Abrasion conditioning Sample Clauses

Abrasion conditioning. 7.4.1.6.1. The abrasion conditioning will be performed on every device in which the strap is in contact with a rigid part of the belt, with the exception of all adjusting devices where the micro-slip test (paragraph 7.3.) shows that the strap slips by less than half the prescribed value, in which case, the procedure 1 abrasion conditioning (paragraph 7.4.1.6.4.1.) will not be necessary. The setting on the conditioning device will approximately maintain the relative position of strap and contact area.
Sample 1Sample 2Sample 3See All (13)
AutoNDA by SimpleDocs

Related to Abrasion conditioning

  • Termination Conditions This Agreement terminates upon the earlier of any of the following events: a.

  • INCLEMENT CONDITIONS Section 1.

  • PROJECT CONDITIONS A. The Grantee agrees to the following Project Conditions:

  • SANITARY CONDITIONS The Employer agrees to maintain a clean, sanitary washroom hav- ing hot and cold running water with toilet facilities in all present and

  • SAFETY CONDITIONS A. It is the intent of the District to comply with applicable standards of the Division of Industrial Safety of the State of California and those requirements imposed by state or federal law.

  • Site Conditions A. Existing Site Conditions: Information with respect to the site of the Work given in drawings or specifications has been obtained by County's representatives and is believed to be reasonably correct, but the County does not warrant either the completeness or accuracy of such information, and it is the responsibility of the Contractor to verify all such information.

  • Test conditions 6.1.1. The test shall be performed on a flat, dry concrete or asphalt surface affording good adhesion.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!