, including but not limited to those promulgated by the City and by the Occupational Safety and Health Administration (OSHA). In case of conflict, the most stringent safety requirement shall govern. The Contractor shall indemnify and hold the City harmless from and against all claims, demands, suits, actions, judgments, fines, penalties and liability of every kind arising from the breach of the Contractor’s obligations under this paragraph.
Data Security and Privacy (a) Each Group Member is, and at all times, has been, in compliance in all material respects with (i) all applicable Data Protection Laws, including, to the extent applicable, but not limited to the GDPR and those relating to cross-border transfers; (ii) all applicable contractual obligations of each Loan Party and its Subsidiaries concerning data privacy and security relating to Personal Data in the possession or control of any Group Member or maintained by third parties on behalf of such Group Member and having access to such information under contracts (or portions thereof) to which a Group Member is a party; and (iii) all applicable data transfer agreements and data processing agreements, including the EU standard contractual clauses, to which a Group Member is a party (collectively, “Privacy Agreements”): (b) Each Group Member is, and has been, in compliance in all material respects with all applicable prior and current written internal and public-facing privacy policies and notices of the Group Members regarding the collection, retention, use, processing, disclosure and distribution of Personal Data by the Group Members or their respective agents (collectively, the “Privacy Policies”), and the Privacy Policies have been maintained to be consistent in all material respects with the actual practices of each Group Member. The Privacy Policies contemplate the Group Members’ current uses of the Personal Data, and to the extent required under applicable Data Protection Laws, each Group Member has sought and obtained the appropriate consent from the applicable data subject for such uses. The Privacy Policies have made all material disclosures to users, customers, employees, or other individuals required by Data Protection Laws. (c) Each Group Member has implemented and maintains a commercially reasonable security program (“Security Program”) that (i) complies in all material respects with all applicable Data Protection Laws, applicable Privacy Policies, and applicable Privacy Agreements, and (ii) includes commercially reasonable administrative, technical, organization, and physical security procedures and measures designed to preserve the security and integrity of all Personal Data and any other sensitive or confidential information or data related to each Group Member (collectively, “Company Sensitive Information”) in such Group Member’s possession or control and to protect such Company Sensitive Information against unauthorized or unlawful processing, access, acquisition, use, theft, interruption, modification, disclosure, loss, destruction or damage. (d) Except as disclosed on Schedule 4.23(d), there has been (i) no actual, suspected or alleged (in writing) incidents of unauthorized access, use, intrusion, disclosure or breach of the security of any information technology systems owned or controlled by a Group Member or any of their contractors and used by such contractors on behalf of a Group Member, and (ii) no actual, suspected or alleged (in writing) incidents of unauthorized acquisition, destruction, damage, disclosure, loss, corruption, alteration, or use of any Company Sensitive Information, in each case that could reasonably be expected to cause a Material Adverse Effect. (e) Each Group Member has a valid and legal right (whether contractually, by applicable law or otherwise) to access or use all Personal Data that is accessed and used by or on behalf of a Group Member in connection with the sale, use and/or operation of their products, services and businesses. (f) Except as would not reasonably be expected to have a Material Adverse Effect, there is no pending or to the knowledge of any Loan Party, threatened in writing, complaints, claims, demands, inquiries, proceedings, or other notices, including any notices of any investigation or other legal proceedings, regarding a Group Member, initiated by (i) any Governmental Authority, including the United States Federal Trade Commission, a state attorney general, data protection authority or similar state official, or a supervisory authority; (ii) any counterparty to, or subject of, a Privacy Agreement; or (iii) any self-regulatory authority or entity, alleging that any activity of a Group Member: (1) is in violation of any applicable Data Protection Laws, (2) is in violation of any Privacy Agreements, (3) is in violation of any Privacy Policies or (4) is otherwise in violation of any person’s privacy, personal or confidentiality rights.
COMPLIANCE WITH NEW YORK STATE INFORMATION SECURITY BREACH AND NOTIFICATION ACT Contractor shall comply with the provisions of the New York State Information Security Breach and Notification Act (General Business Law Section 899-aa; State Technology Law Section 208).
Description of Goods The description of each good in Box7 must include the Harmonized Commodity Description and Coding System (HS) subheading at the 6-digit level of the exported product, and if applicable, product name and brand name. This information should be sufficiently detailed to enable the products to be identified by the customs officer examining them.
