Eligibility It will notify the Issuer and the Servicer promptly if it no longer meets the eligibility requirements in Section 5.1.
Severability Any provision of this Agreement that is prohibited or unenforceable in any jurisdiction shall, as to such jurisdiction, be ineffective to the extent of such prohibition or unenforceability without invalidating the remaining provisions hereof, and any such prohibition or unenforceability in any jurisdiction shall not invalidate or render unenforceable such provision in any other jurisdiction.
Definitions For purposes of this Agreement:
SAVINGS CLAUSE If this Agreement or any portion thereof shall be invalidated on any ground by any court of competent jurisdiction, then the Corporation shall nevertheless indemnify the Indemnitee as to Expenses, judgments, fines, penalties and amounts paid in settlement with respect to any Proceeding to the full extent permitted by any applicable portion of this Agreement that shall not have been invalidated and to the fullest extent permitted by applicable law.
Evaluation 1. The purposes of evaluation provisions include providing employees with feedback, and employers and employees with the opportunity and responsibility to address concerns. Where a grievance proceeds to arbitration, the arbitrator must consider these purposes, and may relieve on just and reasonable terms against breaches of time limits or other procedural requirements.
Safety Where an employee is prevented from working at the employee’s particular function as a result of unsafe conditions caused by the inclement weather, the employee may be transferred to other work in the employee’s classification on site, until the unsafe conditions are rectified. Where such alternative is not available and until the unsafe conditions are rectified, the employee shall remain on site. The employee shall be paid for such time without reduction of the employees’ inclement weather entitlement.
Scope of Services The specific scope of work for each job shall be determined in advance and in writing between TIPS Member, Member’s design professionals and Vendor. It is permitted for the TIPS Member to provide a general scope description, but the awarded vendor should provide a written scope of work, and if applicable, according to the TIPS Member’s design Professional as part of the proposal. Once the scope of the job is agreed to, the TIPS Member will issue a PO and/or an Agreement or Contract with the Job Order Contract Proposal referenced or as an attachment along with bond and any other special provisions agreed by the TIPS Member. If special terms and conditions other than those covered within this solicitation and awarded Agreements are required, they will be attached to the PO and/or an Agreement or Contract and shall take precedence over those in this base TIPS Vendor Agreement.
RECOGNITION 1. For the purposes of the fulfillment, in whole or in part, of its standards or criteria for the authorization, licensing or certification of services suppliers, and subject to the requirements of paragraph 3, a Party may recognize the education or experience obtained, requirements met, or licences or certifications granted in the other Party or a non-Party. Such recognition, which may be achieved through harmonization or otherwise, may be based upon an agreement or arrangement with the other Party or a non-Party concerned or may be accorded autonomously. 2. A Party that is a party to an agreement or arrangement of the type referred to in paragraph 1, whether existing or future, shall afford adequate opportunity for the other Party, if the other Party is interested, to negotiate its accession to such an agreement or arrangement or to negotiate comparable ones with it. Where a Party accords recognition autonomously, it shall afford adequate opportunity for the other Party to demonstrate that education, experience, licences or certifications obtained or requirements met in that other Party's territory should be recognized. 3. A Party shall not accord recognition in a manner which would constitute a means of discrimination between countries in the application of its standards or criteria for the authorization, licensing or certification of services suppliers, or a disguised restriction on trade in services. 4. Each Party should encourage the relevant bodies in its respective territory to conduct future negotiations for developing mutually acceptable standards and criteria for licensing, temporary licensing and certification of professional services suppliers.
HEALTH AND SAFETY 16.01 The Employer, Union and the employees shall comply with the provisions of the Occupational Health and Safety Act where and when applicable. The Employer shall provide working conditions at all times which are not prejudicial to the health or efficiency of the workers. Employees are required to report to their Employer any unsafe work conditions, or violation of any safe work policies or procedures established by the Employer, or any violation of relevant safe work legislation.
Governing Law This Agreement shall be governed by and construed in accordance with the laws of the State of New York.
