Electrical Output Test definition

Electrical Output Test means the tests conducted in accordance with the procedures developed pursuant to the guidelines set forth in Exhibit D-3.
Sample 1Sample 2Sample 3

Examples of Electrical Output Test in a sentence

  • The Net Unit Electrical Output Test for the Unit shall be conducted in general compliance with Power Test Code 46 (PTC-46) with the NSSS power no less than [**] of rated power measured using the Secondary Calorimetric Methodology and for the periods and duration discussed below.

  • Concurrent with the input/output Performance Test and Net Equipment Maximum Electrical Output Test, measurements shall be taken as required to allow calculation of Component performance for the gas turbines.

  • Except as provided in section 13.02(3) of this revenue procedure, a taxpayer that files a Form 3115 under this revenue procedure on or before December 31, 1997, may apply the terms and conditions (exclusive of the year of change) in Rev.

  • In accordance with APP-GW-T1R-600, (AP1000 Performance Test Requirements and Bases), the Performance Tests [***] shall consist of the following tests: (i) Net Unit Electrical Output Test, (referred to as the Turbine Generator Output Test in APP-GW-T1R-600), (ii) Moisture Carryover Test, and (iii) the Cooling Tower Performance Test.

  • The Net Unit Electrical Output Test for the Unit shall be conducted in general compliance with Power Test Code 46 (PTC-46) with the NSSS power no less than 99.5% of rated power measured using the Secondary Calorimetric Methodology and for the periods and duration discussed below.

  • The Net Unit Electrical Output Test shall consist of at least four (4) test runs of a minimum of two (2) hours in duration per test run.

  • In the event that the Net Unit Electric Output, as determined by the Net Unit Electrical Output Test, exceeds the Net Unit Electrical Output Guarantee, then Contractor shall be entitled to receive as a bonus an amount equal to [***].

  • The Net Unit Electrical Output Test for the Unit shall be determined during a period of continuous operation of one hundred (100) hours.

  • Subject to the limits of liability set forth in Section 13.3 and subject to the provisions of this Agreement and in accordance with the Operating Procedures and Maintenance Procedures and Facility Manuals, Contractor guarantees that a Unit, when loaded with the Nuclear Fuel, shall produce a Net Unit Electrical Output of [***] MWe as evidenced by the Net Unit Electrical Output Test (the “Net Unit Electrical Output Guarantee”).

  • The Net Unit Electrical Output Test for each Unit shall be conducted in material compliance with Power Test Code 46 (PTC-46) with the Net Unit Electrical Output [***] for the periods and duration described in this Section 11.5(d)(i).

Related to Electrical Output Test

  • Electrical work Means any labor or material used in installing, altering, maintaining, or extending an electrical wiring system and the appurtenances, apparatus, or equipment used in connection with the use of electrical energy in, on, outside, or attached to a building, residence, structure, property, or premises. The term includes service entrance conductors as defined by the National Electrical Code.

  • Potential electrical output capacity means, with regard to a unit, 33 per- cent of the maximum design heat input of the unit.

  • Electrical Distance means, for a Generation Capacity Resource geographically located outside the metered boundaries of the PJM Region, the measure of distance, based on impedance and in accordance with the PJM Manuals, from the Generation Capacity Resource to the PJM Region.

  • Finished water means the water that is introduced into the distribution system of a public water system and is intended for distribution and consumption without further treatment, except as treatment necessary to maintain water quality in the distribution system (e.g., booster disinfection, addition of corrosion control chemicals).

  • voltage means the root-mean-square value of electrical potential between two conductors.

  • low voltage means the set of nominal voltage levels that are used for the distribution of electricity and whose upper limit is generally accepted to be an a.c. voltage of 1000V ( or a d.c. voltage of 1500 V). [SANS 1019]

  • Generator Maintenance Outage means the scheduled removal from service, in whole or in part, of a generating unit in order to perform necessary repairs on specific components of the facility, if removal of the facility meets the guidelines specified in the PJM Manuals.

  • design pressure means the maximum pressure that a pressure vessel or plant is designed to withstand safety when operating normally;

  • Output means the exposure rate, dose rate, or a quantity related in a known manner to these rates from a brachytherapy source or a teletherapy, remote afterloader, or gamma stereotactic radiosurgery unit for a specified set of exposure conditions.

  • Generator Planned Outage means the scheduled removal from service, in whole or in part, of a generating unit for inspection, maintenance or repair with the approval of the Office of the Interconnection in accordance with the PJM Manuals.

  • Generator Forced Outage means an immediate reduction in output or capacity or removal from service, in whole or in part, of a generating unit by reason of an Emergency or threatened Emergency, unanticipated failure, or other cause beyond the control of the owner or operator of the facility, as specified in the relevant portions of the PJM Manuals. A reduction in output or removal from service of a generating unit in response to changes in market conditions shall not constitute a Generator Forced Outage.

  • DNS test Means one non-­‐recursive DNS query sent to a particular “IP address” (via UDP or TCP). If DNSSEC is offered in the queried DNS zone, for a query to be considered answered, the signatures must be positively verified against a corresponding DS record published in the parent zone or, if the parent is not signed, against a statically configured Trust Anchor. The answer to the query must contain the corresponding information from the Registry System, otherwise the query will be considered unanswered. A query with a “DNS resolution RTT” 5 times higher than the corresponding SLR, will be considered unanswered. The possible results to a DNS test are: a number in milliseconds corresponding to the “DNS resolution RTT” or, undefined/unanswered.

  • Subproject means a specific project to be carried out by an existing BE utilizing the proceeds of a Sub-loan or Investment, as hereinafter defined, fulfilling the conditions set forth in Part A of Schedule 4 to this Agreement;

  • Used water means any water supplied by a public water supply system to a consumer's water system after it has passed through the service connection and is no longer under the control of the water supply official custodian.

  • Outputs means the goods or services that are produced by an entity or other person;

  • Electrical Fitter means an employee who is mainly employed in the workshops manufacturing, fitting, and repairing electrical instruments, machines, and apparatus. Electrical fitting in this definition shall include armature and transformer winding, and people solely engaged in making and repairing instruments. The legitimate possession of a certificate of competency in this particular class of work issued by the Electrical Licensing Board under the Electricity Act 1994 shall be recognised as proof of efficiency.

  • Electrical equipment means underground equipment that contains dielectric fluid that is necessary for the operation of equipment such as transformers and buried electrical cable.

  • Biomass means the biodegradable fraction of products, waste and residues from biological origin from agriculture (including vegetal and animal substances), forestry and related industries including fisheries and aquaculture, as well as the biodegradable fraction of industrial and municipal waste;

  • Cannabis testing facility means an entity registered by

  • Bulk gasoline plant means a gasoline storage and distribution facility with an average daily throughput of 20,000 gallons (76,000 liters) of gasoline or less on a 30-day rolling average.

  • medium voltage means the set of nominal voltage levels that lie above low voltage and below high voltage in the range of 1 kV < Un 44 kV. [SANS 1019]

  • Fuel system means the components which store or transport fuel on board the vehicle and comprise the fuel tank system, all fuel and vapour lines, any non-tank mounted fuel pumps and the activated carbon canister.

  • high voltage means the classification of an electric component or circuit, if its working voltage is > 60 V and ≤ 1500 V DC or > 30 V and ≤ 1000 V AC root mean square (rms).

  • Calibration gas means a gas mixture used to calibrate gas analysers.

  • Forced Outage means any unplanned reduction or suspension of the electrical output from the Facility resulting in the unavailability of the Facility, in whole or in part, in response to a mechanical, electrical, or hydraulic control system trip or operator-initiated trip in response to an alarm or equipment malfunction and any other unavailability of the Facility for operation, in whole or in part, for maintenance or repair that is not a scheduled maintenance outage and not the result of Force Majeure.

  • Bottled water means water that is placed in a safety sealed container or package for human 696 consumption. Bottled water is calorie free and does not contain sweeteners or other additives except 697 that it may contain: (i) antimicrobial agents; (ii) fluoride; (iii) carbonation; (iv) vitamins, minerals, and 698 electrolytes; (v) oxygen; (vi) preservatives; and (vii) only those flavors, extracts, or essences derived 699 from a spice or fruit. "Bottled water" includes water that is delivered to the buyer in a reusable 700 container that is not sold with the water.