Membrane unit definition

Membrane unit means a group of membrane modules that share common valving that allows the unit to be isolated from the rest of the system for the purpose of integrity testing or other maintenance.
Sample 1Sample 2Sample 3
Membrane unit means a group of membrane modules that share common valving which allows the unit to be isolated from the rest of the system for the purpose of integrity testing or other maintenance, synonymous with the terms rack, skid and train.
Sample 1

Examples of Membrane unit in a sentence

  • High raw or filtrate turbidity.2. Pump failure.3. High pressure decay test.4. High transmembrane pressure.5. PLC failure.6. Membrane unit shutdown.7. Clearwell level high or low.8. Equipment failure.

  • High raw or filtrate turbidity.2. Pump failure.3. High pressure decay test.4. High transmembrane pressure.5. PLC failure.6. Membrane unit shutdown.7. Clearwell level high or low.

  • Membrane unit was installed to control CO2 within approved limits.

  • Carrier gas section & Membrane unit: From the reactors, the carrier gas and powder pass into the discharge cyclone and subsequently the degassing vessel where powder and gas are separated.

  • Membrane unit Membrane units – nitrogen at the touch of a buttonThe membrane process makes use of the different rates at which air gases diffuse through a polymer membrane.

  • If the Treated Leachate Effluent Storage Tank is full, then no additional permeate will be allowed to flow through the Ultrafiltration Membrane unit until the tank level decreases sufficiently.

  • Specific policies pertaining to sub-areas are provided in Chapter 6.Note: The policy comprises a number of directions, each of which is accompanied by ex- planatory text.

  • No conditions are recommended relevant to ‘time limit for commencement’ as the scheme has already been implemented.

  • Membrane unit operations: some recent progressesThe main industrial interests in membrane technology involve the separation of gas mixtures, wastewater treatment and water recycling, enhanced oil recovery, separations of organic liquids, oil to gas conversion.

  • By this heat exchange, the uncondensed gets heated by approximately 10 to 20OC & this vapour finally enters the Membrane unit (M30001) for further separation.f. The cooled vapour from the Pre-Cooler enters the shell side of the Cooler where it is cooled by the coolant entering the tube side of the Cooler.

Related to Membrane unit

  • Service Unit means a standardized measure of consumption, use, generation, or discharge attributable to an individual unit of development calculated in accordance with generally accepted engineering or planning standards for a particular category of capital improvements.

  • Junior accessory dwelling unit means a unit that is no more than 500 square feet in size and contained entirely within a single-family residence. A junior accessory dwelling unit may include separate sanitation facilities, or may share sanitation facilities with the existing structure.

  • Membrane filtration means a pressure or vacuum driven separation process in which particulate matter larger than one micrometer is rejected by an engineered barrier, primarily through a size exclusion mechanism, and which has a measurable removal efficiency of a target organism that can be verified through the application of a direct integrity test. This definition includes the common membrane technologies of microfiltration, ultrafiltration, nanofiltration, and reverse osmosis.

  • Accessory dwelling unit means an attached or a detached residential dwelling unit that provides complete independent living facilities for one or more persons and is located on a lot with a proposed or existing primary residence. It shall include permanent provisions for living, sleeping, eating, cooking, and sanitation on the same parcel as the single-family or multifamily dwelling is or will be situated. An accessory dwelling unit also includes the following:

  • Heat unit means a unit of energy equal to the product of the peak kilovoltage, milliamperes, and seconds, i.e., kVp x mA x second.

  • Tight-fitting facepiece means a respiratory inlet covering that forms a complete seal with the face.

  • Generating Unit means one or more generating equipment combinations typically consisting of prime mover(s), electric generator(s), electric transformer(s), steam generator(s) and air emission control devices.

  • Mobile food unit means a vehicle-mounted food service establishment designed to be readily movable.

  • Built-Up Area and/or “Covered Area” in relation to a Flat shall mean the floor area of that Flat including the area of balconies and terraces, if any attached thereto, and also the thickness of the walls (external or internal) and the columns and pillars therein Provided That if any wall, column or pillar be common between two Flats, then one-half of the area under such wall column or pillar shall be included in the built-up area of each such Flat.

  • Dwelling unit means a single unit providing complete, independent living facilities for one or more persons, including permanent provisions for living, sleeping, eating, cooking and sanitation.

  • Filtering facepiece (dust mask) means a negative pressure particulate respirator with a filter as an integral part of the facepiece or with the entire facepiece composed of the filtering medium, not equipped with elastomeric sealing surfaces and adjustable straps.

  • Motor-driven cycle means every motorcycle that has a gasoline engine that (i) displaces less than

  • live-work unit means a unit intended for both residential and non-residential uses concurrently;

  • Plasma arc incinerator means any enclosed device using a high intensity electrical discharge or arc as a source of heat followed by an afterburner using controlled flame combustion and which is not listed as an industrial furnace.

  • Commercial unit means such a unit of goods as by commercial usage is a single whole for purposes of lease and division of which materially impairs its character or value on the market or in use. A commercial unit may be a single article, as a machine, or a set of articles, as a suite of furniture or a line of machinery, or a quantity, as a gross or carload, or any other unit treated in use or in the relevant market as a single whole.

  • separate technical unit means a device subject to the requirements of this Regulation and intended to be part of a vehicle, which may be type-approved separately, but only in relation to one or more specified types of vehicle where this Regulation makes express provisions for so doing.

  • Residential Unit means a home, apartment, residential condominium unit or mobile home, serving as the principal place of residence.

  • Loose-fitting facepiece means a respiratory inlet covering that is designed to form a partial seal with the face.

  • Fuel burning equipment means any furnace, boiler, apparatus, stack and all associated equipment, used in the process of burning fuel.

  • Basement means any area of the building having its floor subgrade (below ground level) on all sides.