Annual Degradation Factor definition

Annual Degradation Factor has the meaning set forth in Section 1.01(i).
Sample 1Sample 2Sample 3
Annual Degradation Factor is stated on Exhibit B.
Sample 1Sample 2
Annual Degradation Factor means the amount by which the projected output of the “insured energy installation” is expected to be reduced for each year of service. This factor may be provided by the project manufacturer or engineer or it may be determined by us. The “annual degradation factor” for this insurance is indicated in the Declarations / Policy schedule.
Sample 1Sample 2

Examples of Annual Degradation Factor in a sentence

  • The Estimated Annual Production will be reduced by the Annual Degradation Factor every Contract Year during the Term.

  • The Annual Degradation Factor will be applied to the kWh energy values of the weather-adjusted Estimated Annual Production (as defined in Exhibit E as the “Calculated kWh”).

  • Provider and Host agree that in accordance with the Systems manufacturer’s specifications, performance of the Systems will degrade by an Annual Degradation Factor as defined in EXHIBIT D for every year of operation.

  • The degradation factor will be applied on a pro rata basis for System operations that do not span an entire Operational Year by multiplying the Annual Degradation Factor times the fraction of the Operational Year.

  • Subject to Section 1.11, commencing on the later of the Commercial Operation Date or the RA Delivery Commencement Date and throughout the remainder of the Delivery Term, Seller shall provide to SCE at least the amount of Resource Adequacy Benefits solely from the Generating Facility in each month (the “Guaranteed RA Quantity”) equal to the product of (I) the RA Benefits specified in the table below for the applicable month, expressed in MW, multiplied by (II) the Annual Degradation Factor.

  • Calculated kWh” means the amount of kWh expected to be produced in consideration of the final system design of each System (but before considering the Annual Degradation Factor) as calculated using PVSYST energy simulation software (or other software as commonly used to calculate solar production) using actual (1) solar insolation, (2) ambient air temperature, and (3) wind speed, as measured by the Metering Device (the “Actual Weather Data”).

  • Annual Degradation Factor: the percentage by which the energy production of the solar panels is expected to decrease each year.

  • The CPRI, in its report dated December 2010, has observed that Heat Rate of Unit 3 at 100% load, under ideal conditions (0% make-up, no change in fuel consumption etc., Test Coal as analyzed and used during Performance Test) is 2577 kCal/kWh. Further, according to the Petitioner, CPRI has recommended Annual Heat Rate of 2643 kCal/kWh for FY 2010-11 and has also determined an Annual Degradation Factor for Unit 3 at 0.4% which translates to 9 kCal/kWh/year.

  • Calculated kWh” means the amount of kWh expected to be produced in consideration of the final system design of each System (but before considering the Annual Degradation Factor) as calculated using PVSYST energy simulation software (or other software as commonly used to calculate solar production) using actual (1) solar insolation, (2) ambient air temperature, and (3) wind speed, asmeasured by the Metering Device (the “Actual Weather Data”).

  • Neither the Law nor the Administrative Instruction gives any indication of how the DMC post should inter-relate with any of the other three community participation mechanisms (for some posts, individual municipal statutes provide additional detail in this respect).iv.


More Definitions of Annual Degradation Factor

Annual Degradation Factor means the annual degradation factor of the Systems as set forth in EXHIBIT D.
Sample 1Sample 2
Annual Degradation Factor means . . .
Sample 1
Annual Degradation Factor. Commencing on the first anniversary of the Commercial Operations Date, for the second Agreement Year and thereafter for each successive Agreement Year till the end of the Term, the lower of:
Sample 1

Related to Annual Degradation Factor

  • Inflation Factor means a number determined for each tax year by dividing the consumer price index for June of the tax year by the consumer price index for June 2005.

  • Limited Indexation Factor means, in respect of a Limited Indexation Month or Limited Indexation Date, as the case may be, the ratio of the Index Figure applicable to that month or date, as the case may be, divided by the Index Figure applicable to the month or date, as the case may be, twelve months prior thereto, provided that (a) if such ratio is greater than the Maximum Indexation Factor specified in the relevant Final Terms, it shall be deemed to be equal to such Maximum Indexation Factor and (b) if such ratio is less than the Minimum Indexation Factor specified in the relevant Final Terms, it shall be deemed to be equal to such Minimum Indexation Factor;

  • Capacity Utilization Factor or “CUF” Shall have the same meaning as provided in CERC (Terms and Conditions for Tariff determination from Renewable Energy Sources) Regulations, 2009 as amended from time to time. Here, the CUF is expressed in AC terms.

  • Expansion Factor has the meaning ascribed thereto in Section 2.3(a);

  • Weighting factor wT for an organ or tissue (T) means the proportion of the risk of stochastic effects resulting from irradiation of that organ or tissue to the total risk of stochastic effects when the whole body is irradiated uniformly. For calculating the effective dose equivalent, the values of wT are:

  • Accumulation Period Factor means, for any Collection Period, a fraction with:

  • Required Accumulation Factor Number shall be equal to a fraction, rounded upwards to the nearest whole number, the numerator of which is one and the denominator of which is equal to the lowest monthly principal payment rate on the Accounts, expressed as a decimal, for the three months preceding the date of such calculation.

  • Load Factor means the percentage of aircraft seats actually occupied on a flight (RPMs divided by ASMs). “NMB” means the National Mediation Board.

  • Average Monthly Limit means the maximum allowable "Average Monthly Concentration" as defined in Section 22a-430-3(a) of the RCSA when expressed as a concentration (e.g. mg/l); otherwise, it means "Average Monthly Discharge Limitation" as defined in Section 22a-430-3(a) of the RCSA.

  • emission factor means the average emission rate of a greenhouse gas relative to the activity data of a source stream assuming complete oxidation for combustion and complete conversion for all other chemical reactions;

  • Lowest achievable emission rate or “LAER” means, for any source, the more stringent rate of emissions based on the following:

  • Dilution Factors means, without duplication, with respect to any period, the aggregate amount of all deductions, credit memos, returns, adjustments, allowances, bad debt write-offs and other non-cash credits which are recorded to reduce accounts receivable in a manner consistent with current and historical accounting practices of the Borrower.

  • Stress Factor means 2.25.

  • Class Factor As to any date of determination and any Class of Certificates (other than the Interest Only Classes and the Residual Certificates), a fraction the numerator of which is (i) the aggregate of the denominations of all Certificates of such Class plus, in the case of each Accrual Class, all interest that has accrued on the Certificates of such Class prior to such date of determination and been added to the Class Balance thereof, less (ii) the aggregate amount of all Principal Distribution Amounts, if any, allocable thereto prior to such date of determination and the denominator of which is the original Class Balance of such Class. As to any date of determination and any Interest Only Class, a fraction, the numerator of which is the percentage of the balance specified for such purpose under “Reference Sheet–Notional Classes” in the Prospectus Supplement (or, if applicable, the sum of the applicable percentages of the balances so specified) and the denominator of which is the original Class Balance thereof. Code: The Internal Revenue Code of 1986, as amended, including any successor or amendatory provisions.

  • Leverage Factor means the leverage factor in respect of a Series of ETP Securities as specified in the relevant Final Terms.

  • Loss Factor means the scaling factor determined in accordance with clause 7 and applied by the reconciliation manager to volumes of electricity measured or estimated in respect of ICPs on the Network, in order to reflect the impact of the ICP on Losses within the Network;

  • Maximum contaminant level goal or “MCLG” means the maximum level of a contaminant in drinking water at which no known or anticipated adverse effect on the health of persons would occur, and which allows an adequate margin of safety. MCLGs are nonenforceable health goals.

  • Fit factor means a quantitative estimate of the fit of a particular respirator to a specific individual, and typically estimates the ratio of the concentration of a substance in ambient air to its concentration inside the respirator when worn.

  • Baseline Value for each of the Company and the Peer Companies means the dollar amount representing the average of the Fair Market Value of one share of common stock of such company over the five consecutive trading days ending on, and including, the Effective Date.

  • Required Reserve Factor Floor means, for any Calculation Period, the sum (expressed as a percentage) of (a) 12.5% plus (b) the product of the Adjusted Dilution Ratio and the Dilution Horizon Ratio, in each case, as of the most recent Cut-Off Date.

  • emission limit value means the mass, expressed in terms of certain specific parameters, concentration and/or level of an emission, which may not be exceeded during one or more periods of time;

  • Maximum residual disinfectant level or “MRDL” means a level of a disinfectant added for water treatment that may not be exceeded at the consumer’s tap without an unacceptable possibility of adverse health effects.

  • Average value means the value which best represents the amount of the nutrient which a given food contains, and reflects allowances for seasonal variability, patterns of consumption and other factors which may cause the actual value to vary.

  • Applicable Multiplier means, with respect to any Rate Period for any Series of RVMTP Shares, the percentage set forth opposite the applicable credit rating most recently assigned to such Series by the Rating Agency in the table below on the Rate Determination Date for such Rate Period: Long-Term Ratings* Fitch Applicable Multiplier AAA to AA- 100% A+ to A- 000% BBB+ to BBB- 140% *And/or the equivalent ratings of any other Rating Agency then rating the RVMTP Shares utilizing the highest of the ratings of the Rating Agencies then rating the RVMTP Shares.

  • Average Contribution Percentage means the average of the Contribution Percentages of the Eligible Participants in a group.