GAS FLOW definition

GAS FLOW means physical flow of NATURAL GAS through the GCP between EUGAL and the NET4GAS INFRASTRUCTURE.
GAS FLOW means a volume of Gas, in CM, that flows through the Connected Systems Point and that can be or has been measured by the Metering Station, being Forward Flow.

Examples of GAS FLOW in a sentence

  • AFTER SHUTTING OFF ALL GAS FLOW, THE PILOT BURNER CANNOT BE RELIT UNTIL THE THERMOCOUPLE HAS COOLED (60 SECONDS TO 2 MINUTES).

  • DO NOT INSTALL ON INLET SIDE.QUICK-DISCONNECT FEMALE FITTING.Flex Connector Do Not Install on Inlet Side.SHUT-OFF VALVE INSTALL ON INLET SIDE.FEMALECAPMALE CAPINSTALL ON INLET SIDE.FEMALE CAP MALE CAP DIRECTION OF GAS FLOW CROSSOVER MUST BE LISTED FOR EXTERIOR USE.

  • Introduction 23Process 23User Applications 23Recipient NTS Exit Point 24Investment Analysis 24Revision Analysis 25Analysis Output 26ANNEX 1: INDICATIVE GAS FLOW DIRECTION IN THE NTS FOR EACH LDZ.

  • OperationCAUTION: DO NOT FLOW ANY LIQUID THROUGH A GAS FLOW SENSOR.

  • A sample run time of six hours was chosen so that sufficient material would be collected to exceed detection limits.STACK GAS FLOW RATE, MOISTURE CONTENT AND MOLECULAR WEIGHTAn S-type Pitot tube (EPA Method 2) was used to determine the average stack gas velocity and volumetric flow rate.

  • Introduction 24Process 24User Applications 24Recipient NTS Exit Point 25Investment Analysis 25Revision Analysis 26Analysis Output 27ANNEX 1: INDICATIVE GAS FLOW DIRECTION IN THE NTS FOR EACH LDZ.

  • Typical flame spray gun GAS FLOW METERCOMPRESSED AIRAIR CONTROLPOWDER GUNF U E L G A SO X Y G E NFLUIDIZED BED HOPPERAIR CLEANER/DRYER Figure 2-4.

  • Specifications 5Country and usefulness gas categories 7Performance curves 10Pressure in the network / gas flow rate curves 11MOUNTINGS AND CONNECTIONS 13Packing 13Fitting the burner to the boiler 13Matching the burner to the boiler 13Installing the gas train 14ELECTRICAL CONNECTIONS 15Power supply without neutral 16ADJUSTING THE AIR AND GAS FLOW RATES 17Combustion head pressure curves vs.

  • Well status on Petrinex: SKSince gas royalties are based solely on monthly production volumes, GAS PUMP and GAS FLOW are not used.

  • AFTER SHUTTING OFF ALL GAS FLOW, THE PILOT BURNER CANNOT BE RELIT UNTIL THE THERMOCOUPLE HAS COOLED, ALLOWING THE ELECTROMAGNET TO BE RELEASED (APPROX.

Related to GAS FLOW

  • Bulk gasoline plant means a gasoline storage and distribution facility with an average daily throughput of 20,000 gallons (76,000 liters) of gasoline or less on a 30-day rolling average.

  • Landfill Gas means any gas derived through any biological process from the decomposition of waste buried within a waste disposal site.

  • Gas supply service means the provision to customers of the

  • Ultra Low Sulfur Diesel Fuel means diesel fuel that has a sulfur content of no more than fifteen parts per

  • State-certified production means a qualified production

  • Train Unloading Infrastructure means train unloading infrastructure reasonably required for the unloading of iron ore from the Railway to be processed, or blended with other iron ore, at processing or blending facilities in the vicinity of that train unloading infrastructure and with the resulting iron ore products then loaded on to the Railway for transport (directly or indirectly) to a loading port. Company to obtain prior Ministerial in-principle approval

  • Gas supplier means a person that is duly licensed pursuant to

  • Condensate means hydrocarbon liquid separated from natural gas which condenses due to changes in the temperature or pressure and remains liquid at standard conditions.

  • Production Burdens means any royalties (including lessor’s royalties), overriding royalties, production payments, net profit interests or other similar interests that constitute a burden on, and are measured by or are payable out of, the production of Hydrocarbons or the proceeds realized from the sale or other disposition thereof (including any amounts payable to publicly traded royalty trusts), but excluding Taxes and assessments of Governmental Entities.

  • generating plant means the generating facility described in Schedule 1 as amended from time to time;

  • Gas Transporter means the licensed operator of the transportation network through which gas is transported to you;

  • Electricity Supply Code means the Electricity Supply Code specified under section 50;

  • Available Flowgate Capability or “AFC” shall mean the rating of the applicable Flowgate less the projected loading across the applicable Flowgate less TRM and CBM. The firm AFC is calculated with only the appropriate Firm Transmission Service reservations (or interchange schedules) in the model, including recognition of all roll-over Transmission Service rights. Non- firm AFC is determined with appropriate firm and non-firm reservations (or interchange schedules) modeled.

  • Ethanol means a high octane gasoline blend stock that is used to make various grades of gasoline.

  • Dried flower means all dead cannabis that has been harvested, dried, cured, or otherwise processed, excluding leaves and stems.

  • LNG means liquefied natural gas.

  • Pipeline means any pipe, pipes, or pipelines used for the intrastate transportation or transmission of any solid, liquid, or gaseous substance, except water.

  • Feedstock Gas means natural gas used as a raw material for its chemical properties in creating an end product.

  • Liquefied natural gas or “LNG” means natural gas that has been liquefied.

  • Fuel Gas means Gas used as fuel for the operation of the Transportation System.

  • Basic gas supply service means gas supply service that is

  • Baseline concentration means that ambient concentration level that exists in the baseline area at the time of the applicable minor source baseline date. A baseline concentration is deter- mined for each pollutant for which a minor source baseline date is estab- lished and shall include:

  • Multi-purpose Lubricant means any lubricant designed for general purpose lubrication, or for use in a wide variety of applications. “Multi-purpose Lubricant” does not include “Multi-purpose Dry Lubricants”, “Penetrants”, or “Silicone-based Multi-purpose Lubricants”.

  • Cogeneration unit means a unit that is able to operate in cogeneration mode;

  • Electricity Supplier means any person authorised to supply electricity.

  • Cogeneration facility means a power plant in which the heat or steam is also used for industrial or commercial heating or cooling purposes and that meets Federal Energy Regulatory Commission standards for qualifying facilities under the Public Utility Regulatory Policies Act of 1978 (16