Idle test definition

Idle test means a single speed idle test as described in 40 CFR 51, Subpart S, Appendix B*.
Sample 1Sample 2Sample 3
Idle test means an exhaust emissions test conducted with the engine of the vehicle running at the manufacturer’s idle speed ± 100 RPM but without pressure exerted on the accelerator.
Sample 1Sample 2Sample 3
Idle test means an exhaust emissions test sampling and analysis performed while the vehicle engine is operating at or approximately at the vehicle manufacturer’s recommended normal curb idle speed. The idle test may involve conditioning the vehicle on a dynamometer at a vehicle drive-wheel speed of approximately thirty (30) miles per hour.
Sample 1Sample 2

Examples of Idle test in a sentence

  • For Notebook Computers, repeat the Short Idle test with the display brightness set to the closest setting that is at least 150 cd/m2.

  • For computers with external computer displays (most desktops): use the computer display power management settings to prevent the display from powering down to ensure it stays on for the full length of the Idle test as described below.

  • For Notebook Computers, repeat the Short Idle test with the display brightness set to the closest setting that is at least 150 cd/m2 for all displays.

  • The following tables define appli- cable ramped modal cycles for line- haul and switch locomotives:TABLE 1 TO § 1033.520—LINE-HAUL LOCOMOTIVE RAMPED MODAL CYCLERMC test intervalWeighting factorRMC modeTime in mode (seconds)Notch settingPre-test idle .......................................NANA600 to 900Lowest idle setting.1Interval 1 (Idle test) ...........................0.380A B600600Low Idle.2 Normal Idle.

  • The database contains vehicle and site identification information as well as Snap and Idle test results and visual inspection results.

  • A PCP is a defined step towards the completion of Work within a PC identified in the Schedule of Progress Check Points.

  • Idle test of all covered vehicles: Model years 1968 through 1980 for light duty vehicles and model years 1970 through 1980 for light duty trucks according to the requirements found in Appendix 6 (a).

  • If the vehicle isincompatible with the OBD test equipment or if the DLC is readilyunavailable, then the vehicle is subject to the Curb Idle test asspecified in Paragraph 1200-3-29-.05.(4) Pass/fail determination.

  • Short tests incorporating the re- start feature are the Engine restart 2500 rpm/Idle test—EPA 81 (§ 85.2210), Engine restart idle test—EPA 81 (§ 85.2211), Idle test—EPA 91 (§ 85.2213), Two speed idle test—EPA 91 (§ 85.2215), Preconditioned idle test—EPA 91 (§ 85.2218), Idle test with loaded pre- conditioning—EPA 91 (§ 85.2219), and Preconditioned two speed idle test— EPA 91 (§ 85.2220).

  • For computers with external computer displays (most desktops): use the computer display power management settings to prevent the display from powering down to ensure it stays on for the full length of the Idle test as described below.b.


More Definitions of Idle test

Idle test means an exhaust emissions test conducted with the engine of the vehicle run- ning at the manufacturer’s idle speed ± 100 RPM but without pressure exerted on the ac- celerator.
Sample 1

Related to Idle test

  • RDDS test Means one query sent to a particular “IP address” of one of the servers of one of the RDDS services. Queries shall be about existing objects in the Registry System and the responses must contain the corresponding information otherwise the query will be considered unanswered. Queries with an RTT 5 times higher than the corresponding SLR will be considered as unanswered. The possible results to an RDDS test are: a number in milliseconds corresponding to the RTT or undefined/unanswered.

  • DNS test Means one non-­‐recursive DNS query sent to a particular “IP address” (via UDP or TCP). If DNSSEC is offered in the queried DNS zone, for a query to be considered answered, the signatures must be positively verified against a corresponding DS record published in the parent zone or, if the parent is not signed, against a statically configured Trust Anchor. The answer to the query must contain the corresponding information from the Registry System, otherwise the query will be considered unanswered. A query with a “DNS resolution RTT” 5 times higher than the corresponding SLR, will be considered unanswered. The possible results to a DNS test are: a number in milliseconds corresponding to the “DNS resolution RTT” or, undefined/unanswered.

  • EPP test Means one EPP command sent to a particular “IP address” for one of the EPP servers. Query and transform commands, with the exception of “create”, shall be about existing objects in the Registry System. The response shall include appropriate data from the Registry System. The possible results to an EPP test are: a number in milliseconds corresponding to the “EPP command RTT” or undefined/unanswered.

  • Performance Test means all operational checks and tests required to determine the performance parameters including inter-alia capacity, efficiency and operating characteristics of the Stores as specified in the Contract.

  • Start-Up Testing means the completion of applicable required factory and start-up tests as set forth in Exhibit C.

  • COVID-19 test means a viral test for SARS-CoV-2 that is:

  • Screening Test means a drug or alcohol test which uses a method of analysis allowed by the Minnesota Drug and Alcohol Testing in the Workplace Act to be used for such purposes.

  • Commissioning Tests means all of the procedures and tests which, in accordance with the Reasonable and Prudent Standard, and in compliance with industry guidelines, practices and standards, are:

  • Operational Acceptance Tests means the tests specified in the Technical Requirements and Agreed Project Plan to be carried out to ascertain whether the System, or a specified Sub system, is able to attain the functional and performance requirements specified in the Technical Requirements and Agreed Project Plan, in accordance with the provisions of GCC Clause 27.2 (Operational Acceptance Test).

  • Incurrence Test means the incurrence test set out in Clause 12.1 (Incurrence Test).

  • Drug use test means a scientifically substantiated method to test for the presence of illegal or performance-enhancing drugs or the metabolites thereof in a person’s urine.

  • Fit test means the use of a protocol to qualitatively or quantitatively evaluate the fit of a respirator on an individual.

  • Drug test means a test designed to detect the illegal use of a controlled substance.

  • Acceptance Testing mean the tests, reviews and other activities that are performed by or on behalf of Agency to determine whether the Deliverables meet the Acceptance Criteria or otherwise satisfy the Agency, as determined by the Agency in its sole discretion.

  • Percolation test means a subsurface soil test at the depth of a proposed absorption system or similar component of an OWTS to determine the water absorption capability of the soil, the results of which are normally expressed as the rate at which one inch of water is absorbed. The rate is expressed in minutes per inch.

  • Coverage Test means each of the Class A/B Par Value Test, the Class A/B Interest Coverage Test, the Class C Par Value Test, the Class C Interest Coverage Test, the Class D Par Value Test, the Class D Interest Coverage Test, the Class E Par Value Test and the Class E Interest Coverage Test.

  • Penetration Testing means security testing in which assessors mimic real-world attacks to identify methods for circumventing the security features of an application, system, or network. (NIST SP 800-115)

  • Acceptance Test is a test of the Features executed by the Customer to prepare the acceptance.

  • Plant Test Date or "PTD" means the date acceptance testing is performed with CLEC. "Point of Interface", "Point of Interconnection," or "POI" is a demarcation between the networks of two (2) LECs (including a LEC and CLEC). The POI is that point where the exchange of traffic takes place.

  • Test means such test as is prescribed by the particulars or considered necessary by the Inspecting Officer whether performed or made by the Inspecting Officer or any agency acting under the direction of the Inspecting Officer;