Common use of Vertical and horizontal adjustment Clause in Contracts

Vertical and horizontal adjustment. If the "cut-off" complies with the quality requirements of paragraph 2.2. the beam adjustment may be performed instrumentally. Figure A5-II 2.3.1. Vertical adjustment Moving upward from below the line B (see Figure A5-III), a vertical scan is carried out through the horizontal part of the "cut-off" at 2.5° from V-V. Xxx xxxxxxxxxx xxxxx (xxxxx x0 (xxx X) / xx0 = 0) is determined and positioned on the line B situated one per cent below H-H.

Vertical and horizontal adjustment. If the "cut-off" complies with the quality requirements of paragraph 2.2. the beam adjustment may be performed instrumentally. Figure A5-IIII Note: The scales are different for vertical and horizontal lines. 2.3.1. Vertical adjustment Moving upward from below the line B (see Figure A5-III), a vertical scan is carried out through the horizontal part of the "cut-off" at 2.5° from V-V. Xxx xxxxxxxxxx xxxxx (xxxxx x0 (xxx X) / xx0 = 0) is determined and positioned on the line B situated one per cent below H-H.

Vertical and horizontal adjustment. If the "cut-off" complies with the quality requirements of paragraph 2.2. ., the beam adjustment may be performed instrumentally. Figure A5-IIII Measurement of "cut-off" quality 2.3.1. Vertical adjustment Moving upward from below the line B (see Figure A5-III), a vertical scan is carried out through the horizontal part of the "cut-off" at 2.5° from V-V. Xxx xxxxxxxxxx xxxxx The inflection point (xxxxx x0 where d2 (xxx Xlog E) / xx0 dv2 = 0) is determined and positioned on the line B situated one per cent below H-H.