Domestic Steel The Recipient shall use and cause all of its Contractors and subcontractors to comply with domestic steel use requirements pursuant to Section 153.011 of the Ohio Revised Code;
Distribution of UDP and TCP queries DNS probes will send UDP or TCP “DNS test” approximating the distribution of these queries.
Preference for domestically manufactured goods The provisions of paragraphs 2.54 and 2.55 of the Guidelines and Appendix 2 thereto shall apply to goods manufactured in the territory of the Borrower.
Application of Code Section 409A 8.1 Notwithstanding anything in this Agreement to the contrary, the receipt of any benefits under this Agreement as a result of a termination of employment will be subject to satisfaction of the condition precedent that you undergo a “separation from service” within the meaning of Treas. Reg. § 1.409A-1(h) or any successor thereto. In addition, if you are deemed to be a “specified employee” within the meaning of that term under Code Section 409A(a)(2)(B), then with regard to any payment or the provisions of any benefit that is required to be delayed pursuant to Code Section 409A(a)(2)(B), such payment or benefit will not be made or provided prior to the earlier of (i) the expiration of the six (6) month period measured from the date of your “separation from service” (as such term is defined in Treas. Reg. § 1.409A-1(h)), or (ii) the date of your death (the “Delay Period”). Within 10 days following the expiration of the Delay Period, all payments and benefits delayed pursuant to this Section (whether they would have otherwise been payable in a single sum or in installments in the absence of such delay) will be paid or reimbursed to you in a lump sum, and any remaining payments and benefits due under this Agreement will be paid or provided in accordance with the normal payment dates specified for them herein. To the extent that the foregoing applies to the provision of any ongoing welfare benefits to you that would not be required to be delayed if the premiums therefore were paid by you, you will pay the full costs of premiums for such welfare benefits during the Delay Period and the Corporation or the Bank will pay you an amount equal to the amount of such premiums paid by you during the Delay Period within 10 days after the conclusion of such Delay Period.
8.2 Except as otherwise expressly provided herein, to the extent any expense reimbursement or other in-kind benefit is determined to be subject to Code Section 409A, the amount of any such expenses eligible for reimbursement or in-kind benefits in one calendar year will not affect the expenses eligible for reimbursement or in-kind benefits in any other taxable year (except under any lifetime limit applicable to expenses for medical care), in no event will any expenses be reimbursed or in-kind benefits be provided after the last day of the calendar year following the calendar year in which you incurred such expenses or received such benefits, and in no event will any right to reimbursement or in-kind benefits be subject to liquidation or exchange for another benefit.
8.3 Any payments made pursuant to Section 2.1, to the extent of payments made from the date of termination through March 15th of the calendar year following such date, are intended to constitute separate payments for purposes of Treas. Reg. §1.409A-2(b)(2) and thus payable pursuant to the “short-term deferral” rule set forth in Treas. Reg. §1.409A-1(b)(4); to the extent such payments are made following said March 15th, they are intended to constitute separate payments for purposes of Treas. Reg. §1.409A-2(b)(2) made upon an involuntary termination from service and payable pursuant to Treas. Reg. §1.409A-1(b)(9)(iii), to the maximum extent permitted by said provision.
8.4 To the extent it is determined that any benefits described in Section 2.1(b) are taxable to you, they are intended to be payable pursuant to Treas. Reg. §1.409A-1(b)(9)(v), to the maximum extent permitted by said provision.
Family and Domestic Violence Leave 46.1 For the purposes of this clause, “family and domestic violence” and “family member” are defined in the Award.
CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes
Domestic Regulation 1. In sectors where specific commitments are undertaken, each Party shall ensure that all measures of general application affecting trade in services are administered in a reasonable, objective and impartial manner. 2. Each Party shall maintain or institute as soon as practicable judicial, arbitral or administrative tribunals or procedures which provide, at the request of an affected service supplier of the other Party, for the prompt review of, and where justified, appropriate remedies for, administrative decisions affecting trade in services. Where such procedures are not independent of the agency entrusted with the administrative decision concerned, the Party shall ensure that the procedures in fact provide for an objective and impartial review.
Domestic Relations Orders If any judgment, decree or order (including approval of a property settlement agreement) which (i) relates to the provision of child support, alimony payments, or marital property rights to a spouse, former spouse, child, or other dependent of a Participant, and (ii) is made pursuant to a state or foreign domestic relations law (including a community property law) directs assignment of a portion of a Participant’s Account to a spouse, former spouse, child, or other dependent of a Participant, such amount may be paid in a lump-sum cash payment at the request of the person to whom assignment is directed to be made as soon as administratively possible after the Administrator’s receipt of the signed order, as long as the order (or a written direction to the Administrator of how to interpret the order, signed by the Participant and the person to whom the order directs assignment) clearly specifies the amount of the Account assigned and the timing of payment to the person to whom the assignment is made.
Uniform Commercial Code Security Agreement (a) This Instrument is also a security agreement under the Uniform Commercial Code for any of the Mortgaged Property which, under applicable law, may be subjected to a security interest under the Uniform Commercial Code, whether such Mortgaged Property is owned now or acquired in the future, and all products and cash and non-cash proceeds thereof (collectively, "UCC Collateral"), and Borrower hereby grants to Lender a security interest in the UCC Collateral. Borrower hereby authorizes Lender to prepare and file financing statements, continuation statements and financing statement amendments in such form as Lender may require to perfect or continue the perfection of this security interest and Borrower agrees, if Lender so requests, to execute and deliver to Lender such financing statements, continuation statements and amendments. Borrower shall pay all filing costs and all costs and expenses of any record searches for financing statements and/or amendments that Lender may require. Without the prior written consent of Lender, Borrower shall not create or permit to exist any other lien or security interest in any of the UCC Collateral.
(b) Unless Borrower gives Notice to Lender within 30 days after the occurrence of any of the following, and executes and delivers to Lender modifications or supplements of this Instrument (and any financing statement which may be filed in connection with this Instrument) as Lender may require, Borrower shall not (i) change its name, identity, structure or jurisdiction of organization; (ii) change the location of its place of business (or chief executive office if more than one place of business); or (iii) add to or change any location at which any of the Mortgaged Property is stored, held or located.
(c) If an Event of Default has occurred and is continuing, Lender shall have the remedies of a secured party under the Uniform Commercial Code, in addition to all remedies provided by this Instrument or existing under applicable law. In exercising any remedies, Lender may exercise its remedies against the UCC Collateral separately or together, and in any order, without in any way affecting the availability of Lender's other remedies.
(d) This Instrument constitutes a financing statement with respect to any part of the Mortgaged Property that is or may become a Fixture, if permitted by applicable law.
Domestic Partners; Spouses; Gender Discrimination If the Contract Amount is $100,000 or more, Contractor certifies that it is in compliance with PCC 10295.3, which places limitations on contracts with contractors who discriminate in the provision of benefits regarding marital or domestic partner status.
