Continuous Inspection definition

Continuous Inspection means the full-time observation of work requiring special inspection by a Project Inspector who is continuously present in the area where the work is being performed.
Sample 1Sample 2Sample 3

Examples of Continuous Inspection in a sentence

  • Continuous Inspection of Workmanship: Describe process for continuous inspection during construction to identify and correct deficiencies in workmanship in addition to testing and inspection specified.

  • However, at no time can there be less than 4 Full Time Construction Inspectors provided during any secondary or multiple shift time period.4. Additional Staffing Requirements: The Design Builder is expected to balance the inspection needs with its schedule of simultaneous operations paying particular attention to the Continuous Inspection demands vs.

  • However, at no time can there be less than 2 Full Time Construction Inspectors provided during any secondary or multiple shift time period.4. Additional Staffing Requirements: The Design Builder is expected to balance the inspection needs with its schedule of simultaneous operations paying particular attention to the Continuous Inspection demands vs.

  • The Design Builder is expected to balance the inspection needs with its schedule of simultaneous operations paying particular attention to the Continuous Inspection demands vs.

  • The results from SDG 7 (equation 2) suggests that all the SDGs (except SDG9) are significant causal factors.

  • Inspection means complete and timely inspection of the work on either a Continuous Inspection or Periodic Inspection basis as determined in the Inspection Plan and periodic consultation with the Architect, the Project Manager, and the Construction Manager charged with the administration of the construction of the Project.

  • Contractor may elect to offer product under (1) Continuous Inspection or (2) Lot Inspection.

  • Continuous Inspection can be used to examine debt and monitor whether it has an impact.

  • In the event the DB elects to perform work in Secondary or Multiple shifts, the operations occurring during the secondary or multiple shift shall be staffed at the same staffing level pattern as the primary shift operations.4. Additional Staffing Requirements: The Design Builder is expected to balance the inspection needs with its schedule of simultaneous operations paying particular attention to the Continuous Inspection demands vs.

  • The process of Continuous Inspection can reveal parts of the architecture with deficiencies that need attention.

Related to Continuous Inspection

  • Continuous emission monitoring system or "CEMS" means the equipment required under section 11 of this rule to sample, analyze, measure, and provide, by means of readings recorded at least once every fifteen (15) minutes, using an automated data acquisition and handling system (DAHS), a permanent record of nitrogen oxides emissions, stack gas volumetric flow rate, stack gas moisture content, and oxygen or carbon dioxide concentration, as applicable, in a manner consistent with 40 CFR 75*. The following systems are the principal types of continuous emission monitoring systems required under section 11 of this rule:

  • Continuous parameter monitoring system or "CPMS" means all of the equipment necessary to meet the data acquisition and availability requirements of this chapter, to monitor process and control device operational parameters (for example, control device secondary voltages and electric currents) and other information (for example, gas flow rate, oxygen or carbon dioxide concentrations), and to record average operational parameter value on a continuous basis.

  • Continuous emissions monitoring system or “CEMS” means all of the equipment that may be required to meet the data acquisition and availability requirements of this chapter, to sample, to condition (if applicable), to analyze, and to provide a record of emissions on a continuous basis.

  • Continuous emissions rate monitoring system or “CERMS” means the total equipment required for the determination and recording of the pollutant mass emissions rate (in terms of mass per unit of time).

  • Inspection means activities such as measuring, examining, testing, gauging one or more characteristics of the product or service and comparing the same with the specified requirement to determine conformity.

  • Permanent Work means the permanent works including equipment to be supplied, executed, erected and maintained in accordance with the Contract.

  • The Completion Date means the date of completion of the Works as certified by the Employer’s Representative.

  • Completion Date means the date of completion of the Services by the Service Provider as certified by the Procuring Entity