Chiller for Thermal Energy Storage Form Sample Clauses

Chiller for Thermal Energy Storage Form. ‌ When you include thermal energy storage in central plant, the first electric chiller is designated as the thermal energy storage (TES) chiller. This chiller is used to charge the thermal energy storage tanks or to make ice, depending on the type of thermal energy storage that you define. The form you use to define the TES chiller is essentially the same other electric chillers, except that an additional command button is included on the general folder titled Define TES Settings. When you click this command button, an additional form appears where you can enter some additional information about how the chiller will perform in conjunction with thermal storage. The information that you need to enter depends on the type of thermal storage you specified (see the Thermal Energy Storage Form. The table below shows the information that is needed for each type of thermal storage. Ice on Coil Starting Chiller Efficiency • Ending Chiller Efficiency • Ice Harvest Brine Ice Slurry Eutectic Time Fraction for Ice Making • Suction Temperature at Storage While Making Brine • Suction Temperature at Beginning of Ice Making • • • Suction Temperature at Phase Change • Drop in Suction Temperature • Starting Chiller Efficiency. For ice-on-coil systems, you enter the efficiency of the chiller at the beginning of ice making. The efficiency will generally be greater at the beginning of ice making and less at the end after ice has built up on the coils. Ending Chiller Efficiency. For ice-on-coil systems, you enter the efficiency of the chiller at the end of ice making. Time Fraction for Ice Making. For ice harvesting systems, you must enter the fraction of time that the chiller makes ice. After ice is made, the refrigeration cycle is usually reversed briefly so that the ice falls off the evaporator into the storage tank. A reasonable default is 0.75. Suction Temperature at Storage While Making Brine. For brine systems, you must specify the suction temperature when the brine is charged. Suction Temperature at Beginning of Ice Making. For Ice harvesting and ice slurry systems, you must specify the suction temperature during the process of making ice.
Sample 1
AutoNDA by SimpleDocs

Related to Chiller for Thermal Energy Storage Form

  • HEALTH AND SAFETY C8.1 The Contractor shall promptly notify the Authority of any health and safety hazards which may arise in connection with the performance of the Contract. The Authority shall promptly notify the Contractor of any health and safety hazards which may exist or arise at the Authority’s Premises and which may affect the Contractor in the performance of the Contract.

  • PAYMENT OF WAGES With the agreement of the majority of the employees, the company may elect to pay wages weekly by electronic funds transfer (EFT) to up to two accounts of the employee’s choice.

  • Scope of Services The specific scope of work for each job shall be determined in advance and in writing between TIPS Member, Member’s design professionals and Vendor. It is permitted for the TIPS Member to provide a general scope description, but the awarded vendor should provide a written scope of work, and if applicable, according to the TIPS Member’s design Professional as part of the proposal. Once the scope of the job is agreed to, the TIPS Member will issue a PO and/or an Agreement or Contract with the Job Order Contract Proposal referenced or as an attachment along with bond and any other special provisions agreed by the TIPS Member. If special terms and conditions other than those covered within this solicitation and awarded Agreements are required, they will be attached to the PO and/or an Agreement or Contract and shall take precedence over those in this base TIPS Vendor Agreement.

  • Safety Where an employee is prevented from working at the employee’s particular function as a result of unsafe conditions caused by the inclement weather, the employee may be transferred to other work in the employee’s classification on site, until the unsafe conditions are rectified. Where such alternative is not available and until the unsafe conditions are rectified, the employee shall remain on site. The employee shall be paid for such time without reduction of the employees’ inclement weather entitlement.

  • Hours of Work i) Where employees are now working a longer daily tour, the provisions set out in this Article governing the regular hours of work on a daily tour shall be adjusted accordingly.

  • Services FASC agrees to provide to the Adviser the services indicated in Exhibit A to this Agreement (the “Services”).

  • Training a. The employer, in consultation with the local, shall be responsible for developing and implementing an ongoing harassment and sexual harassment awareness program for all employees. Where a program currently exists and meets the criteria listed in this agreement, such a program shall be deemed to satisfy the provisions of this article. This awareness program shall initially be for all employees and shall be scheduled at least once annually for all new employees to attend.

  • Termination for Convenience TIPS may, by written notice to Vendor, terminate this Agreement for convenience, in whole or in part, at any time by giving thirty (30) days’ written notice to Vendor of such termination, and specifying the effective date thereof.

  • Payment Terms DXC agrees to pay Supplier the undisputed amount of an invoice within ninety (90) days after the receipt of a valid, complete and properly documented invoice. Any prompt payment discount will be calculated from the date a conforming invoice is received by DXC. Payment will be in U.S. currency unless otherwise stated. Payment will not constitute acceptance of Products and/or Services or impair DXC’s right to inspect. Acceptance shall be when DXC deems the Products and/or Services to meet its specified criteria (“Acceptance”). DXC, at its option, and without prior notice to Supplier, shall have the right to set off or deduct from any Supplier’s invoice, any credits, refunds or claims of any kind due DXC.

  • Confirmation of Agreement Except as amended hereby, the Custody Agreement is in full force and effect and as so amended is hereby ratified, approved and confirmed by the Customer and the Bank in all respects.

Time is Money Join Law Insider Premium to draft better contracts faster.