We use cookies on our site to analyze traffic, enhance your experience, and provide you with tailored content.

For more information visit our privacy policy.

DS0 definition

DS0 means the 64 Kbps zero-level signal in the time-division multiplex hierarchy.
DS0 means the 64 Kbps zero-level signal in the time-division multiplex hierarchy. 3.16 "Digital Signal Level 1" or "DS1" means the 1.544 Mbps first-level signal in the time-division multiplex hierarchy. In the time-division multiplexing hierarchy of the telephone network, DS1 is the initial level of multiplexing. 3.17 "Digital Signal Level 3" or "DS3" means the 44.736 Mbps third-level in the time-division multiplex hierarchy. In the time-division multiplexing hierarchy of the telephone network, DS3 is defined as the third level of multiplexing. 3.18 "Exchange Message Record" or "EMR" is the standard used for exchange of telecommunications message information between telecommunications providers for billable, non-billable, sample, settlement and study data. EMR format is contained in BR-010-200-010 XXXX Exchange Message Record, a
DS0 means a Digital Signal Zero, which is a circuit with a bandwidth of 64 kilobits per second, which is the capacity necessary to carry a single voice conversation. "DS1" shall mean Digital Signal One, which is a circuit with a bandwidth of 1.544 megabits per second, roughly 24 times that of DS-0. A DS-1 is also known as a T-1.

Examples of DS0 in a sentence

  • When referring to digital Voice Grade service (a 56-64 kbps channel), the terms "DS0" or "sub-DS1" may also be used.

  • There shall be a DS1 or higher rate transport interface at each of the SPOIs. Each signaling link shall appear as a DS0 channel within the DS1 or higher rate interface.

  • Also, if either Party has provided or ordered a DS1 Entrance Facility or private line facility, that Party will be responsible for identification of the DS0 channels of the DS1 private line to be used to provide CFA.

  • DTT facilities are provided as dedicated DS3, DS1 or DS0 facilities.

  • Each signaling link shall appear as a DS0 channel within the DS1 or higher rate interface.

  • Grandfathered DS0 UNE Loops will be provided at the rates that apply under this Agreement through February 7, 2024.

  • After such date, Verizon will no longer provide or maintain any DS0 UNE Loop in any Urbanized Census Block.

  • New purchases of DS0 UNE Loops may be made for installations occurring through February 7, 2023.

  • Grandfathered DS0 UNE Loops purchased before February 7, 2023 will continue to be provisioned through February 7, 2025.

  • A DS0-, DS1-, or DS3-capacity transmission facility between Verizon switches (as identified in the LERG) or UNE Wire Centers, within a LATA, that is dedicated to a particular end user or carrier.


More Definitions of DS0

DS0 means the 64 Kbps zero-level signal in the time-division multiplex hierarchy. 3.16 "Digital Signal Level 1" or "DS1" means the 1.544 Mbps first-level signal in the time-division multiplex hierarchy. In the time-division multiplexing hierarchy of the telephone network, DS1 is the initial level of multiplexing.
DS0 means a Digital Signal Zero, which is a circuit with a bandwidth of 64 kilobits per second, which is the capacity necessary to carry a single voice conversation.

Related to DS0

  • DS-1 A service having an absolute digital signal speed of 1.544 Mbps. DS-3: A service having an absolute digital signal speed of 44.736 Mbps. Duct: A pipe, tube or conduit through which cables or wires are passed. Dynamic 911: The provision of E911 service utilizing a call processing arrangement with pseudo ANIs for non call-path associated signaling and routing commonly associated with the delivery of mobile, nomadic or out-of-region calls.

  • IXC means a Carrier that provides InterLATA or IntraLATA Toll services.

  • Digital Signal Level 0 (DS-0 means the lowest-level signal in the time division multiplex digital hierarchy, and represents a voice-grade channel operating at either the 56 Kbps or 64 Kbps transmission bit rates. There are twenty-four (24) DS-0 channels in a DS-1.

  • Digital Signal Level 3 (DS-3 means the 44.736 Mbps third level signal in the time division multiplex hierarchy.

  • PNode has the meaning set forth in the CAISO Tariff.

  • PSTN means the public switched telephone network.

  • Level 4 means a project of greater than 550 kWac and not more than 1 MWac.

  • Level 2 means a charging system that provides charging through a two-hundred- eight to two-hundred-forty volt AC plug with a cord connector that meets the SAE international J1772 standard or a successor standard.

  • Digital Signal Level 1 (DS-1 means the 1.544 Mbps first level signal in the time division multiplex hierarchy.

  • Level 2 Support means, with the use of technical support specialists: (i) performing Defect isolation, Defect replication and interoperability testing; (ii) performing remote diagnostic services and on-site troubleshooting, if required; (iii) identifying the source of Defects; (iv) developing a reproducible test case for any Defect and documenting the details of such Defect for escalation to Level 3 Support; and (v) developing and implementing Workarounds where reasonably possible.

  • Level 3 Support means, with the use of backup engineering and technical support staff, isolating Defects and developing Defect corrections including, without limitation, Upgrades.

  • Headend means any facility for signal reception and dissemination on a Cable System, including cables, antennas, wires, satellite dishes, monitors, switchers, modulators, processors for Broadcast Signals, equipment for the Interconnection of the Cable System with adjacent Cable Systems and Interconnection of any networks which are part of the Cable System, and all other related equipment and facilities.

  • Digital Signal Level 0 or "DS0" means the 64 Kbps zero-level signal in the time-division multiplex hierarchy.

  • CDSL means Central Depository Services (India) Ltd.

  • Ethernet means a family of computer networking technologies for LANs.

  • OPD treatment means the one in which the Insured visits a clinic / hospital or associated facility like a consultation room for diagnosis and treatment based on the advice of a Medical Practitioner. The Insured is not admitted as a day care or in-patient.

  • TARGET2 System means the Trans-European Automated Real-Time Gross Settlement Express Transfer (TARGET2) system or any successor thereto.

  • Level 5 means a project of greater than 2 MWac.

  • Keyboard access Can users access all functions and content, and complete all tasks, independently by using only the keyboard (<tab>, <enter>, <spacebar>, <esc>, and arrow keys)? Verify in particular: o There are no keyboard traps that would prevent a user from advancing through the entire page, such as an automatically-refreshing social media embedded feed (tip: try to tab very, very slowly through any such feed to observe whether a user can close it, or move past it, at a reasonable point; if the feed keeps refreshing by automatically adding additional entries to be shown, it causes a trap for those who are unable to use quick keyboard strokes – or a mouse - to navigate);

  • Behavior Support Plan means the individualized proactive support strategies used to support positive behavior.

  • CPD means verifiable continuing professional development, as described in the General Dental Council's publication of April 2000, "Lifelong Learning – Taking Dentistry Forward", and may include attendance at approved postgraduate education courses but does not include any quality improvement activities within the meaning of paragraph 40 of Schedule 1 to the National Health Service (General Dental Services) (Scotland) Regulations 2010 in respect of which he is claiming an allowance in accordance with Determination XI of this Statement;

  • kVA means kilovolt-ampere or kilovolt-amperes;

  • SDR means Special Drawing Rights as defined by the International Monetary Fund.

  • Continuing treatment means ongoing medical treatment or supervision by a health care provider.

  • Diameter means the diameter of the stem of a tree measured outside the bark at a specified point of measurement.

  • Connector means a flanged, screwed, welded, or other joined fitting used to connect two pipelines or a pipeline and a piece of process equipment.