Alternate Site Relocation Sample Clauses

Alternate Site Relocation. 4.10.1 On days forecast to be affected by inclement weather, employees can be transferred to unaffected sites. Notification to take place no less than 1 hour prior to work completion on the preceding day. Requirements for work to continue during inclement weather on Appendix ( B ) sites Wet Heat
Sample 1Sample 2Sample 3See All (66)
AutoNDA by SimpleDocs
Alternate Site Relocation. On days forecast to be affected by inclement weather, employees can be transferred to unaffected sites. Notification to take place no later than 10am on the same day. The employer shall be responsible for the movement of any tools required to be used on unaffected sites.
Sample 1
Alternate Site Relocation i. On days forecast to be affected by inclement weather, employees can be transferred to unaffected sites. Notification to take place no less than 1 hour prior to work completion on the preceding day. Requirements for work to continue during inclement weather on sites Wet Heat Safety A level two First Aid worker must be on site. A level two First Aid worker must be on site. Site Amenities Reverse cycle Air- conditioning Reverse cycle Air- conditioning Walking from amenities First Aid etc to worksite Covered walkways required Clause 73.10(b) Once reaching 32 degrees Celsius, Maximum 75 Mtrs On site relocation to unaffected areas. Acceptable when rain commences. OK for assembly work to continue in sheds other than lunch sheds etc. Relocation is acceptable either prior to or upon the temperature reaching 32 degrees Celsius Clause 73.9(a) Determination of unaffected areas Areas must be dry, safe and no falling rain. Clause 73.10(c) Thermometers can be used in predetermined locations Starting times On days of forecast inclement weather work can start at 6.00am by agreement. Clause 73.10(e) On days of forecast inclement weather work can start at 6.00am by agreement. Clause 73.9(f) Casual water Work will not continue in areas affected by casual water. Rest of site continues. Clause 73.10(a) N/A Requirements for Safety Work to be carried out during inclement weather on Section 2 sites. Wet Heat Emergency or safety work Protective Clothing to be provided. Clause 73.10(f) Protective Clothing to be provided, sunscreen, cool drinks etc. Clause 73.9(e) Payment for Emergency or Safety Work. Double Time. Double Time Alternate Site Relocation on Section 2 sites Wet Heat Other site relocation On days forecast to be affected by inclement weather, notification 1 hour prior to work completion on the preceding day. Clause 73.11 On days forecast to be affected by inclement weather, notification 1 hour prior to work completion on the preceding day. Clause 73.11 Conditions where wages will not be paid on sites Wet Heat Unilateral cessation of work Consultation is compulsory when requested within 1 hour. Clause 73.6(a) Consultation is compulsory when requested within 1 hour. Clause 73.6(a) Ambient temperature N/A If outside temperature is 35 degrees Celsius or greater, Work in air-conditioned or unaffected areas stops. Clause 73.9(d) Cessation on site by employees of other companies. If employees leave site and working conditions are available under clause 73.10 If employees leave...
Sample 1
Alternate Site Relocation. Requirements for work to continue during inclement weather 4.10.1 On days forecast to be affected by inclement weather, employees can be transferred to unaffected sites. Notification to take place no less than 1 hour prior to work completion on the preceding day. Requirements for Safety Work to be carried out during inclement weather
Sample 1

Related to Alternate Site Relocation

  • Program Location A. Unless otherwise agreed upon in writing, the parties acknowledge and agree that the Work of this Agreement will be performed at the following Property address: Ktr Address1 Address2

  • Work Location While employed by the Company hereunder, the Executive shall perform his duties (when not traveling or engaged elsewhere in the performance of his duties) at the offices of the Company in Bermuda. The Executive shall travel to such places on the business of the Company in such manner and on such occasions as the Company may from time to time reasonably require.

  • Data Location 1.1. The CONTRACTOR shall not store or transfer non-public COUNTY data outside of the United States. This includes backup data and Disaster Recovery locations. The CONTRACTOR will permit its personnel and contractors to access COUNTY data remotely only as required to provide technical support. (Remote access to data from outside the continental United States is prohibited unless approved in advance and in writing by the County.) 1.2. The CONTRACTOR must notify the COUNTY in advance and in writing of any location changes to CONTRACTOR’s data center(s) that will process or store County data.

  • Project Location [Insert the location of the Project, if applicable]

  • Designated Configuration; Trained Personnel State Street and the Fund shall be responsible for supplying, installing and maintaining the Designated Configuration at the Designated Locations. State Street and the Fund agree that each will engage or retain the services of trained personnel to enable both parties to perform their respective obligations under this Addendum. State Street agrees to use commercially reasonable efforts to maintain the System so that it remains serviceable, provided, however, that State Street does not guarantee or assure uninterrupted remote access use of the System.

  • Office Location During the Term, the Executive's services hereunder shall be performed at the offices of the Company, which shall be within a twenty five (25) mile radius of New York, NY, subject to necessary travel requirements to the Company’s offices in Toronto, Canada and other MDC Group company locations in order to carry out his duties in connection with his position hereunder.

  • Site Lands or areas indicated in the Contract Documents as being furnished by the Owner upon which the Work is to be performed, including rights-of-way and easements for access thereto, and such other lands furnished by the Owner that are designated for the use of the Contractor. Also referred to as Project Site, Job Site and Premises.

  • Service Location The services shall be performed at all contracting and participating facilities of the Contractor.

  • Equipment Testing and Inspection 2.1.1 The Interconnection Customer shall test and inspect its Small Generating Facility and Interconnection Facilities prior to interconnection. The Interconnection Customer shall notify the NYISO and the Connecting Transmission Owner of such activities no fewer than five Business Days (or as may be agreed to by the Parties) prior to such testing and inspection. Testing and inspection shall occur on a Business Day. The Connecting Transmission Owner may, at its own expense, send qualified personnel to the Small Generating Facility site to inspect the interconnection and observe the testing. The Interconnection Customer shall provide the NYISO and Connecting Transmission Owner a written test report when such testing and inspection is completed. The Small Generating Facility may not commence parallel operations if the NYISO, in consultation with the Connecting Transmission Owner, finds that the Small Generating Facility has not been installed as agreed upon or may not be operated in a safe and reliable manner. 2.1.2 The NYISO and Connecting Transmission Owner shall each provide the Interconnection Customer written acknowledgment that it has received the Interconnection Customer’s written test report. Such written acknowledgment shall not be deemed to be or construed as any representation, assurance, guarantee, or warranty by the NYISO or Connecting Transmission Owner of the safety, durability, suitability, or reliability of the Small Generating Facility or any associated control, protective, and safety devices owned or controlled by the Interconnection Customer or the quality of power produced by the Small Generating Facility.

  • Configuration Management The Contractor shall maintain a configuration management program, which shall provide for the administrative and functional systems necessary for configuration identification, control, status accounting and reporting, to ensure configuration identity with the UCEU and associated cables produced by the Contractor. The Contractor shall maintain a Contractor approved Configuration Management Plan that complies with ANSI/EIA-649 2011. Notwithstanding ANSI/EIA-649 2011, the Contractor’s configuration management program shall comply with the VLS Configuration Management Plans, TL130-AD-PLN-010-VLS, and shall comply with the following:

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!