Gas Analysis Equipment definition

Gas Analysis Equipment means the measurement equipment for measuring quality of gas installed at the Interconnection Point as shown in Appendix 1.
Sample 1Sample 2Sample 3
Gas Analysis Equipment means the measurement equipment for measuring quality of gas to be installed in respect of the SCP as shown in Annex A;
Sample 1

Examples of Gas Analysis Equipment in a sentence

  • However, hydrocarbons heavier than butane should not be calculated from the butane content alone and so the Gas Analysis Equipment must allow the responses of hydrocarbons heavier than butane, with the Standard Gas also containing appropriate amounts of the heavier hydrocarbons.

  • The Gross Calorific Value of the gas offtaken from or delivered to the National Grid Gas System at the Interconnection Point shall be determined by the Gas Analysis Equipment.

  • The accuracy of the Primary Meters, Xxxx’x Xxxx Meters and Gas Analysis Equipment is described in Table 1.

  • The on-stream Gas Analysis Equipment shall be calibrated in accordance with the approved validation procedures at appropriate intervals with Standard Gas prepared by gravimetric means or traceable by recognised procedure to an appropriate gravimetrically prepared standard mixture and containing, as a minimum, nitrogen, carbon dioxide, methane, ethane, propane and butane.

  • Where an Operator proposes to modify the Primary Meters and/or Gas Analysis Equipment, the provisions of clause 9 (Modification and inspection of Connection Facilities) shall apply.

  • National Grid Gas shall have the right, upon giving reasonable notice to IUK, to inspect IUK’s measurement equipment and the charts and other measurements or test data, but the reading calibration and adjustment of the Primary Meters and/or Gas Analysis Equipment and the changing of any charts shall be carried out by IUK who shall preserve all original test data, charts and other similar records for a period of three (3) years and shall make a copy thereof available to National Grid Gas upon request.

  • All affected persons who are identified in the subproject areas on the cut-off date will be entitled to compensation for their loss, and rehabilitation measures (as outlined in the entitlement matrix below) sufficient to assist them to improve or at least maintain their pre project living standards, income-earning capacity and production levels.

  • The accuracy of the Flow Measurement EquipmentPrimary Meters, Xxxx’x Xxxx Meters and Gas Analysis Equipment is described in Table 1.

  • The on-stream Gas Analysis Equipment shall be calibrated in accordance with ISO 10723 (or any replacement of ISO 10723) performance evaluationthe approved validation procedures at appropriate intervals with Standard Gas prepared by gravimetric means or traceable by recognised procedure to an appropriate gravimetrically prepared standard mixture and containing, as a minimum, nitrogen, carbon dioxide, methane, ethane, propane and butane.

  • Where an Operator proposes to modify the Flow Measurement EquipmentPrimary Meters and/or Gas Analysis Equipment, the provisions of clause 9 (Modification and inspection of Connection Facilities) shall apply.

Related to Gas Analysis Equipment

  • Cost Analysis means the evaluation of cost data for the purpose of arriving at estimates of costs to be incurred, prices to be paid, costs to be reimbursed, or costs actually incurred.

  • Interconnection Feasibility Study means either a Generation Interconnection Feasibility Study or Transmission Interconnection Feasibility Study.

  • risk analysis the analysis required under Rule 17f-7(a)(1)(i)(A).

  • Generation Interconnection Feasibility Study means a study conducted by the Transmission Provider (in coordination with the affected Transmission Owner(s)) in accordance with Tariff, Part IV, section 36.2.

  • Contractor’s Equipment means all apparatus, machinery, vehicles and other things required for the execution and completion of the Works and the remedying of any defects. However, Contractor’s Equipment excludes Temporary Works, Employer’s Equipment (if any), Plant, Materials and any other things intended to form or forming part of the Equipment.

  • The Works/Project means the works to be executed or done under this contract.

  • Manufacturing Facilities means facilities engaged in the mechanical or chemical transformation of materials or substances into new products and shall include:

  • Clean coal technology demonstration project means a project using funds appropriated under the heading “Department of Energy—Clean Coal Technology,” up to a total amount of $2,500,000,000 for commercial demonstration of clean coal technology, or similar projects funded through appropriations for the Environmental Protection Agency. The federal contribution for a qualifying project shall be at least 20 percent of the total cost of the demonstration project.

  • Spacecraft (9) means active and passive satellites and space probes.

  • Fluoroscopic imaging assembly means a subsystem in which X-ray photons produce a visual image. It includes the image receptor(s) such as the image intensifier and spot-film device, electrical interlocks, if any, and structural material providing linkage between the image receptor and diagnostic source assembly.

  • Manufacturing Facility means buildings and structures, including machinery and equipment, the primary purpose of which is or will be the manufacture of tangible goods or materials or the processing of such goods or materials by physical or chemical change.

  • technical specification means, with respect to any Software, the document setting forth the technical specifications for such Software and included in the Statement of Work.

  • Compression Ignition Engine means an internal combustion engine with operating characteristics significantly similar to the theoretical diesel combustion cycle. The regulation of power by controlling fuel supply in lieu of a throttle is indicative of a compression ignition engine.

  • Transboundary movement means any movement of hazardous wastes or other wastes from an area under the national jurisdiction of one State to or through an area under the national jurisdiction of another State or to or through an area not under the national jurisdiction of any State, provided at least two States are involved in the movement;

  • Forensic analysis means the practice of gathering, retaining, and analyzing computer-related data for investigative purposes in a manner that maintains the integrity of the data.

  • Technical Specifications means the detailed requirements for the Work furnished by the Architect and set forth in Book 3 of the Contract Documents.

  • Digital audio-visual work means a series of related images which, when shown in succession, imparts an impression of motion, together with accompanying sounds, if any.

  • Systems Engineering means preparing specifications, identifying and resolving interface problems, developing test requirements, evaluating test data, and supervising design.

  • Digital audio-visual works which means a series of related images which, when shown in succession, impart an impression of motion, together with accompanying sounds, if any;

  • Recalibration means the adjustment of all DRG weights to reflect changes in relative resource consumption.

  • Contractor Equipment means all appliances and things of whatsoever nature (other than temporary works) required for execution and completion of works and remedying of any defects, therein. But does not include plant, materials or other things intended to form or forming part of the permanent works.

  • Infrastructure Improvements means a street, road, sidewalk, parking facility, pedestrian mall, alley, bridge, sewer, sewage treatment plant, property designed to reduce, eliminate, or prevent the spread of identified soil or groundwater contamination, drainage system, waterway, waterline, water storage facility, rail line, utility line or pipeline, transit-oriented development, transit-oriented property, or other similar or related structure or improvement, together with necessary easements for the structure or improvement, owned or used by a public agency or functionally connected to similar or supporting property owned or used by a public agency, or designed and dedicated to use by, for the benefit of, or for the protection of the health, welfare, or safety of the public generally, whether or not used by a single business entity, provided that any road, street, or bridge shall be continuously open to public access and that other property shall be located in public easements or rights-of-way and sized to accommodate reasonably foreseeable development of eligible property in adjoining areas. Infrastructure improvements also include 1 or more of the following whether publicly or privately owned or operated or located on public or private property:

  • Comprehensive resource analysis means an analysis including,

  • Customer Premises Equipment or "CPE" means equipment employed on the premises of a Person other than a Carrier to originate, route or terminate Telecommunications (e.g., a telephone, PBX, modem pool, etc.).

  • MSAA Indicator Technical Specifications document means, as the context requires, either or both of the document entitled “Multi-Sector Service Accountability Agreement (MSAA) 2019-20 Indicator Technical Specifications November 5, 2018 Version 1.3” and the document entitled “Multi-Sector Service Accountability Agreement (MSAA) 2019-20 Target and Corridor-Setting Guidelines” as they may be amended or replaced from time to time;

  • Infrastructure improvement means permanent infrastructure that is essential for the public health and safety or that: