COMPLIANCE WITH EQUAL EMPLOYMENT OPPORTUNITY ORDINANCE 2.16.1 Contractor shall comply with City’s Equal Employment Opportunity Ordinance as set out in in Section 15-17 of the Code of Ordinances.
COMPLIANCE WITH EQUAL OPPORTUNITY ORDINANCE Contractor shall comply with the City’s Equal Employment Opportunity Ordinance as set out in Section 15-17 of the Code of Ordinance.
Jury Service/Witness Leave 17.1 Employees called on for jury service are required to serve. Where the need is urgent, the Employer may apply for postponement because of particular work needs, but this may be done only in exceptional circumstances.
COMPLIANCE WITH WORKERS' COMPENSATION ACT Contractor shall comply with the provisions of the Montana Workers' Compensation Act while performing work for the Department of Montana in accordance with 00-00-000, 00-00-000, and 00-00-000, MCA. Proof of compliance must be in the form of workers' compensation insurance, an independent contractor's exemption, or documentation of corporate officer status. Neither Contractor nor its employees are Department employees. This insurance/exemption must be valid for the entire contract term and any renewal. Upon expiration, a renewal document must be sent to the Department’s Contracts Management Bureau, X.X. Xxx 000000, Xxxxxx, XX 00000.
COMPLIANCE WITH HEALTH & SAFETY CODE § 25249 7(f) Xxxxxxxx agrees to comply with the reporting requirements referenced in Health & Safety Code § 25249.7(f).
Supervisor's Post-Probation Report Unless the probationary employee has previously been removed from probation, the principal or other supervisor shall submit a written report to the Superintendent at the end of the probationary period, which report shall identify whether the performance of the probationary employee has improved and which shall set forth one of the following recommendations for further action:
TERMINATION FOR NON-ADHERENCE OF COUNTY LOBBYIST ORDINANCE The Contractor, and each County Lobbyist or County Lobbying firm as defined in County Code Section 2.160.010 retained by the Contractor, shall fully comply with the County’s Lobbyist Ordinance, County Code Chapter
Certification of Meeting or Exceeding Tobacco-Free Workplace Policy Minimum Standards A. Grantee certifies that it has adopted and enforces a Tobacco-Free Workplace Policy that meets or exceeds all of the following minimum standards of:
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
COMPLIANCE BY CONTRACTOR WITH LAWS AND REGULATIONS/ EQUAL EMPLOYMENT OPPORTUNITY 6.1 In connection with the performance of the Services, the Contractor shall comply with all applicable statutes, laws, regulations, and orders of federal, state, county or municipal authorities which impose any obligation or duty upon the Contractor, including, but not limited to, civil rights and equal employment opportunity laws. In addition, if this Agreement is funded in any part by monies of the United States, the Contractor shall comply with all federal executive orders, rules, regulations and statutes, and with any rules, regulations and guidelines as the State or the United States issue to implement these regulations. The Contractor shall also comply with all applicable intellectual property laws.
