Corrosion test. 7.2.1. A complete safety-belt assembly shall be positioned in a test chamber as prescribed in Annex 12 to this Regulation. In the case of an assembly incorporating a retractor, the strap shall be unwound to full length less 300 ± 3 mm. Except for short interruptions that may be necessary, for example, to check and replenish the salt solution, the exposure test shall proceed continuously for a period of 50 hours.
7.2.2. On completion of the exposure test the assembly shall be gently washed, or dipped in clean running water with a temperature not higher than 38 °C to remove any salt deposit that may have formed and then allowed to dry at room temperature for 24 hours before inspection in accordance with paragraph 6.2.1.2. above.
Corrosion test. 8.2.4.4.1. The corrosion test is described in paragraph 8.1.1. above.
Corrosion test. 60 5 Abrasion and microslip test .............................................................................................................. 62 6 Description of trolley ....................................................................................................................... 65 Appendix 1 ....................................................................................................................................... 71 Appendix 2 - Arrangement and use of anchorages on the test trolley .............................................. 74 Appendix 3 - Definition of side impact door.................................................................................... 76 7 Curve of trolley's deceleration or acceleration, as function of time ................................................. 79 Appendix 1 - Frontal impact ............................................................................................................ 80 Appendix 2 - Rear impact ................................................................................................................ 81 Appendix 3 - Lateral impact............................................................................................................. 82 Appendix 4 ....................................................................................................................................... 83 8 Description of dummies ................................................................................................................... 85 9 Frontal impact test against a barrier ................................................................................................. 89 10 Rear impact test procedure ............................................................................................................... 91 11 Type approval scheme (Flow chart ISO 9002:2000)........................................................................ 93 12 Control of conformity of production ................................................................................................ 95 13 Test of energy absorbing material .................................................................................................... 99 14 Method of defining head impact area of devices with backrests and for rearward-facing devices defining the minimum size of side wings ............................................................................ 101 15 Description of conditioning of adjusters mounted direct...
Corrosion test. 85 13 Order of tests .................................................................................................................................... 87 14 Control of conformity of production ................................................................................................ 89 15 Procedure for determining the "H" point and the actual torso angle for seating positions in motor vehicles .................................................................................................................................. 92 Appendix 1: Description of the three dimensional "H" point machine ............................................ 92 Appendix 2: Three-dimensional reference system ........................................................................... 92 Appendix 3: Reference data concerning seating positions ............................................................... 92 16 Safety-belt installation showing the belt types and retractor types .................................................. 93 17 Requirements for the installation of safety-belts and restraint systems for adult occupants of power-driven vehicles on forward facing seats, for the installation of ISOFIX child restraint systems and i-size child restraint systems .......................................................................... 94
