Base Surface definition

Base Surface means the base surface calculated from the official established building grades.
Base Surface means the base surface calculated from the official established building grades, except that for this sloped site “base surface” shall be deemed to be 30.4 m (99.81 ft.).

Examples of Base Surface in a sentence

  • These features, as well as features to be retained from the chart and features digitized from the Base Surface, are included in the HCell.

  • POTENTIAL_USABILITY TYPES A AND B MATERIAL AVAILABLE Best known potential use of the material, based on records, exploration and laboratory data.CONCRETE AGGREGATE PRODUCED The site has produced concrete aggregate PAVING AGGREGATE PRODUCED The site has produced paving aggregateCRUSHED PRODUCTS PRODUCED Base, Surface Coarse, Subbase, etc.

  • Amendment to OPSS.MUNI 314 Construction Specification for Untreated Granular Subbase, Base, Surface, Shoulder and Stockpiling.

  • OPSS 314 (1993), “Construction Specification for Untreated Granular, Subbase, Base, Surface Shoulder and Stockpiling”, Ontario Provincial Standard Specification.

  • The resultant difference surface was exported using the Base Surface to ASCII function and statistics were compiled on the ASCII data.

  • If the percent passing the No. 200 sieve is less than 12% 2 to 9 703.05_National_7_18_2017If the percent passing the No. 200 sieve is greater than 12% Less than 2 703.05_National_3_17_2021 Delete 703.05 and replace with the following:703.05 Subbase, Base, Surface Course, and Screened Aggregate.

  • Words in this by-law shall have the meaning assigned to them in the Zoning and Development By-law, except as provided below: Base Surface means the base surface calculated from the official established building grades.

  • Wafer No.Interface ThicknessRMS of Surface BRMS of Surface ABol286F3.3±0.3 nm0.85 nm0.55 nm 3.2.1.5 Base Surface Oxidation Effect on the Base Contact Resistivity It is crucial to avoid contact surface oxidation that can degrade Ohmic performance [70].

  • The finalized Base Surface, H11335_Combined.hns, was used to generate a depth area, and for survey evaluation and verification purposes only, a set of contours.

  • Gravel driveway restoration will consist of a minimum compacted depth of 150 mm of Granular 'A' in accordance with the requirements of OPSS.MUNI 314 Construction Specifications for Untreated Granular, Subbase, Base, Surface, Shoulder and Stockpiling.

Related to Base Surface

  • Pervious surface means an area that releases as runoff a small portion of the precipitation that falls on it. Lawns, gardens, parks, forests or other similar vegetated areas are examples of surfaces that typically are pervious.

  • Water surface elevation means the height, in relation to the National Geodetic Vertical Datum (NGVD) of 1929, the North American Vertical Datum (NAVD) of 1988, or other datum, where specified, of floods of various magnitudes and frequencies in the floodplains of riverine areas.

  • Water Surface Elevation (WSE means the height, in relation to NAVD 1988, of floods of various magnitudes and frequencies in the floodplains of riverine areas.

  • Rentable Area of the Premises The amount of square footage set forth in Section 1.01(10).

  • Surface impoundment or "impoundment" means a facility or part of a facility which is a natural topographic depression, man-made excavation, or diked area formed primarily of earthen materials (although it may be lined with man-made materials), which is designed to hold an accumulation of liquid wastes or wastes containing free liquids, and which is not an injection well. Examples of surface impoundments are holding, storage, settling, and aeration pits, ponds, and lagoons.

  • Underground facility means any item which shall be buried or placed below ground for use in connection with the storage or conveyance of water, sewage, electronic, telephone or telegraphic communications, electric energy, oil, gas or other substances, and shall include, but not be limited to pipes, sewers, conduits, cables, valves, lines, wires, manholes, attachments and those portions of poles and their attachments below ground.

  • Customer Premises Equipment or "CPE" means equipment employed on the premises of a Person other than a Carrier to originate, route or terminate Telecommunications (e.g., a telephone, PBX, modem pool, etc.).

  • Storage Space means a space where goods of non-hazardous nature are stored and includes cold storage and banking safe vaults;

  • Impact surface means an interior or exterior surface that is subject to damage by repeated sudden force such as certain parts of door frames.

  • stacked bicycle parking space means a horizontal bicycle parking space that is positioned above or below another bicycle parking space and equipped with a mechanical device providing floor level access to both bicycle parking spaces.

  • Building, structure, facility, or installation means all of the pollutant-emitting activities which belong to the same industrial grouping, are located on one or more contiguous or adjacent properties, and are under the control of the same person (or persons under common control) except the activities of any vessel. Pollutant-emitting activities shall be considered as part of the same industrial grouping if they belong to the same major group (i.e., which have the same two-digit code) as described in the Standard Industrial Classification Manual, 1972, as amended by the 1977 Supplement (U.S. Government Printing Office stock numbers 4101-0066 and 003-005-00176-0, respectively).

  • Impervious surface means a surface that has been covered with a layer of material so that it is highly resistant to infiltration by water.

  • Underground area means an underground room, such as a basement, cellar, shaft or vault, providing enough space for physical inspection of the exterior of the tank situated on or above the surface of the floor.

  • The Building means any building of which the Property forms part.

  • Containment building means a hazardous waste management unit that is used to store or treat hazardous waste pursuant to the provisions of Subpart DD of 35 Ill. Adm. Code 724 and Subpart DD of 35 Ill. Adm. Code 725.

  • Built-Up Area and/or “Covered Area” in relation to a Flat shall mean the floor area of that Flat including the area of balconies and terraces, if any attached thereto, and also the thickness of the walls (external or internal) and the columns and pillars therein Provided That if any wall, column or pillar be common between two Flats, then one-half of the area under such wall column or pillar shall be included in the built-up area of each such Flat.

  • Building Square Footage or "BSF" means the square footage of assessable internal living space of a Unit, exclusive of any carports, walkways, garages, overhangs, patios, enclosed patios, detached accessory structure, other structures not used as living space, or any other square footage excluded under Government Code Section 65995 as determined by reference to the Building Permit for such Unit.

  • Groundwater means all water, which is below the surface of the ground in the saturation zone and in direct contact with the ground or subsoil.

  • Common Areas is defined as all areas and facilities outside the Premises and within the exterior boundary line of the Project and interior utility raceways and installations within the Unit that are provided and designated by the Lessor from time to time for the general non-exclusive use of Lessor, Lessee and other tenants of the Project and their respective employees, suppliers, shippers, customers, contractors and invitees, including parking areas, loading and unloading areas, trash areas, roadways, walkways, driveways and landscaped areas.

  • Building Project means the aggregate combined parcel of land on a portion of which are the improvements of which the Premises form a part, with all the improvements thereon, said improvements being a part of the block and lot for tax purposes which are applicable to the aforesaid land.

  • Common Areas and Facilities means collectively the Development Common Areas and Facilities and the Residential Common Areas and Facilities and all those parts and such of the facilities of the Development designated as common areas and facilities in any Sub-Deed;

  • Common Area means all areas and facilities within the Project that are not designated by Landlord for the exclusive use of Tenant or any other lessee or other occupant of the Project, including the parking areas, access and perimeter roads, pedestrian sidewalks, landscaped areas, trash enclosures, recreation areas and the like.

  • Drainage area means a geographic area within which stormwater, sediments, or dissolved materials drain to a particular receiving waterbody or to a particular point along a receiving waterbody.

  • Base Building shall include the structural portions of the Building, the public restrooms and the Building mechanical, electrical and plumbing systems and equipment located in the internal core of the Building on the floor or floors on which the Premises are located. Tenant shall promptly provide Landlord with copies of any notices it receives regarding an alleged violation of Law. Tenant shall comply with the rules and regulations of the Building attached as Exhibit E and such other reasonable rules and regulations adopted by Landlord from time to time, including rules and regulations for the performance of Alterations (defined in Section 9).

  • public open space means the securing of an area of a site at grade or street level which is acceptable to the City and is appropriately landscaped for the use and enjoyment of the public during reasonable hours.

  • Building Area means the greatest horizontal area of a building within the outside surface of the exterior walls.