CarbFix sampling and analysis Sample Clauses

CarbFix sampling and analysis. Sampling of the fluids at the original Carbfix site began in 2008, prior to CO2 injection tests, in several shallow and deep xxxxx. During the injection (from January 2012) and until September 2012, sampling of HN-4 was conducted twice weekly, and continued weekly until July 2013. In short, water was pumped from the monitoring well at constant rate and sampled through a stainless-steel pipe connected to the well lining pipe. After flushing the sampling pipe, water was filtered and at least 3 L of water was pumped through the system before samples were collected in different bottles depending on the subsequent analyses for pH, alkalinity, cations, anions, trace metals, Fe-species, and DIC. Temperature, conductivity, pH, dissolved oxygen, and dissolved H2S were measured on site. All other analyses were completed in the laboratory. More details of the sampling and analysis of these fluid samples can be found in the supplementary material that complement the papers published by Xxxxxx et al. (2016) and Xxxxxxxxxxxxxxx et al. (2017). Samples for isotopes analysis were also collected from the site, but analysed later within the framework of the S4CE project. Details on the analysis protocol for Fe, Cu, and Zn are given Section 2.4.
AutoNDA by SimpleDocs

Related to CarbFix sampling and analysis

  • Sampling and Analysis The Seller has sole responsibility for quality control of the coal and shall forward its “as loaded” quality to the Buyer as soon as possible. The sampling and analysis of the coal delivered hereunder shall be performed by Buyer and the results thereof shall be accepted and used for the quality and characteristics of the coal delivered under this Agreement. All analyses shall be made in Buyer’s laboratory at Buyer’s expense in accordance with ASTM standards where applicable, or using standards mutually acceptable to both parties. Samples for analyses shall be taken by any ASTM standards or standards mutually acceptable to both parties, and may be composited and shall be taken with a frequency and regularity sufficient to provide reasonably accurate representative samples of the deliveries made hereunder. Seller represents that it is familiar with Buyer’s sampling and analysis practices, and finds them to be acceptable. Buyer shall notify Seller in writing of any significant changes in Buyer’s sampling and analysis practices. Any such changes in Buyer’s sampling and analysis practices shall, except for ASTM or mutually agreeable changes in practices, provide for no less accuracy than the sampling and analysis practices existing at the time of the execution of this Agreement, unless the Parties otherwise mutually agree. (1) part shall be used for analysis by Buyer; one (l) part shall be used by Buyer as a check sample, if Buyer in its sole judgment determines it is necessary; one (1) part shall be retained by Buyer (LG&E) until the twenty-fifth (25th) of the month following the month of unloading (the “LG&E Disposal Date”) or Buyer (KU) until thirty (30) days after the sample is taken (the “KU Disposal Date”), the LG&E Disposal Date and the KU Disposal Date are collectively the “Disposal Date”), and shall be delivered to Seller for analysis if Seller so requests before the Disposal Date; and one part (“Referee Sample”) shall be retained by Buyer until the Disposal Date. Seller shall be given copies of all analyses made by Buyer by the tenth (10th) business day of the month following the month of unloading. Seller, on reasonable notice to Buyer shall have the right to have a representative present to observe the sampling and analyses performed by Buyer. Unless Seller requests a Referee Sample analysis before the Disposal Date, Buyer’s analysis shall be used to determine the quality of the coal delivered hereunder. The Monthly Weighted Averages shall be determined by utilizing the individual shipment analyses. If any dispute arises before the Disposal Date, the Referee Sample retained by Buyer shall be submitted for analysis to an independent commercial testing laboratory (“Independent Lab”) mutually chosen by Buyer and Seller. For each coal quality specification in question, a dispute shall be deemed not to exist and Buyer’s analysis shall prevail and the analysis of the Independent Lab shall be disregarded if the analysis of the Independent Lab differs from the analysis of Buyer by an amount equal to or less than: (i) 0.50% moisture (ii) 0.50% ash on a dry basis (iii) 100 Btu/lb. on a dry basis (iv) 0.10% sulfur on a dry basis. For each coal quality specification in question, if the analysis of the Independent Lab differs from the analysis of Buyer by an amount more than the amounts listed above, then the analysis of the Independent Lab shall prevail and Buyer’s analysis shall be disregarded. The cost of the analysis made by the Independent Lab shall be borne by Seller to the extent that Buyer’s analysis prevails and by Buyer to the extent that the analysis of the Independent Lab prevails.

  • Risk Analysis The Custodian will provide the Fund with a Risk Analysis with respect to Securities Depositories operating in the countries listed in Appendix B. If the Custodian is unable to provide a Risk Analysis with respect to a particular Securities Depository, it will notify the Fund. If a new Securities Depository commences operation in one of the Appendix B countries, the Custodian will provide the Fund with a Risk Analysis in a reasonably practicable time after such Securities Depository becomes operational. If a new country is added to Appendix B, the Custodian will provide the Fund with a Risk Analysis with respect to each Securities Depository in that country within a reasonably practicable time after the addition of the country to Appendix B.

  • Quantitative Analysis Quantitative analysts develop and apply financial models designed to enable equity portfolio managers and fundamental analysts to screen potential and current investments, assess relative risk and enhance performance relative to benchmarks and peers. To the extent that such services are to be provided with respect to any Account which is a registered investment company, Categories 3, 4 and 5 above shall be treated as “investment advisory services” for purposes of Section 5(b) of the Agreement.”

  • Escrow Analysis If applicable, with respect to each Mortgage Loan, the Seller has within the last twelve months (unless such Mortgage was originated within such twelve month period) analyzed the required Escrow Payments for each Mortgage and adjusted the amount of such payments so that, assuming all required payments are timely made, any deficiency will be eliminated on or before the first anniversary of such analysis, or any overage will be refunded to the Mortgagor, in accordance with RESPA and any other applicable law;

  • Research Analyst Independence The Company acknowledges that the Underwriters’ research analysts and research departments are required to be independent from their respective investment banking divisions and are subject to certain regulations and internal policies, and that such Underwriters’ research analysts may hold views and make statements or investment recommendations and/or publish research reports with respect to the Company and/or the offering that differ from the views of their respective investment banking divisions. The Company hereby waives and releases, to the fullest extent permitted by law, any claims that the Company may have against the Underwriters with respect to any conflict of interest that may arise from the fact that the views expressed by their independent research analysts and research departments may be different from or inconsistent with the views or advice communicated to the Company by such Underwriters’ investment banking divisions. The Company acknowledges that each of the Underwriters is a full service securities firm and as such from time to time, subject to applicable securities laws, may effect transactions for its own account or the account of its customers and hold long or short positions in debt or equity securities of the companies that may be the subject of the transactions contemplated by this Agreement.

  • Investment Analysis and Implementation In carrying out its obligations under Section 1 hereof, the Advisor shall: (a) supervise all aspects of the operations of the Funds; (b) obtain and evaluate pertinent information about significant developments and economic, statistical and financial data, domestic, foreign or otherwise, whether affecting the economy generally or the Funds, and whether concerning the individual issuers whose securities are included in the assets of the Funds or the activities in which such issuers engage, or with respect to securities which the Advisor considers desirable for inclusion in the Funds' assets; (c) determine which issuers and securities shall be represented in the Funds' investment portfolios and regularly report thereon to the Board of Trustees; (d) formulate and implement continuing programs for the purchases and sales of the securities of such issuers and regularly report thereon to the Board of Trustees; and (e) take, on behalf of the Trust and the Funds, all actions which appear to the Trust and the Funds necessary to carry into effect such purchase and sale programs and supervisory functions as aforesaid, including but not limited to the placing of orders for the purchase and sale of securities for the Funds.

  • Independent Analysis Each Party hereby confirms that its decision to execute this Agreement has been based upon its independent assessment of documents and information available to it, as it has deemed appropriate.

  • Statistical Sampling Documentation a. A copy of the printout of the random numbers generated by the “Random Numbers” function of the statistical sampling software used by the IRO.‌ b. A description or identification of the statistical sampling software package used by the IRO.‌

  • Inspections and Tests 26.1 The Supplier shall at its own expense and at no cost to the Procuring Entity carry out all such tests and/or inspections of the Goods and Related Services as are specified in the SCC. 26.2 The inspections and tests may be conducted on the premises of the Supplier or its Subcontractor, at point of delivery, and/or at the Goods' final destination, or in another place in Kenya as specified in the SCC. Subject to GCC Sub-Clause 26.3, if conducted on the premises of the Supplier or its Subcontractor, all reasonable facilities and assistance, including access to drawings and production data, shall be furnished to the inspectors at no charge to the Procuring Entity. 26.3 The Procuring Entity or its designated representative shall be entitled to attend the tests and/or inspections referred to in GCC Sub-Clause 26.2, provided that the Procuring Entity bear all of its own costs and expenses incurred in connection with such attendance including, but not limited to, all travelling and board and lodging expenses. 26.4 Whenever the Supplier is ready to carry out any such test and inspection, it shall give a reasonable advance notice, including the place and time, to the Procuring Entity. The Supplier shall obtain from any relevant third party or manufacturer any necessary permission or consent to enable the Procuring Entity or its designated representative to attend the test and/or inspection. 26.5 The Procuring Entity may require the Supplier to carry out any test and/or inspection not required by the Contract but deemed necessary to verify that the characteristics and performance of the Goods comply with the technical specifications codes and standards under the Contract, provided that the Supplier's reasonable costs and expenses incurred in the carrying out of such test and/or inspection shall be added to the Contract Price. Further, if such test and/or inspection impedes the progress of manufacturing and/or the Supplier's performance of its other obligations under the Contract, due allowance will be made in respect of the Delivery Dates and Completion Dates and the other obligations so affected. 26.6 The Supplier shall provide the Procuring Entity with a report of the results of any such test and/or inspection. 26.7 The Procuring Entity may reject any Goods or any part thereof that fail to pass any test and/or inspection or do not conform to the specifications. The Supplier shall either rectify or replace such rejected Goods or parts thereof or make alterations necessary to meet the specifications at no cost to the Procuring Entity, and shall repeat the test and/or inspection, at no cost to the Procuring Entity, upon giving a notice pursuant to GCC Sub- Clause 26.4. 26.8 The Supplier agrees that neither the execution of a test and/or inspection of the Goods or any part thereof, nor the attendance by the Procuring Entity or its representative, nor the issue of any report pursuant to GCC Sub-Clause 26.6, shall release the Supplier from any warranties or other obligations under the Contract.

  • Technology Research Analyst Job# 1810 General Characteristics

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!