Inlet conditions definition

Inlet conditions. ’ means the concentration of mercury in the flue gas exiting the combustion source prior to application of any air pollution control device as determined using the coal analysis procedures estab- lished in the United States environmental protection agency’s mercury information collection request, as amended.
Inlet conditions. ’ means the concentration of mercury in the flue
Inlet conditions. ’ means the concentration of mercury in

Examples of Inlet conditions in a sentence

  • Inlet conditions for kF and ω are defined as in a standard k − ω model.

  • Inlet conditions were set in the airspeed conditions of 11m/s and 37.5m/s for static aeroelastic analysis and flutter analysis, respectively.

  • Inlet conditions are similar to the hybrid engine under investigation, rather than any ramjet engine.

  • Inlet conditions for validation cases DEDALE1101 and DEDALE1103 [22, 23] PropertyDEDALE1101DEDALE1103Liquid superficial velocity, Jl [m/s]*0.8770.877Gas superficial velocity, Jg [m/s]*0.05880.1851Area averaged void fraction, (α)0.0480.152Interfacial area density, ai [m-1]97269* As specified in [22, 23] at level y=0.

  • For the purposes of the present study, it is assumed that estuarine-dependent seafood packing and processing is unaffected by Oregon Inlet conditions.

  • Inlet conditions are applied upstream of the swirler at the inlet duct and on the combustor limiting surfaces described as mp-*.

  • The transition model has been found to have good convergence behavior in the underlying flow solver and convergence plots for the complex 3D Table 1 Inlet conditions for the test caseshelicopter body will be shown and compared to fully turbulent simulations.

  • Inlet conditions at that time are 24 ˚C and 60% RH at a constant inlet air speed of 0.12 m/s.

  • Under ―essentially closed‖ Oregon Inlet conditions, Dare County boat builders interviewed for this study report that Dare County location would be a much less attractive location for their operations, because they could not easily access the ocean to conduct ―sea trials‖ of their boat designs, and the passive, but very substantial, marketing exposure they get from the many boaters who come to the Oregon Inlet region to fish would be greatly diminished.

  • Inlet conditions are 0.2 SCFM, 5000ppm CO2.shows that at a flow rate of 5 SCFM, the minimum achievable deposition cooler temperature is approximately 180K.


More Definitions of Inlet conditions

Inlet conditions means either: (A) the concentration of mercury in the flue gas exiting the combustion source prior to application of any air pollution control device; or (B) in the case of a fluidized bed combustion unit, the concentration of mercury input to the combustion source based on representative fuel sampling and analysis, as determined by the Commissioner of Environmental Protection.”
Inlet conditions. ’ means the concentration of mercury in the flue gas exiting the combustion source prior to application of any air pollution control device as determined using the coal analysis procedures estab-
Inlet conditions means either of the following: 99

Related to Inlet conditions

  • Product Conditions means these product terms and conditions. These Product Conditions apply to each series of cash settled Warrants over single equities;

  • Specific Conditions means the conditions in addition or in variation to the general conditions which the Commission may lay down specifically for a distribution licensee;

  • Step Down Conditions As of any Distribution Date on which any decrease in any Senior Prepayment Percentage may apply, (i) the outstanding Principal Balance of all Mortgage Loans 60 days or more Delinquent (including Mortgage Loans in REO and foreclosure), averaged over the preceding six month period, as a percentage of the aggregate of the Class Certificate Principal Balances of the Classes of Subordinate Certificates on such Distribution Date, does not equal or exceed 50% and (ii) cumulative Realized Losses with respect to all of the Mortgage Loans do not exceed: · for any Distribution Date on or after the seventh anniversary until the eighth anniversary of the first Distribution Date, 30% of the aggregate Certificate Principal Balance of the Subordinate Certificates as of the Closing Date, · for any Distribution Date on or after the eighth anniversary until the ninth anniversary of the first Distribution Date, 35% of the aggregate Certificate Principal Balance of the Subordinate Certificates as of the Closing Date, · for any Distribution Date on or after the ninth anniversary until the tenth anniversary of the first Distribution Date, 40% of the aggregate Certificate Principal Balance of the Subordinate Certificates as of the Closing Date, · for any Distribution Date on or after the tenth anniversary until the eleventh anniversary of the first Distribution Date, 45% of the aggregate Certificate Principal Balance of the Subordinate Certificates as of the Closing Date, and · for any Distribution Date on or after the eleventh anniversary of the first Distribution Date, 50% of the aggregate Certificate Principal Balance of the Subordinate Certificates as of the Closing Date.

  • Abnormal Market Conditions means conditions contrary to Normal Markets Conditions e.g. when there is low liquidity in the market or rapid price movements in the market or Price Gaps.

  • LC Conditions has the meaning given to such term in Section 2.9.

  • Review Conditions means (i) the Delinquency Percentage for any Payment Date exceeds the Delinquency Trigger for that Payment Date and (ii) the Noteholders or Note Owners, as applicable, have voted, pursuant to Section 2.03(d) of the Receivables Purchase Agreement, to direct an Asset Representations Review of the Subject Receivables.

  • Payment Conditions means, at the time of determination with respect to a proposed payment to fund a Specified Transaction, that:

  • Unsafe condition as used in this clause means the actual or potential exposure of contractor or Government employees to a hazardous material as defined in Federal Standard No. 313, and any revisions thereto during the term of this contract, or any other material or working condition designated by the Contracting Officer's Technical Representative (COTR) as potentially hazardous and requiring safety controls.

  • Standard Conditions means the “International Bank for Reconstruction and Development and International Development Association Standard Conditions for Grant Financing Made by the Bank out of Trust Funds”, dated February 25, 2019.

  • Termination Conditions means, collectively, (a) the payment in full in cash of the Obligations (other than (i) contingent indemnification obligations not then due and (ii) Obligations under Secured Hedge Agreements and Secured Cash Management Agreements) and (b) the termination of the Commitments and the termination or expiration of all Letters of Credit under this Agreement (unless the Outstanding Amount of the L/C Obligations related thereto has been Cash Collateralized on terms reasonably acceptable to the applicable Issuing Bank, backstopped by a letter of credit reasonably satisfactory to the applicable Issuing Bank or deemed reissued under another agreement reasonably acceptable to the applicable Issuing Bank).

  • Licence Conditions means the licence terms and conditions contained in this document, as amended from time to time in accordance with this agreement.

  • Regulatory Conditions means the conditions set out in paragraphs 3.3 to 3.5 (inclusive) of Part A of Appendix I to the Announcement;

  • Extension Conditions Defined in Section 3.06(a).

  • Distribution Conditions means, with respect to any Restricted Payment or Restricted Junior Debt Prepayment, the following:

  • Specified Conditions means, at any time of determination thereof, (a) no Incremental Term Loans in the form of an institutional term loan B facility have been issued and are outstanding pursuant to Section 2.20 of the Credit Agreement and (b) (i) the Company’s “corporate credit rating” from S&P (or such other term as S&P may from time to time use to describe the Company’s senior unsecured non-credit enhanced long term indebtedness, such rating, the “S&P Rating”) shall be at least BBB- (with a stable outlook) and the Company’s “corporate family rating” from Xxxxx’x (or such other term as Xxxxx’x may from time to time use to describe the Company’s senior unsecured non-credit enhanced long term indebtedness, such rating, the “Xxxxx’x Rating”) shall be at least Baa3 (with a stable outlook) or (ii) (x) the Company’s S&P Rating shall be at least BBB- (with a stable outlook) or the Company’s Xxxxx’x Rating shall be at least Baa3 (with a stable outlook) and (y) the Leverage Ratio is less than or equal to 2.50 to 1.00.

  • Standard Listing Conditions has the meaning ascribed thereto in subsection 4(a)(iv);

  • Litigation Conditions has the meaning set forth in Section 11.3.

  • Release Conditions mean the following conditions: (i) Company has received the Executive’s executed Release and (ii) any rescission period applicable to the Executive’s executed Release has expired.

  • Normal Operating Conditions means those Service conditions which are within the control of Grantee. Those conditions which are not within the control of Grantee include, but are not limited to, natural disasters, civil disturbances, power outages, telephone network outages, and severe or unusual weather conditions. Those conditions which are ordinarily within the control of Grantee include, but are not limited to, special promotions, pay-per-view events, rate increases, regular peak or seasonal demand periods, and maintenance or upgrade of the Cable System.

  • Offer Conditions has the meaning set forth in Section 1.01(b).

  • Closing Conditions shall include, but are not limited to, SI Securities determining in its sole discretion that at the time of a closing, the Minimum Offering has been met, the investment remains suitable for investors, investors have successfully passed ID, KYC, AML, OFAC, and suitability screening, and that Issuer has completed all actions required by it as communicated by SI Securities at the time of a closing.

  • Business Condition means the financial condition, business, assets, liabilities and operations of a Person.

  • Equity Conditions Measuring Period means each day during the period beginning twenty (20) Trading Days prior to the applicable date of determination and ending on and including the applicable date of determination.

  • Funding Conditions With respect to any proposed Funding Date, the following conditions:

  • Escrow Release Conditions means, collectively, the conditions set forth in Section 4.3.

  • Nonconforming zoning condition means a physical improvement on a property that does not conform with current zoning standards.