Measurements and arithmetic conventions All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.
WAGE RATES AND CLASSIFICATIONS Classifications and the hourly wage rates applicable thereto are contained in the Appendices attached to and forming part of this Agreement.
Measurements Units set out in SI (metric) are the governing units for the purposes of this Contract. Units set out in Imperial measurement in parentheses beside their SI (metric) equivalent are for reference only and in the event of a conflict between SI (metric) and Imperial measurement herein, SI (metric) shall prevail.
Union Conventions Leave of Absence without pay and without loss of seniority shall be granted upon request to the Employer, to employees elected or appointed to represent the Union at Union Conventions or seminars. The total of such time off for all causes and for all employees in this unit combined shall not exceed fifteen (15) working days in any calendar year.
Calculations; Computations (a) The financial statements to be furnished to the Lenders pursuant hereto shall be made and prepared in accordance with U.S. GAAP consistently applied throughout the periods involved (except as set forth in the notes thereto or as otherwise disclosed in writing by the Borrower to the Lenders), provided that (i) if at any time any change in U.S. GAAP is reasonably likely to cause any financial ratio or requirement set forth in any Credit Document to be violated or to impose additional obligations on the Borrower, or to prevent any such violation or any such imposition absent such change, and either the Borrower or the Required Lenders shall so request, the Administrative Agent and the Borrower shall negotiate in good faith to amend such ratio or requirement to preserve the original intent thereof in light of such change in U.S. GAAP (subject to the approval of the Required Lenders); provided that, until so amended, (x) such ratio or requirement shall continue to be computed in accordance with U.S. GAAP prior to such change therein (and, for the avoidance of doubt, if such notice is provided following the last day of a Test Period but prior to the date the officer’s certificate required pursuant to Section 9.01(e) has been delivered for such Test Period, such notice shall be deemed to have been received on the last day of such Test Period) and (y) the Borrower shall provide to the Administrative Agent and the Lenders financial statements and other documents required under this Agreement or as reasonably requested hereunder setting forth a reconciliation between calculations of such ratio or requirement made before and after giving effect to such change in U.S. GAAP, (ii) to the extent expressly required pursuant to the provisions of this Agreement, certain calculations shall be made on a Pro Forma Basis and (iii) for purposes of determining compliance with any incurrence or expenditure tests set forth in Sections 9 and/or 10, any amounts so incurred or expended (to the extent incurred or expended in a currency other than Dollars) shall be converted into Dollars on the basis of the exchange rates (as shown on Reuters ECB page 37 or, if same does not provide such exchange rates, on such other basis as is reasonably satisfactory to the Administrative Agent) as in effect on the date of such incurrence or expenditure under any provision of any such Section that has an aggregate Dollar limitation provided for therein (and to the extent the respective incurrence or expenditure test regulates the aggregate amount outstanding at any time and it is expressed in terms of Dollars, all outstanding amounts originally incurred or spent in currencies other than Dollars shall be converted into Dollars on the basis of the exchange rates (as shown on Reuters ECB page 37 or, if same does not provide such exchange rates, on such other basis as is reasonably satisfactory to the Administrative Agent) as in effect on the date of any new incurrence or expenditures made under any provision of any such Section that regulates the Dollar amount outstanding at any time). (b) All computations of interest, Commitment Commission and other Fees hereunder shall be made on the basis of a year of 360 days (except for interest calculated by reference to (x) the Prime Lending Rate, which shall be based on a year of 365 or 366 days, as applicable and (y) Sterling LIBOR, which shall be based on a year of 365 days) for the actual number of days (including the first day but excluding the last day; except that in the case of Letter of Credit Fees and Facing Fees, the last day shall be included) occurring in the period for which such interest, Commitment Commission or Fees are payable.
Annual Evaluations The purpose of the annual evaluation is to assess and communicate the nature and extent of an employee's performance of assigned duties consistent with the criteria specified below in this Policy. Except for those employees who have received notice of non-reappointment pursuant to the BOT- UFF Policy on Non- reappointment, every employee shall be evaluated at least once annually. Personnel decisions shall take such annual evaluations into account, provided that such decisions need not be based solely on written faculty performance evaluations.
Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.
File Naming Conventions Files will be named according to the following convention: {gTLD}_{YYYY-MM-DD}_{type}_S{#}_R{rev}.{ext} where: {gTLD} is replaced with the gTLD name; in case of an IDN-TLD, the ASCII-compatible form (A-Label) must be used; {YYYY-MM-DD} is replaced by the date corresponding to the time used as a timeline watermark for the transactions; i.e. for the Full Deposit corresponding to 2009-08-02T00:00Z, the string to be used would be “2009-08-02”; {type} is replaced by: “full”, if the data represents a Full Deposit; “diff”, if the data represents a Differential Deposit; “thin”, if the data represents a Bulk Registration Data Access file, as specified in Section 3 of Specification 4; {#} is replaced by the position of the file in a series of files, beginning with “1”; in case of a lone file, this must be replaced by “1”. {rev} is replaced by the number of revision (or resend) of the file beginning with “0”: {ext} is replaced by “sig” if it is a digital signature file of the quasi-homonymous file. Otherwise it is replaced by “ryde”.
CLASSIFICATIONS AND WAGE RATES A current list of Field job classifications and applicable wage rates for the Nevada Irrigation District are set forth in the District Wage Schedule.
Particular Methods of Procurement of Goods and Works International Competitive Bidding. Goods and works shall be procured under contracts awarded on the basis of International Competitive Bidding.
