BOD Load definition

BOD Load means the number of kilograms of BOD in industrial wastewater, after multiplying the number of litres of industrial wastewater discharged by the number of kilograms per litre indicated by the BOD;
Sample 1Sample 2Sample 3

Examples of BOD Load in a sentence

  • This JICA Study proposed “priority towns” for WWTPs or sewerage improvement are selected mainly based on the reduction rate of BOD load against the Near Future BOD Load scenario.

  • Co-relation between the accumulated catchment BOD load, which accumulate BOD load of NAM catchments locating upstream from certain calculation point in the river, and the river BOD Load in dry season (July to September) is calculated.

  • Table 4.3 Top 10 Districts in Terms of BOD Load Generation in the Ganga basin Sr. No. District State BOD Generation Sub-basin State-wise BOD generation in descending order is presented in Table 4.4. As expected, UP is the largest generator accounting for 38% of the total, followed by West Bengal at 30%.

  • Dewatered sewage sludge was obtained from Wupa Wastewater Treatment Plant (W.W.T.P.) in federal capital territory Abuja and transported down to Abubakar Tafawa Balewa University Bauchi (ATBU Bauchi) in plastic bags as in Fig 1 below, serves the city of Abuja, the Capital of the federal republic of Nigeria with an average design flow of 13120 m3/day), average B.O.D. Load 66,000 kg/day and effluent quality 15/20/10 BOD/TSS/N.

  • The F/M ratio is calculated as follows:- F/M = Organic LoadingVolume of Sludge = BOD Load (kg/d) Volume of Aeration Tank (m3) x MLSS (kg/m3) The CIWEM Handbook of UK Wastewater Practice entitled ‘Activated Sludge Treatment’ lists the following parameters for activated sludge plants:- Treatment ModeSludge Loadingkg BOD/kg MLSS.

  • This gives the following results: - Table 5.3 – Daily BOD Load (kg/d) Averaged Over a Week at Bellozanne STW The minimum load of 1,171 kg/d observed in 2010 occurs in August and is low as a result of 2 data points that are substantially lower than the other samples taken over the summer months.

  • The court noted that the constitution showed a clear intention that this object was exclusively charitable but went on to say: 2 [1961] NZLR 405, 407.3 [1932] 2 KB 465.4 [1931] 2 KB 465, 481.5 [1961] NZLR 405, 408.6 (1980) 55 TC 651.

  • J.P. Singh, S.K. Singh, Shakun, Yadav, P.K. 1993, Assessment of BOD Load in river Yamuna in respect to Potable water at Agra.

  • The movement from size band 6 to 5 reflects a significant reduction in PE (30717 to 17350) and resultant reduction in the average daily BOD Load from 1843 Kg/d to 1041 Kg/d, which is less than the 1500 kg/d BOD required for Band 6.

  • BOD Load = 240 kg BOD/dMLSS = 3,500 mg/LDesign F/M Ratio = 0.1 kg BOD/kg MLSS Cycle Times:Fill = 4 hAerate = 2 hSettle = 1 h Decant = 1 h (including wasting) TOTAL = 8 h/CycleNo. of Cycles /Tank = 3 Cycles/Tank.dTotal No. Cycles = 3 Cycles/Tank.d x 3 no.

Related to BOD Load

  • Front-end Load means the Sales load which may be included in the offering price of the Units; provided however that different levels of Front-end Load may be applied to different investors, as determined by the Management Company. However aggregate of Front-end Load and Back-end Load should not exceed 3% of Net Asset Value.

  • Manual Load Dump Warning means a notification from PJM to warn Members of an increasingly critical condition of present operations that may require manually shedding load.

  • Back-end Load means the charge deducted from the Net Asset Value in determining the Redemption Price; provided however that different levels of Back-end Load may be applied to different classes of Units, as specified in this document.

  • Unfit-for-use tank system means a tank system that has been determined through an integrity assessment or other inspection to be no longer capable of storing or treating hazardous waste without posing a threat of release of hazardous waste to the environment.

  • Modular building manufacturer means a person or corporation who owns or operates a

  • Potential electrical output capacity means, with regard to a unit, 33 per- cent of the maximum design heat input of the unit.

  • Available Flowgate Capability or “AFC” shall mean the rating of the applicable Flowgate less the projected loading across the applicable Flowgate less TRM and CBM. The firm AFC is calculated with only the appropriate Firm Transmission Service reservations (or interchange schedules) in the model, including recognition of all roll-over Transmission Service rights. Non- firm AFC is determined with appropriate firm and non-firm reservations (or interchange schedules) modeled.

  • Capacity Export Transmission Customer means a customer taking point to point transmission service under Tariff, Part II to export capacity from a generation resource located in the PJM Region that has qualified for an exception to the RPM must-offer requirement as described in Tariff, Attachment DD, section 6.6(g).

  • INTER-CONNECTION POINT/ DELIVERY/ METERING POINT means a single point at 220kV or above, where the power from the Project(s) is injected into the identified ISTS Substation (including the dedicated transmission line connecting the Projects with the substation system) as specified in the RfS document. Metering shall be done at this interconnection point where the power is injected into. For interconnection with grid and metering, the WPDs shall abide by the relevant CERC/ SERC Regulations, Grid Code and Central Electricity Authority (Installation and Operation of Meters) Regulations, 2006 as amended and revised from time to time.

  • Available RP Capacity Amount means (i) the amount of Restricted Payments that may be made at the time of determination pursuant to Sections 7.06(d), (g), (h) and (l) minus (ii) the sum of the amount of the Available RP Capacity Amount utilized by the Borrower or any Restricted Subsidiary to (A) make Restricted Payments in reliance on Sections 7.06 (g), (h) or (l), (B) incur Liens pursuant to Section 7.01(bb), (C) make Investments pursuant to Section 7.02(n), (D) incur Indebtedness pursuant to Section 7.03(y) and (E) make prepayments, redemptions, purchases, defeasances and other payments in respect of Junior Financings prior to their scheduled maturity utilizing the Available RP Capacity Amount pursuant to Section 7.13 plus (iii) the aggregate principal amount of Indebtedness prepaid prior to or substantially concurrently at such time, solely to the extent such Indebtedness (A) was secured by Liens pursuant to Section 7.01(bb) or (B) was incurred pursuant to Section 7.03(y) and not secured pursuant to Section 7.01(bb) (it being understood that the amount under this clause (iii) shall only be available for use under Sections 7.01(bb) and/or 7.03(y), as applicable).

  • Slug loading means any pollutant, including oxygen demanding pollutants, released in a discharge at a flow rate and/or pollutant concentration as to cause interference in the POTW.

  • Unmetered Load means electricity consumed on the Network that is not directly recorded using Metering Equipment, but is calculated or estimated in accordance with the Code;

  • Load means energy consumed by Customers together with allocated losses and unaccounted for energy;

  • Manual Load Dump Action means an Operating Instruction, as defined by NERC, from PJM to shed firm load when the PJM Region cannot provide adequate capacity to meet the PJM Region’s load and tie schedules, or to alleviate critically overloaded transmission lines or other equipment.

  • Interconnection Feasibility Study means either a Generation Interconnection Feasibility Study or Transmission Interconnection Feasibility Study.

  • PJM Region Peak Load Forecast means the peak load forecast used by the Office of the Interconnection in determining the PJM Region Reliability Requirement, and shall be determined on both a preliminary and final basis as set forth in Tariff, Attachment DD, section 5.

  • Generation Interconnection Feasibility Study means a study conducted by the Transmission Provider (in coordination with the affected Transmission Owner(s)) in accordance with Tariff, Part IV, section 36.

  • Planned Financed Generation Capacity Resource means a Planned Generation Capacity Resource that, prior to August 7, 2015, has an effective Interconnection Service Agreement and has submitted to the Office of the Interconnection the appropriate certification attesting achievement of Financial Close.

  • Planned External Financed Generation Capacity Resource means a Planned External Generation Capacity Resource that, prior to August 7, 2015, has an effective agreement that is the equivalent of an Interconnection Service Agreement, has submitted to the Office of the Interconnection the appropriate certification attesting achievement of Financial Close, and has secured at least 50 percent of the MWs of firm transmission service required to qualify such resource under the deliverability requirements of the Reliability Assurance Agreement.

  • Interconnection Customer means a Generation Interconnection Customer and/or a Transmission Interconnection Customer.

  • Generation Interconnection Customer means an entity that submits an Interconnection Request to interconnect a new generation facility or to increase the capacity of an existing generation facility interconnected with the Transmission System in the PJM Region.

  • Applicable Registry Operators means, collectively, the registry operators of top-­‐level domains party to a registry agreement that contains a provision similar to this Section 7.6, including Registry Operator.

  • Inter-connection Point means interface point of renewable energy generating facility with the transmission system or distribution system, as the case may be:

  • Designated reception site means the designated place for the reception, staging, integration, and onward movement of contractors deploying during a contingency. The designated reception site includes assigned joint reception centers and other Service or private reception sites.

  • Bulk gasoline plant means a gasoline storage and distribution facility with an average daily throughput of 20,000 gallons (76,000 liters) of gasoline or less on a 30-day rolling average.

  • Net Load means the difference between the load of a given substance as calculated from a sample taken of the discharge and the load of the same substance in a sample taken at the intake which supplies water to given process. For purposes of this definition, samples that are taken to determine the net loading shall always be 24-hour composite samples made up of at least six increments taken at regular intervals throughout the plant day.