Metered Quantity means apparent power, reactive power, active power, with associated time tagging and any other quantity that may be measured by a Party’s Metering Equipment and that is reasonably required by either Party for Security reasons or revenue requirements.
Required Quantity in a unit price Contract shall mean the actual quantity of any item of Work or materials which is required to be performed or furnished in order to comply with the Contract.
Type B quantity means a quantity of radioactive material greater than a Type A quantity.
Contract Quantity means the quantity of Delivered Energy expected to be delivered by Seller during each Contract Year as set forth in the Cover Sheet.
Type A quantity means a quantity of radioactive material, the aggregate radioactivity of which does not exceed A1 for special form radioactive material or A2 for normal form radio- active material, where A1 and A2 are given in Appendix O or may be determined by procedures described in Appendix O.
Minimum Order Quantity means the minimum number of batches of a Product to be produced during the same cycle of manufacturing as set forth in a Product Agreement on Schedule B;
Bill of Quantities means the priced and completed Bill of Quantities forming part of the tender.
Limited Resource Price Decrement means, for the 2017/2018 Delivery Year, a difference between the clearing price for Limited Demand Resources and the clearing price for Extended Summer Demand Resources and Annual Resources, representing the cost to procure additional Extended Summer Demand Resources or Annual Resources out of merit order when the Limited Resource Constraint is binding.
tons means the gross tonnage calculated in accordance with the tonnage measurement regulations contained in Annex I of the International Convention on Tonnage Measurement of Ships, 1969; the word “tonnage” shall be construed accordingly.
Supply Pipe means any part of a service pipe which a water undertaker could not be, or have been required to lay under section 46 of the Water Industry Act 1991; and
Limited Demand Resource Reliability Target for the PJM Region or an LDA, shall mean the maximum amount of Limited Demand Resources determined by PJM to be consistent with the maintenance of reliability, stated in Unforced Capacity that shall be used to calculate the Minimum Extended Summer Demand Resource Requirement for Delivery Years through May 31, 2017 and the Limited Resource Constraint for the 2017/2018 and 2018/2019 Delivery Years for the PJM Region or such LDA. As more fully set forth in the PJM Manuals, PJM calculates the Limited Demand Resource Reliability Target by first: i) testing the effects of the ten- interruption requirement by comparing possible loads on peak days under a range of weather conditions (from the daily load forecast distributions for the Delivery Year in question) against possible generation capacity on such days under a range of conditions (using the cumulative capacity distributions employed in the Installed Reserve Margin study for the PJM Region and in the Capacity Emergency Transfer Objective study for the relevant LDAs for such Delivery Year) and, by varying the assumed amounts of DR that is committed and displaces committed generation, determines the DR penetration level at which there is a ninety percent probability that DR will not be called (based on the applicable operating reserve margin for the PJM Region and for the relevant LDAs) more than ten times over those peak days; ii) testing the six-hour duration requirement by calculating the MW difference between the highest hourly unrestricted peak load and seventh highest hourly unrestricted peak load on certain high peak load days (e.g., the annual peak, loads above the weather normalized peak, or days where load management was called) in recent years, then dividing those loads by the forecast peak for those years and averaging the result; and (iii) (for the 2016/2017 and 2017/2018 Delivery Years) testing the effects of the six-hour duration requirement by comparing possible hourly loads on peak days under a range of weather conditions (from the daily load forecast distributions for the Delivery Year in question) against possible generation capacity on such days under a range of conditions (using a Monte Carlo model of hourly capacity levels that is consistent with the capacity model employed in the Installed Reserve Margin study for the PJM Region and in the Capacity Emergency Transfer Objective study for the relevant LDAs for such Delivery Year) and, by varying the assumed amounts of DR that is committed and displaces committed generation, determines the DR penetration level at which there is a ninety percent probability that DR will not be called (based on the applicable operating reserve margin for the PJM Region and for the relevant LDAs) for more than six hours over any one or more of the tested peak days. Second, PJM adopts the lowest result from these three tests as the Limited Demand Resource Reliability Target. The Limited Demand Resource Reliability Target shall be expressed as a percentage of the forecasted peak load of the PJM Region or such LDA and is converted to Unforced Capacity by multiplying [the reliability target percentage] times [the Forecast Pool Requirement] times [the DR Factor] times [the forecasted peak load of the PJM Region or such LDA, reduced by the amount of load served under the FRR Alternative].
Production Unit means a facility for generation of electricity made up of a single generation unit or of an aggregation of generation units;
Share Delivery Quantity For any Settlement Date, a number of Shares, as calculated by the Calculation Agent, equal to the Net Share Settlement Amount for such Settlement Date divided by the Settlement Price on the Valuation Date for such Settlement Date.
Bills of Quantities means the priced and completed Bill of Quantities forming part of the tender[where applicable].
Schedule of quantities means the schedule of quantities as specified and forming part of this contract.
PRICED SCHEDULE OR QUANTITIES means the schedule duly priced.
Supply Point means the point of connection between the licensed network and your apparatus or equipment.
Ethanol means a high octane gasoline blend stock that is used to make various grades of gasoline.
SCHEDULE OF QUANTITIES, BILL OF QUANTITIES means the Schedule or Quantities as specified and forming part of contract.
The Schedule of Quantities means the schedule of quantities as specified and forming part of this contract.
INTER-CONNECTION POINT/ DELIVERY/ METERING POINT means a single point at 220kV or above, where the power from the Project(s) is injected into the identified ISTS Substation (including the dedicated transmission line connecting the Projects with the substation system) as specified in the RfS document. Metering shall be done at this interconnection point where the power is injected into. For interconnection with grid and metering, the WPDs shall abide by the relevant CERC/ SERC Regulations, Grid Code and Central Electricity Authority (Installation and Operation of Meters) Regulations, 2006 as amended and revised from time to time.
Daily Quantity means the quantity of waste discharged during an operating day.
Network Supply Point or "NSP" means any Point of Connection between:
Ultra Low Sulfur Diesel Fuel means diesel fuel that has a sulfur content of no more than fifteen parts per million.
Coal means high-grade, medium-grade and low-grade category A and B coal within the meaning of the international codification system for coal established by the United Nations Economic Commission for Europe and clarified in the Council decision of 10 December 2010 on State aid to facilitate the closure of uncompetitive coal mines;
Process Gas means gas used for which alternate fuels, other than another gaseous fuel, are not technically feasible such as in applications requiring precise temperature controls and precise flame characteristics.