Specific Limitations definition

Specific Limitations. This warranty does not cover any post-sales technical support under the following circumstances: • Problems caused by misuse of software or hardware • Failure to provide a network connection or site phone line for a modem connection, if deemed necessary by dormakaba USA • Technical support for network software products • Technical support for software installed on computer hardware or computer operating system that is no longer commercially available for purchase.
Sample 1

Examples of Specific Limitations in a sentence

  • All emission units are listed in Section I under Emission Units with Limitations and Emission Units without Specific Limitations.

  • Specific Limitations For cost reimbursement compensation such as CPFF or T&M, Consultant shall invoice Agency only for actual productive time Consultant personnel spend on Services by any level of Consultant’s staff (up to the established not-to-exceed amount).

  • Specific Limitations Temperature & Pressure Relief valves are not operated due to the likelihood of leaks at this valve after testing and the potential to cause damage on the interior of the residence during testing.

  • Specific Limitations The inspector will not inspect the automatic function of the timer or control box; the effectiveness of rain or freeze sensors; or the effectiveness and sizing of the anti-siphon valves or backflow preventers.

  • Specific Limitations and Exceptions in the BC The Berne Convention recognizes two types of limitations: compensated limitations and uncompensated limitations.

  • Please refer to Section 15.2 (Product Specific Limitations) for gastric or GEJ adenocarcinoma specimens.

  • Specific Limitations This shall apply for brand new Vehicles only subject to one claim per Policy year .

  • Table 30.25.020 of the Santa Barbara Municipal Code is amended to read as follows: TABLE 30.25.020: LAND USE REGULATIONS–COMMERCIAL AND OFFICE ZONES“A” Allowed Use “–“ Use Not Allowed“PSP” Performance Standard Permit Required “(#)” Specific Limitations at the end of the table “CUP” Conditional Use Permit RequiredUse Classification SECTION 6.

  • Plan Specific Limitations Upon completion of a Payroll Deduction Form, your compensation will be reduced each pay period by the percent you specify.

  • Specific Limitations on Personal Investing: The Code generally prohibits all Covered Persons from purchasing Restricted-Reportable Investments, but permits us otherwise to hold, acquire, or sell these and other types of investments in certain circumstances.

Related to Specific Limitations

  • Exceptions and Limitations means fair use, fair dealing, and/or any other exception or limitation to Copyright and Similar Rights that applies to Your use of the Licensed Material.

  • Specific license means a license, under requirements prescribed by the department by rule, to possess, use, manufac- ture, produce, transfer or acquire radioactive material or devices or equipment utilizing radioactive material.

  • Applicable effluent standards and limitations means all State and Federal effluent standards and limitations to which a discharge is subject under the Act, including, but not limited to, effluent limitations, standards of performance, toxic effluent standards and prohibitions, and pretreatment standards.

  • Concentration Limitations Limitations satisfied on each Measurement Date on or after the Effective Date and during the Reinvestment Period if, in the aggregate, the Collateral Obligations owned (or in relation to a proposed purchase of a Collateral Obligation, owned and proposed to be owned) by the Issuer comply with all of the requirements set forth below (or in relation to a proposed purchase after the Effective Date, if any such requirement is not satisfied, the level of compliance with such requirement is maintained or improved after giving effect to the purchase), calculated in each case as required by Section 1.3 herein:

  • Plantwide applicability limitation (PAL means an emission limitation expressed in tons per year, for a pollutant at a major stationary source, that is enforceable as a practical matter and established source-wide in accordance with Chapter 19, section 011.

  • Automatic licensure means granting the occupational licensure without an individual having met occupational licensure requirements provided under the Arkansas Code or by other provisions in these Rules.

  • Exclusions means that certain things are deliberately not covered in a particular policy type

  • Public liability means any legal liability arising out of or resulting from a nuclear in- cident or precautionary evacuation (includ- ing all reasonable additional costs incurred by a State, or a political subdivision of a State, in the course of responding to a nu- clear incident or precautionary evacuation), except (1) claims under State or Federal Workmen’s Compensation Acts of employees of persons indemnified who are employed (a) at the location or, if the nuclear incident oc- curs in the course of transportation of the radioactive material, on the transporting ve- hicle, and (b) in connection with the licens- ee’s possession, use or transfer of the radio- active material; (2) claims arising out of an act of war; and (3) claims for loss of, or dam- age to, or loss of use of (a) property which is located at the location and used in connec- tion with the licensee’s possession, use, or transfer of the radioactive material, and (b) if the nuclear incident occurs in the course of transportation of the radioactive mate- rial, the transporting vehicle, containers used in such transportation, and the radio- active material.

  • Public library means a library that is lawfully established for free public purposes by 1 or more counties, cities, townships, villages, school districts, or other local governments or a combination thereof, or by a public or local act, the entire interests of which belong to the general public. Public library does not include a special library such as a professional, technical, or school library.

  • Nominal tomographic section thickness means the full width at half-maximum of the sensitivity profile taken at the center of the cross-sectional volume over which x-ray transmission data are collected.

  • Technical Limits means the limits and constraints described in Schedule 2, relating to the operations, maintenance and dispatch of the Project.

  • Acid rain emissions limitation means, as defined in 40 CFR 72.2*, a limitation on emissions of sulfur dioxide or nitrogen oxides under the acid rain program under Title IV of the Clean Air Act (CAA).

  • Limitations means any limitations of the exclusive right to the use of a trade mark given by the registration of a person as proprietor thereof, including limitations of that right as to mode of use, as to use in relation to goods to be sold or otherwise traded in in any place within Zambia or as to use in relation to goods to be exported to any market outside Zambia;

  • Limitation of Liability PrimePay has negotiated preferred terms and conditions with FD as a service to PrimePay Clients. Client understands that FD, and not PrimePay, will be performing those services and that Client will enter its own service agreement(s) with FD for such services under terms and conditions specified by FD and agreed to by Client. Accordingly, Client acknowledges that FD shall be the provider of Payment Processing Services hereunder and that PrimePay shall have no liability whatsoever for or related to the performance of those services, including any and all damages, costs and related expenses (including attorney fees).

  • the limits of deviation means the limits of deviation shown on the deposited plan;

  • Enforceability Limitations means limitations on enforcement and other remedies by or arising under or in connection with applicable bankruptcy, insolvency, fraudulent transfer, reorganization, moratorium and other similar Applicable Laws affecting creditors’ rights generally or general principles of equity.

  • Annual Additions means the sum credited to a Participant's Accounts for any Limitation Year of (a) "employer" contributions, (b) Employee contributions (except as provided below), (c) Forfeitures, (d) amounts allocated to an individual medical benefit account, as defined in Code §415(l)(2), which is part of a pension or annuity plan maintained by the "employer," (e) amounts derived from contributions paid or accrued which are attributable to post-retirement medical benefits allocated to the separate account of a key employee (as defined in Code §419A(d)(3)) under a welfare benefit fund (as defined in Code §419(e)) maintained by the "employer" and (f) allocations under a simplified employee pension. Except, however, the Compensation percentage limitation referred to in paragraph (e)(5)(ii) below shall not apply to: (1) any contribution for medical benefits (within the meaning of Code §419A(f)(2)) after separation from service which is otherwise treated as an "annual addition," or (2) any amount otherwise treated as an "annual addition" under Code §415(l)(1).

  • General Provisions means those portions of the Subscription Agreement headed “General Provisions” and contained on pages 7 to 12;

  • Pollutants of concern or "POC" means total nitrogen, total phosphorus, and total suspended solids.

  • Hydraulic lift tank means a tank holding hydraulic fluid for a closed-loop mechanical system that uses compressed air or hydraulic fluid to operate lifts, elevators, and other similar devices.

  • emissions of substances not controlled by emission limits means emissions of substances to air, water or land from the activities, either from the emission points specified in schedule 3 or from other localised or diffuse sources, which are not controlled by an emission limit.

  • Emission limitation means a requirement established by the Board, the director or the Administrator, EPA, which limits the quantity, rate or concentration of emission of air pollutants on a continuous emission reduction including any requirement relating to the operation or maintenance of a source to assure continuous emission reduction (Section 302(k)).

  • Restricted use pesticide means any pesticide or device which, when used as directed or in accordance with a widespread and commonly recognized practice, the director determines, subsequent to a hearing, requires additional restrictions for that use to prevent unreasonable adverse effects on the environment including people, lands, beneficial insects, animals, crops, and wildlife, other than pests.

  • Equator Principles means that set of principles entitled "The Equator Principles – A financial industry benchmark for determining, assessing and managing environmental and social risk in projects", dated July 2020 and available as at the date of this Agreement at: hxxxx://xxxxxxx-xxxxxxxxxx.xxx/xx-content/uploads/2021/02/The-Equator-Principles-July-2020.pdf.

  • Classifications means the classifications contained in Schedule 1 to this Agreement.

  • Technically permissible maximum laden mass means the maximum mass allocated to a vehicle on the basis of its construction features and its design performances.