Breakdown of the consultation Sample Clauses

Breakdown of the consultation. The work is broken down into 17 lots, divided as follows: Lot Title 02 Desks 03 Entrance table 04 Desks separators 05 Storage 06 Small meeting tables 07 Meeting tables on wheels 08 Trapeze meeting table 09 Bench BD 10 75 meeting room chairs 11 90 meeting room chairs 12 110 meeting room chairs 13 110 desk chairs 14 Informal meeting tables 15 Armchairs 16 Sofas 17 Meeting chairs Each lot is the subject of a separate contract. However, companies may tender for all the lots. There is no limit on the number of lots which can be allocated to one company.
AutoNDA by SimpleDocs

Related to Breakdown of the consultation

  • Scope, Consultations, Mediation and Conciliation Disputes between the Contracting Parties concerning the interpretation or application of this Agreement shall, as far as possible, be settled amicably or through consultations, mediation or conciliation.

  • JOINT CONSULTATION 21.01 The parties acknowledge the mutual benefits to be derived from joint consultation and are prepared to enter into discussion aimed at the development and introduction of appropriate machinery for the purpose of providing joint consultation on matters of common interest.

  • Technical Consultations 1. A Party may initiate technical consultations with another Party through the respective contact points with the aim of resolving any matter arising under this Chapter.

  • Prior consultation It is expected that the Parents, or duly authorised education guardian, will consult personally with the Head or with the Head's authorised deputy before Notice of Withdrawal is given by the Parents.

  • Telephone Consultation Where an employee is consulted by a Supervisor or his/her delegate by telephone outside of his/her normal hours of work concerning a problem of work, a telephone consultation premium will be paid as follows:

  • Consultations 1. A Party may request in writing consultations with the other Party with respect to any matter referred to in Article 174 (Scope of Application). 2. The requesting Party shall deliver the request to the other Party, and shall set out the reasons for the request, including identification of the measure or other matter at issue and an indication of the legal basis for the complaint. 3. The requested Party shall reply to the request in writing within 25 days following the date of receipt of the request. 4. The Parties shall enter into consultations in good faith within: (a) 35 days following the date of receipt of the request for consultations regarding urgent matters (20); or (b) 40 days following the date of receipt of the request for consultations for all other matters. 5. The consulting Parties shall make every attempt to arrive at a mutually satisfactory resolution of any matter raised through consultations under this Article or other consultative provisions of this Agreement.

  • Vendor’s Resellers as Related to This Agreement Vendor’s Named Resellers (“Resellers”) under this Agreement shall comply with all terms and conditions of this agreement and all addenda or incorporated documents. All actions related to sales by Authorized Vendor’s Resellers under this Agreement are the responsibility of the awarded Vendor. If Resellers fail to report sales to TIPS under your Agreement, the awarded Vendor is responsible for their contractual failures and shall be billed for the fees. The awarded Vendor may then recover the fees from their named reseller. Support Requirements If there is a dispute between the awarded Vendor and TIPS Member, TIPS or its representatives may, at TIPS sole discretion, assist in conflict resolution if requested by either party. TIPS, or its representatives, reserves the right to inspect any project and audit the awarded Vendor’s TIPS project files, documentation and correspondence related to the requesting TIPS Member’s order. If there are confidentiality requirements by either party, TIPS shall comply to the extent permitted by law. Incorporation of Solicitation The TIPS Solicitation which resulted in this Vendor Agreement, whether a Request for Proposals, the Request for Competitive Sealed Proposals or Request for Qualifications solicitation, or other, the Vendor’s response to same and all associated documents and forms made part of the solicitation process, including any addenda, are hereby incorporated by reference into this Agreement as if copied verbatim. SECTION HEADERS OR TITLES THE SECTON HEADERS OR TITLES WITHIN THIS DOCUMENT ARE MERELY GUIDES FOR CONVENIENCE AND ARE NOT FOR CLASSIFICATION OR LIMITING OF THE RESPONSIBILITES OF THE PARTIES TO THIS DOCUMENT. STATUTORY REQUIREMENTS Texas governmental entities are prohibited from doing business with companies that fail to certify to this condition as required by Texas Government Code Sec. 2270. By executing this agreement, you certify that you are authorized to bind the undersigned Vendor and that your company (1) does not boycott Israel; and (2) will not boycott Israel during the term of the Agreement. You certify that your company is not listed on and does not and will not do business with companies that are on the Texas Comptroller of Public Accounts list of Designated Foreign Terrorists Organizations per Texas Gov't Code 2270.0153 found at xxxxx://xxxxxxxxxxx.xxxxx.xxx/purchasing/docs/foreign-terrorist.pdf You certify that if the certified statements above become untrue at any time during the life of this Agreement that the Vendor will notify TIPS within three (3) business day of the change by a letter on Vendor’s letterhead from and signed by an authorized representative of the Vendor stating the non-compliance decision and the TIPS Agreement number and description at: Attention: General Counsel ESC Region 8/The Interlocal Purchasing System (TIPS) 0000 Xxxxxxx 000 Xxxxx Xxxxxxxxx, XX,00000 And by an email sent to xxxx@xxxx-xxx.xxx Insurance Requirements The undersigned Vendor agrees to maintain the below minimum insurance requirements for TIPS Contract Holders: General Liability $1,000,000 each Occurrence/ Aggregate Automobile Liability $300,000 Includes owned, hired & non-owned Workers' Compensation Statutory limits for the jurisdiction in which the Vendor performs under this Agreement. Umbrella Liability $1,000,000 When the Vendor or its subcontractors are liable for any damages or claims, the Vendor’s policy, when the Vendor is responsible for the claim, must be primary over any other valid and collectible insurance carried by the Member. Any immunity available to TIPS or TIPS Members shall not be used as a defense by the contractor's insurance policy. The coverages and limits are to be considered minimum requirements and in no way limit the liability of the Vendor(s). Insurance shall be written by a carrier with an A-; VII or better rating in accordance with current A.M. Best Key Rating Guide. Only deductibles applicable to property damage are acceptable, unless proof of retention funds to cover said deductibles is provided. "Claims made" policies will not be accepted. Vendor’s required minimum coverage shall not be suspended, voided, cancelled, non-renewed or reduced in coverage or in limits unless replaced by a policy that provides the minimum required coverage except after thirty (30) days prior written notice by certified mail, return receipt requested has been given to TIPS or the TIPS Member if a project or pending delivery of an order is ongoing. Upon request, certified copies of all insurance policies shall be furnished to the TIPS or the TIPS Member. Special Terms and Conditions • Orders: All Vendor orders received from TIPS Members must be emailed to TIPS at tipspo@tips- xxx.xxx. Should a TIPS Member send an order directly to the Vendor, it is the Vendor’s responsibility to forward a copy of the order to TIPS at the email above within 3 business days and confirm its receipt with TIPS. • Vendor Encouraging Members to bypass TIPS agreement: Encouraging TIPS Members to purchase directly from the Vendor or through another agreement, when the Member has requested using the TIPS cooperative Agreement or price, and thereby bypassing the TIPS Agreement is a violation of the terms and conditions of this Agreement and will result in removal of the Vendor from the TIPS Program. • Order Confirmation: All TIPS Member Agreement orders are approved daily by TIPS and sent to the Vendor. The Vendor should confirm receipt of orders to the TIPS Member (customer) within 3 business days. • Vendor custom website for TIPS: If Vendor is hosting a custom TIPS website, updated pricing when effective. TIPS shall be notified when prices change in accordance with the award.

  • Disputes Not Related to Contract Services The Engineer shall be responsible for the settlement of all contractual and administrative issues arising out of any procurement made by the Engineer in support of the services authorized herein.

  • Scope of Professional Services 3.1 On the terms and conditions set forth in this Agreement, COUNTY hereby engages CONTRACTOR to provide all labor, materials and equipment to complete the Project/Service in accordance with the Scope of Services, attached hereto and incorporated herein as Attachment A, as modified or clarified by Addendum(s) # , dated , attached hereto and incorporated herein by reference as Attachment B. It is understood that the Scope of Services may be modified by change order as the Project/Service progresses, but to be effective and binding, any such change order must be in writing, executed by the parties, and in accordance with the COUNTY’s Purchasing Policies and Procedures. A copy of these policies and procedures shall be made available to the CONTRACTOR upon request.

  • LABOUR MANAGEMENT RELATIONS 30.01 A Labour/Management Relations Committee shall be appointed, consisting of a maximum of two (2) Shop Stewards from the Union, and a maximum of two (2) representatives from the Co-operative. The full-time Union Representative may also attend these meetings from time to time. The Committee shall meet at the request of either party, for the purpose of discussing matters of mutual concern. Time spent by bargaining unit employees in carrying out the functions of this Committee shall be considered as time worked and shall be paid for by the Co-operative. The Committee shall not have jurisdiction to interpret and/or amend the Collective Agreement.

Time is Money Join Law Insider Premium to draft better contracts faster.