Cable Length. At each drum, the maximum length of cable should be as follows: Table 9 CABLE SIZE LENGTH IN M 4x6 mm2 1000 + 10% , - 5 % The tolerance in total length of the required lot in each purchase order is applicable to increase by 10%, and decreased by - 5%.
Cable Length. Cable Length is a static measure and is established by considering all cableLength constraints allocated to elements of the HardwareDesignArchitecture, typically the HWconnectors. In case such fine granularity is not needed it is also possible to define cable lengths for components or component compositions that use a set of cables. In such case the cable length is specified without defining which cables it refers to. To find the total cable length, the genericConstraintValue over all GenericConstraints with the genericConstraintType cableLength is added up. If there is variability, all variation groups of the architecture need to be resolved first. If an entire product line is considered, it is necessary to either sum the cable lengths over each fully resolved architecture and iterate over all fully resolved vehicles while summing up the total cable lengths, or calculate component counts over the entire product line (see TakeRate constraint) so that the component’s cable length is multiplied with the component count and summed.
Cable Length. At each drum, the maximum length of cable should be as following:
Cable Length. Cable length from work area faceplate to either patch panel or 110 cross-connect terminal block shall not exceed 90 meters.
Cable Length. At each coil, the maximum length of cable foe each size should be as follows: CABLE SIZE LENGTH IN M 1X6 mm2 100 m in each coil 1X16 mm2 100 m in each coil
