Fog test definition

Fog test means an evaluation of increased density and reduced contrast on film which has not been exposed to the radiation field. This is usually done by processing unexposed film and measuring the density.
Sample 1Sample 2Sample 3
Fog test means an evaluation of increased density and reduced contrast on film, which has not been exposed to the radiation field. This is usually done by processing unexposed
Sample 1

Examples of Fog test in a sentence

  • Influence of the weathering conditions on the acid etch resistance of PC-4(colour and surface image after 168 days of pre-weathering plus 5 ADF cycles in comparison to an un-weathered specimens after 5 ADF cycles) The Acid Dew and Fog test (ADF test in short) as described by Schulz (1999) was used to determine this material property.

  • Mr. Moustafa told Mr. Hale that Edgetech IG’s Toronto representative (Andrew Moore) told him he wanted to send them Edgetech IG Silicone Super Spacer® so that they would pass the Volatile Fog test (even though they use EPDM for their production).

  • Buyer receiving sites must be compliant with UK Health and Safety law and all applicable regulations.

  • The mean result for the STs is 12.1, and that for the TTs 9.7, a difference of2.4. According to the information on how to evaluate Gunning Fog test results (see section 2.2.2), the mean result for the STs suggested that these texts are very difficult to read, as they generated a result above 12.

  • Similarly, the network output is lower on the Fog test events, which gives us stronger reduction factor.

  • Verify the operation for all power levels prior to conducting the Salt Fog test.

  • For example, the nonzero element 1 in a set covering problem is stored only once using the mult attribute.

  • Test Data: Test data will consist of log sheets showing the chamber temperature, Salt concentration, test start date, serial numbers, inspection report, and the Salt Fog test data record.

  • The section below presents the results of each test of the AUPs in chart form.Figure 1 presents the result from the Flesch Reading Ease test, Figure 2 presents the results of the Gunning Fog test, Figure 3 presents the results of the SMOG test, and Figure 4 presents the results of the Coleman-Liau test.

  • Verification of the appropriate processing solutions as described in 21 CFR 900.12(b)(13).It is also recommended that the medical physicist conduct the Darkroom Fog test if the integrity of the darkroom is compromised and conduct the fixer retention analysis test, if deemed necessary.

Related to Fog test

  • RDDS test Means one query sent to a particular “IP address” of one of the servers of one of the RDDS services. Queries shall be about existing objects in the Registry System and the responses must contain the corresponding information otherwise the query will be considered unanswered. Queries with an RTT 5 times higher than the corresponding SLR will be considered as unanswered. The possible results to an RDDS test are: a number in milliseconds corresponding to the RTT or undefined/unanswered.

  • DNS test Means one non-­‐recursive DNS query sent to a particular “IP address” (via UDP or TCP). If DNSSEC is offered in the queried DNS zone, for a query to be considered answered, the signatures must be positively verified against a corresponding DS record published in the parent zone or, if the parent is not signed, against a statically configured Trust Anchor. The answer to the query must contain the corresponding information from the Registry System, otherwise the query will be considered unanswered. A query with a “DNS resolution RTT” 5 times higher than the corresponding SLR, will be considered unanswered. The possible results to a DNS test are: a number in milliseconds corresponding to the “DNS resolution RTT” or, undefined/unanswered.

  • Drug test means a test designed to detect the illegal use of a controlled substance.

  • COVID-19 test means a viral test for SARS-CoV-2 that is:

  • EPP test Means one EPP command sent to a particular “IP address” for one of the EPP servers. Query and transform commands, with the exception of “create”, shall be about existing objects in the Registry System. The response shall include appropriate data from the Registry System. The possible results to an EPP test are: a number in milliseconds corresponding to the “EPP command RTT” or undefined/unanswered.

  • Fit test means the use of a protocol to qualitatively or quantitatively evaluate the fit of a respirator on an individual.

  • Screening Test means a drug or alcohol test which uses a method of analysis allowed by the Minnesota Drug and Alcohol Testing in the Workplace Act to be used for such purposes.

  • Percolation test means a subsurface soil test at the depth of a proposed absorption system or similar component of an OWTS to determine the water absorption capability of the soil, the results of which are normally expressed as the rate at which one inch of water is absorbed. The rate is expressed in minutes per inch.

  • Commissioning test means tests applied to the Generating Facility, after completion of the construction of the Generating Facility, in order to verify that the Generating Facility may be released for Operation.

  • Asset Test means, for an Asset Review, each Test, as defined in the Asset Representations Review Agreement, in Schedule A to the Asset Representations Review Agreement to be performed by the Asset Representations Reviewer on the related Asset Review Receivables.

  • Performance Test means all operational checks and tests required to determine the performance parameters including inter-alia capacity, efficiency and operating characteristics of the Stores as specified in the Contract.

  • Incurrence Test means the incurrence test set out in Clause 12.1 (Incurrence Test).

  • Drug use test means a scientifically substantiated method to test for the presence of illegal or performance-enhancing drugs or the metabolites thereof in a person’s urine.

  • Start-Up Testing means the completion of applicable required factory and start-up tests as set forth in Exhibit C.

  • Acceptance Test is a test of the Features executed by the Customer to prepare the acceptance.

  • Plant Test Date or "PTD" means the date acceptance testing is performed with CLEC. "Point of Interface", "Point of Interconnection," or "POI" is a demarcation between the networks of two (2) LECs (including a LEC and CLEC). The POI is that point where the exchange of traffic takes place.

  • Operational Acceptance Tests means the tests specified in the Technical Requirements and Agreed Project Plan to be carried out to ascertain whether the System, or a specified Sub system, is able to attain the functional and performance requirements specified in the Technical Requirements and Agreed Project Plan, in accordance with the provisions of GCC Clause 27.2 (Operational Acceptance Test).

  • Witness Test means the Company’s right to witness the commissioning testing and/or Company-required Interconnecting Customer-owned communication system. Commissioning testing is defined in IEEE Standard 1547-2003.

  • Coverage Test means each of the Class A/B Par Value Test, the Class A/B Interest Coverage Test, the Class C Par Value Test, the Class C Interest Coverage Test, the Class D Par Value Test, the Class D Interest Coverage Test, the Class E Par Value Test and the Class E Interest Coverage Test.

  • Genetic test means an analysis of human DNA, RNA, chromosomes, proteins, or metabolites, that detect genotypes, mutations, or chromosomal changes. The term “genetic test” does not mean an analysis of proteins or metabolites that does not detect genotypes, mutations, or chromosomal changes; or an analysis of proteins or metabolites that is directly related to a manifested disease, disorder, or pathological condition that could reasonably be detected by a health care professional with appropriate training and expertise in the field of medicine involved.

  • Acceptance Testing mean the tests, reviews and other activities that are performed by or on behalf of Agency to determine whether the Deliverables meet the Acceptance Criteria or otherwise satisfy the Agency, as determined by the Agency in its sole discretion.

  • Cannabis testing facility means an entity registered by

  • Maintenance Test means the maintenance test set out in Clause 12.1 (Maintenance Test).

  • LCT Test Date shall have the meaning provided in Section 1.12(b).

  • Test means such test as is prescribed by the particulars or considered necessary by the Inspecting Officer whether performed or made by the Inspecting Officer or any agency acting under the direction of the Inspecting Officer;

  • Performance Tests means the tests to be conducted on the equipment at site for checking the performance parameters of the equipment as defined in Technical Specification.