Dual Fuel Alternative Sample Clauses

Dual Fuel Alternative. In the case of the dual fuel vessel the alternatives in the consortium come from Dolderman ArenaRED and Wärtsilä. The difference is that the solution from Wärtsilä is an OEM solution and that of Dolderman ArenaRED is a retrofit solution. This has the implication that the data supplied by Wärtsilä are according to the similar ISO Standard compared to the Cat information. The data available by Dolderman ArenaRed was raw testbed development data. This data is considered too experimental and therefore not suitable to integrate into the comparison and derive conclusions from based on an apples to apples comparison. The overall efficiency of the engine is included in the graph called ‘Specific Fuel Consumption of Dual Fuel Engines’ as a base case the diesel alternative is included as well. What can be derived from this graph is that the efficiency of the Cat DGB engine has a slight negative offset compared to the diesel base case. The difference is kept limited by limiting the time spent in gas mode when the load of the engine is either too low or too high as listed in figure 4 in chapter 8.1. Based on the sailing profile the DGB engines operates approximately 26% of the time in diesel only mode. This limitation is caused by the technology path of fumigated gas injection. An alternative technology path is with direct gas injection like Wärtsilä on a medium speed engine. The advantage of this technology is that a higher gas substitution can be targeted. The advantage of a medium speed engine is that it has a superior fuel consumption at higher loads. From the graph below can be seen that if the load is above 70% a medium speed engines outperforms the diesel base case. This high load efficiency is penalized by low load efficiency. With loads below the 50% the specific fuel consumption rapidly offsets. Figure 40: specific fuel consumption of dual fuel engines 13.000 12.000 Energy Consumption [kWh] 11.000 10.000 9.000 8.000 7.000 6.000 0 000 000 000 800 1.000 1.200 Power [kW] Wärtsilä W6L20DF 3512 DGB 1120 bkW at 1600 rpm Cat 3512C Diesel
Sample 1
AutoNDA by SimpleDocs

Related to Dual Fuel Alternative

  • Alternative Work Schedule An alternate forty (40) hour work schedule (other than five (5) uniform and consecutive eight (8) hour days in a seven (7) day period), or for hospital personnel an eighty (80) hour workweek in a fourteen (14) day period and other mutually agreed upon schedules that comply with applicable federal and state law. Employee work schedules normally include two (2) consecutive days off.

  • Alternative A The grievance shall be determined by the Personnel Commission. The decision of the Commission shall be made in writing within sixty (60) calendar days after the filing of the appeal at step 3 and shall be final and binding on all parties subject to ratification by the Board of Supervisors if the decision requires an unbudgeted expenditure.

  • Alternate Work Schedule An alternate work schedule is any work schedule where an employee is regularly scheduled to work five (5) days per week, but the employee’s regularly scheduled two (2) days off are NOT Saturday and Sunday.

  • Excellent Above Average Satisfactory Needs Improvement Unsatisfactory 5 4 3 2 1 5. The instructor demonstrates knowledge of the subject matter.

  • Replacement Basic Cardmember About using your card You must tell us if the Basic Cardmember is no longer an employee or officer of the Company or does not want to be the Basic Cardmember. In that case, you must either close the Account, or propose another person to replace the Basic Cardmember. If you propose another person to replace the Basic Cardmember, that person must agree to assume the obligations and liabilities of the Basic Cardmember under this Agreement, as of the date that such person replaces the Basic Cardmember. That person is subject to our approval. You agree that the Basic Cardmember remains the Basic Cardmember until we approve a replacement or the Account is closed. Using the card Cards may be used for purchases. At our discretion, we may permit you to make cash advances, balance transfers or person-to-person transactions subject to Limits on person-to-person transactions. You cannot transfer balances from any other account issued by us and/or our affiliates. Each Cardmember acknowledges and agrees that cards are intended to be used for the Company's commercial or business purposes. You may arrange for certain merchants and third parties to store your card number and expiration date, so that, for example: ● the merchant may charge your account at regular intervals; or ● you may make charges using that stored card information. We may (but are not required to) tell these merchants and third parties if your expiration date or card number changes or if your account status is updated, including if your account is cancelled. If you do not want us to share your updated account information, please contact us using the number on the back of your card. Keep the cards safe. Do not let anyone use them. If a card is lost or stolen or the Account is being used without permission, contact us right away. The Account may not be used for illegal activities. Limits on person-to-person transactions Your person-to-person transactions may not exceed the $2,000 person-to-person transaction limit within any 30-day period. You agree to manage your Account so that the total of your person-to-person transactions in any 30-day period do not exceed the limit on person-to-person transactions. We may not approve a person-to-person transaction if it would cause your Account to exceed the person-to- person transaction limit or your Credit Limit. Promise to pay You promise to pay all charges, including: ● charges you make, even if you do not present your card or sign for the transaction, ● charges that other people make, whether or not you or an Additional Cardmember intend to let them use the Account, subject to applicable law, and if you let them use your Account, and ● charges that Additional Cardmembers make or permit others to make. Credit limit and cash advance limit We assign a Credit Limit to the Account. We may make part of the Credit Limit available for cash advances (Cash Advance Limit). There may also be a limit on the amount you can withdraw from ATMs in a given period. The Credit Limit and Cash Advance Limit are shown on page 1 of Part 1 and on each billing statement. We may increase or reduce the Credit Limit and Cash Advance Limit. We may do so even if you pay on time and the Account is not in default. You agree to manage the Account so that: ● the Account balance (including fees and interest) is not more than the Credit Limit, and ● the cash advance balance (including fees and interest) is not more than the Cash Advance Limit. We may approve charges that cause the Account balance to go over the Credit Limit. If we do this, we will not charge an overlimit fee. If we ask you to promptly pay the amount of the Account balance above the Credit Limit, you agree to do so. Declined transactions We may decline to authorize a charge. Reasons we may do this include suspected fraud and our assessment of your creditworthiness. This may occur even if the charge would not cause you to go over your Credit Limit and your Account is not in default. We are not responsible for any losses you or any Additional Cardmembers incur if we do not authorize a charge. And we are not responsible if any merchant refuses to accept the card. About your payments When you must pay You must pay at least the Minimum Payment Due by the Payment Due Date. The Minimum Payment Due and Payment Due Date are shown on each billing statement. Each statement also states the time and manner by which you must make your payment for it to be credited as of the same day it is received. For your payment to be considered on time, we must receive at least the Minimum Payment Due in such time and How to make payments Make payments to us in U.S. dollars with: ● a single check drawn on a U.S. bank, or ● a single negotiable instrument clearable through the U.S. banking system, for example a money order, or ● an electronic payment that can be cleared through the U.S. banking system. When making a payment by mail: ● make a separate payment for each Account, ● mail your payment to the address shown on the payment coupon on the billing statement, and ● write the Account number on your check or negotiable instrument and include the payment coupon. If your payment meets the above requirements, we will credit it to the Account as of the day we receive it, as long as we receive it by the time disclosed in the manner by the Payment Due Date shown on your billing statement. Each statement also shows a Closing Date. The Closing Date is the last day of the billing period covered by the statement. Each Closing Date is about 30 days after the previous statement's Closing Date. billing statement. If we receive it after that time, we will credit the payment on the day after we receive it. If your payment does not meet the above requirements, there may be a delay in crediting the Account. This may result in late fees and additional interest charges (see How Rates and Fees Work on page 2 of Part 1). We will not accept a payment made in a foreign currency or a payment drawn on an account at a bank located outside of the U.S. If we process a late payment, a partial payment, or a payment marked with any restrictive language, that will have no effect on our rights and will not change this Agreement. How we apply payments and credits Your Account may have balances with different interest rates. For example, purchases may have a lower interest rate than cash advances. If your Account has balances with different interest rates, here is how we generally apply payments in a billing period: ● We apply your payments, up to the Minimum Payment Due, first to the balance with the lowest interest rate, and then to balances with higher interest rates. ● After the Minimum Payment Due has been paid, we apply your payments to the balance with the highest interest rate, and then to balances with lower interest rates. In most cases, we apply a credit to the same balance as the related charge. For example, we apply a credit for a purchase to the purchase balance. We may apply payments and credits within balances, and among balances with the same interest rate, in any order we choose. About your Minimum Payment Due

  • Normal Work Schedule 130. Compensation fixed herein on a per diem basis are for a normal eight-hour work day; and on a bi-weekly basis for a bi-weekly period of service consisting of normal work schedules.

  • Alternative The provisions of Paragraph 5 will apply.

  • Equipment Return You may use the Leased Equipment provided under this plan only while you remain an active customer in good standing and in compliance with this Agreement (including, without limitation, the RCA). You must return all Leased Equipment in good operating condition, normal wear and tear excepted, within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment. If you acquired your Leased Equipment from a retailer, then you must return all Leased Equipment to: (A) your original retailer, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming; or (B) DISH, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs after such 30-day period. You are responsible for and shall bear all costs, expenses and risk of returning your Leased Equipment, including, without limitation, risk of loss during shipment. You are not responsible under the terms and conditions of this Agreement for the return of equipment other than your Leased Equipment. Following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment (unless you acquired your Leased Equipment from a retailer and the cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming and you returned Leased Equipment to such retailer within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment), DISH will send you one or more return labels or empty boxes (depending on your Leased Equipment) to be used by you in returning your Leased Equipment and DISH will charge you up to $20.00 for each such return label or empty box (“Box Return Fee”). The Box Return Fee is subject to change at any time. Unless you are a resident of a Remote Area of Alaska, you also have the option of contacting DISH by calling 000-000-XXXX (000-000-0000) to request that DISH or our designee(s) perform an in-home service call to remove your Leased Equipment at DISH’s then-current in-home service call rate, which rate is subject to change at any time. Leased Equipment will not be deemed returned until received by DISH. DISH Protect ===> Signature: DISH Protect is an optional service program currently priced as set forth in the table below. DISH Protect is offered in two (2) plans: Dish Protect and Plus. The services offered in each plan can be viewed at xxxxxx.xxx/xxxxxxxxxxx. If you enroll in a DISH Protect plan, you will receive an initial six (6) month trial offer of DISH Protect if you are eligible and if such plans are otherwise available to you at the time you sign this Agreement. During the trial offer period, you will be charged the monthly Trial Offer Price set forth below. By signing above, you are accepting the terms of this trial offer and understand that you may cancel or change your DISH Protect plan at any time by calling 000- 000-XXXX (3474) or by emailing xxxxxxxxxxxxxxxxxxxxxxxx@xxxx.xxx. You also agree that if you do not cancel your DISH Protect plan during the initial six (6) month trial offer period, DISH will automatically begin billing you the then-current monthly Regular Price of your DISH Protect plan upon the expiration of the six (6) month trial offer period until you cancel your DISH Protect plan. Not all DISH Protect plans are available to all customers. DISH Protect is not available to residents of Remote Areas of Alaska and/or residents of some Shared Dish MDU Properties. If you reside in a Shared Dish MDU Property and you are not sure if you qualify for DISH Protect, then please call 000-000-0000 to determine if you qualify. Plan Regular Price/month Trial Offer Price/month DISH Protect $10.99 $0.00 DISH Protect Plus $10.99 $0.00

  • Operating Schedule Purchaser shall, be- fore commencing operations, provide in writing an annual Operating Schedule of anticipated major activities and needs for logging Included Timber, such as logging, road maintenance, Scaling, and road construction, including construction staking under B5.212 and material delivery under B5.22. Upon reasonable notice to Forest Service, such schedule shall be subject to modifications necessi- xxxxx by weather, markets, or other unpredictable circum- stances. Subject to B6.6 and when the requirements of B6.66 are met, Purchaser’s Operations may be conducted out- side Normal Operating Season. “Normal Operating Sea- son” is the period(s) beginning and ending on the dates stated in A16 of any year.

  • Normal Work Week The normal work week shall be thirty-seven and one-half (37 1/2) hours, and the normal daily hours of work shall be seven and one-half (7 1/2) hours, exclusive of a meal period. The normal work week shall be Monday through Friday and the normal workday shall be scheduled between 7:00 a.m. and 6:00 p.m.

Time is Money Join Law Insider Premium to draft better contracts faster.