Calculation and Payment of Participation Rent
Calculation and Payment of Participation Rent Sample Clauses
Related to Calculation and Payment of Participation Rent
Salary Rate Calculation and Payment The biweekly salary rate of employees serving on twelve (12) month (calendar year) appointments shall be calculated by dividing the calendar year salary rate by 26.1 pay periods.
Compensation and Payment Terms A. Subject to the satisfactory performance of the services required of Contractor pursuant to this Agreement, and to the terms and conditions set forth in this Agreement, and following Contractor’s submission of an appropriate claim, and such other documentation that the County may require, County shall pay Contractor according to the terms set forth in Exhibit C, Terms of Payment. Contractor agrees to accept the foregoing payments as full and complete payment for all services provided pursuant to this Agreement, irrespective of whether the cost of such services and related administrative expenses exceed such payments.
MEASUREMENT AND PAYMENT Temporary traffic control work, including, but not limited to installation and removal of portable signs, cones, drums, skinny drums, flaggers, AFAD’s, changeable message boards, truck mounted attenuators, flashing arrow boards, and pilot vehicles will be paid at the contract lump sum price for
Payment Terms – Payment in Arrears A. Invoices are to be submitted in arrears to the user agency/department to the ship- to address, unless otherwise directed in this CONTRACT. Payment will be net 30 days after receipt of an invoice in a format acceptable to the County of Orange and verified and approved by the agency/department and subject to routine processing requirements. The responsibility for providing an acceptable invoice rests with the CONTRACTOR.
Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) 1/10th) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
Rates and Payments Room and board fees are approved by the Board of Trustees during the spring semester for the following academic year; however, the University reserves the right to make adjustments as deemed necessary and appropriate in the sole discretion of the Vice President for Student Affairs or designee, at any time during the term of this agreement in accordance with Section 11.
Compensation and Payment 3.1 Contractor’s fees shall be calculated at the rates set forth in the attached Exhibit
Settlement Funding and Payments (a) Rite Aid agrees to pay up to twenty million and nine-hundred thousand dollars and no cents ($20,900,000), in order to fully and finally resolve the Wage-Hour Lawsuits in their entirety, inclusive of all Attorneys’ Fees and Lawsuit Costs; interest; Administration Costs; liquidated, punitive and multiplier of damages; taxes; payroll taxes, Employer Payroll Taxes, and Incentive Awards, if any. Rite Aid shall not be responsible for any taxes imposed by law on the Settlement Class Members as a result of payments made to the Settlement Classes, or any other sums in excess of the Gross Settlement Amount.
Credit Request and Payment Procedures 1. To receive a Service Credit, the Customer must submit a claim by opening a case in the NAVER CLOUD PLATFORM Customer Support Center by the end of the following month in which the failure occurred (for example, by March 31st if the failure occurred on February 15th), and must submit the claim documents specifying the name of the Product, instance ID, volume ID, task NRN, the time of failure and log data.
Consideration and Payment The purchase price for the sale of the Purchased Assets sold to the Purchaser on the Closing Date shall equal the estimated fair market value of the Purchased Assets. Such purchase price shall be paid in cash to Santander Consumer in an amount agreed to between Santander Consumer and the Purchaser, and, to the extent not paid in cash by the Purchaser, shall be paid by a capital contribution by Santander Consumer of an undivided interest in such Purchased Assets that increases its equity interest in the Purchaser in an amount equal to the excess of the estimated fair market value of the Purchased Assets over the amount of cash paid by the Purchaser to Santander Consumer.
