Earthing and lightning protection requirements Sample Clauses

Earthing and lightning protection requirements. The Contractor shall ensure all new equipment to be supplied as part of the works are properly bonded to the existing station earth mat. Contractor’s designs shall be in compliance with the Earthing and lighting Standard (240-56356396). If pure copper is to be used it must be painted or copper clad steel. The Contractor shall produce an earthing and lightning protection design for the HFPS and ESP system which interfaces with the existing Eskom substation plant earth mat. The Contractor ensures that the scope of supply is compatible with the “As Built” precipitator earthing design system. The Contractor submits at tender, the earthing and lightning concept designs drawings for the system in accordance with Eskom Standard Earthing and lighting Standard (240-56356396). The Contractor ensures that the HFPS units are adequately earthed for optimal operation and protection. If a return earth is required the connection point needs to be installed during the readiness outage by the Contractor. Earth continuity tests shall be performed by the Contractor and provide certification for quality controls.
Sample 1
AutoNDA by SimpleDocs

Related to Earthing and lightning protection requirements

  • ENERGY CONSERVATION REQUIREMENTS The Contractor agrees to comply with mandatory standards and policies relating to energy efficiency which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act.

  • Civil Rights Requirements The Recipient agrees that it must comply with applicable federal civil rights laws, regulations, and requirements, and follow applicable federal guidance, except as the Federal Government determines otherwise in writing. Therefore, unless a Recipient or a federal program, including the Indian Tribe Recipient or the Tribal Transit Program, is specifically exempted from a civil rights statute, FTA requires compliance with each civil rights statute, including compliance with equity in service requirements.

  • Compliance with Data Protection Laws Data Controller shall comply with all of its obligations under Data Protection Laws when Processing Personal Data.

  • Certification of Compliance with the Energy Policy and Conservation Act When appropriate and to the extent consistent with the law, Vendor certifies that it will comply with the Energy Policy and Conservation Act (42 U.S.C. 6321 et seq; 49 C.F.R. Part 18) and any mandatory standards and policies relating to energy efficiency which are contained in applicable state energy conservation plans issued in compliance with the Act. Does Vendor agree? Yes

  • COMPLIANCE WITH HEALTH, SAFETY, AND ENVIRONMENTAL REGULATIONS The Contractor, it’s Subcontractors, and their respective employees, shall comply fully with all applicable federal, state, and local health, safety, and environmental laws, ordinances, rules and regulations in the performance of the services, including but not limited to those promulgated by the City and by the Occupational Safety and Health Administration (OSHA). In case of conflict, the most stringent safety requirement shall govern. The Contractor shall indemnify and hold the City harmless from and against all claims, demands, suits, actions, judgments, fines, penalties and liability of every kind arising from the breach of the Contractor’s obligations under this paragraph.

  • Personnel Action Requirements The evaluation procedure contained in this agreement shall not be used in any decision concerning the assignment, reassignment, contract status, non-renewal, termination, reduction or recall of any counselor prior to May 1, 2018.

  • Fire, Life Safety, and Accessibility Codes The following codes, in the versions approved by the Georgia State Fire Marshal/Fire Safety Commissioner and Department of Human Resources, shall be used. The Design Professional will designate any additional codes or special modifications in the Supplementary General Conditions.

  • COMPLIANCE WITH HEALTH & SAFETY CODE § 25249 7(f) Xxxxxxxx agrees to comply with the reporting requirements referenced in Health & Safety Code § 25249.7(f).

  • National Environmental Policy Act All subrecipients must comply with the requirements of the National Environmental Policy Act (NEPA) 42 U.S.C. 4321 et seq., and the Council on Environmental Quality (CEQ) Regulations (40 C.F.R. Parts 1500-1508) for Implementing the Procedural Provisions of NEPA, which requires Subrecipients to use all practicable means within their authority, and consistent with other essential considerations of national policy, to create and maintain conditions under which people and nature can exist in productive harmony and fulfill the social, economic, and other needs of present and future generations of Americans.

  • COMPLIANCE WITH ENERGY POLICY AND CONSERVATION ACT Contractor certifies that Contractor will be in compliance with mandatory standards and policies relating to energy efficiency which are contained in the state energy conservation plan issued in compliance with the Energy Policy and Conservation Act (Pub. L. 94-163, 89 Stat. 871). Attachment A NorMont Equipment Co. Sewer Cleaning, Hydro-Excavating, Inspection Equipment and Miscellaneous Services Contract No. SC01-21A H-GAC PRODUCT ITEM BASE OFFERING PRICES H-GAC Product Code Description Base Offered Price Envirosight

Time is Money Join Law Insider Premium to draft better contracts faster.