Environmental Standards If the contract amount set forth in this Contract is in excess of $100,000, the Contractor shall comply with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. § 7606), section 508 of the Clean Water Act (33 U.S.C. § 1368), Executive Order 11738, and Environmental Protection Agency regulations (2 C.F.R. Part 1532), which prohibit the use under non-exempt Federal contracts of facilities included on the EPA List of Violating Facilities. The Contractor shall report any violations of this paragraph to the State of Indiana and to the United States Environmental Protection Agency Assistant Administrator for Enforcement.
OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.
Environmental Health and Safety i. Environment, Health and Safety Performance. Seller acknowledges and accepts full and sole responsibility to maintain an environment, health and safety management system ("EMS") appropriate for its business throughout the performance of this Contract. Buyer expects that Seller’s EMS shall promote health and safety, environmental stewardship, and pollution prevention by appropriate source reduction strategies. Seller shall convey the requirement of this clause to its suppliers. Seller shall not deliver goods that contain asbestos mineral fibers.
Environmental, Health and Safety Laws There does not exist any violation by the Borrower or any of its Subsidiaries of any applicable federal, state or local law, rule or regulation or order of any government, governmental department, board, agency or other instrumentality relating to environmental, pollution, health or safety matters which has, will or threatens to impose a material liability on the Borrower or any of its Subsidiaries or which has required or would require a material expenditure by the Borrower or any of its Subsidiaries to cure. Neither the Borrower nor any of its Subsidiaries has received any notice to the effect that any part of such Person’s operations or properties is not in material compliance with any such law, rule, regulation or order or notice that it or its property is the subject of any governmental investigation evaluating whether any remedial action is needed to respond to any release of any toxic or hazardous waste or substance into the environment, which non-compliance or remedial action could reasonably be expected to constitute a Material Adverse Occurrence. Except as set out on Schedule 4.7 of the Disclosure Schedules, the Borrower does not have knowledge that it, any of its Subsidiaries or any of their respective property will become subject to environmental laws or regulations during the term of this Agreement, compliance with which could reasonably be expected to require significant Capital Expenditures or to constitute a Material Adverse Occurrence.
Manufacturing Standards All forest products except poles, produced and sold under this contract will be manufactured to maximize the amount of logs meeting preferred log lengths and to achieve the average log length listed. 97318 3 WS "WS" indicates that west side scaling rules apply. Minimum trim is 8 inches per scaling segment for west side scaling rules. "ES" indicates that east side scaling rules apply. Minimum trim is 4 inches per scaling segment for east side scaling rules. Poles produced under this contract will be manufactured to ANSI specifications (American National Standard Specifications and Dimensions for Wood Poles), in force at the time of signing this contract.
a. Sweep will be limited to within the bole of the log as measured using a tape stretched between the centers of each end of the log.
b. Logs approved by the state for peelers shall be chuckable with no more than a 2 inch diameter area of rot within a 5 inch diameter circle located at the center of either end of the log.
c. Limbs and knots shall be cut flush, with no more than 15 percent of a log having limbs or knots over 2 inches in diameter extending more than 2 inches above the surface of the log.
Environmental, Health and Safety Matters (a) Comply in all material respects with all applicable Environmental Laws, including, without limitation, obtaining and complying with and maintaining any and all licenses, approvals, notifications, registrations or permits required by applicable Environmental Laws. For purposes of this Section 5.12(a), material noncompliance by the Company, any of its Subsidiaries or any tenant or subtenant, with any applicable Environmental Law shall be deemed not to constitute a breach of this covenant provided that, upon learning of any actual or suspected material noncompliance, the Company and the relevant Subsidiaries shall promptly undertake all reasonable efforts to achieve material compliance (or contest in good faith by appropriate proceedings the alleged violation or applicable Environmental Law at issue and (to the extent required by GAAP) provide on the books of the Company or any of its Subsidiaries, as the case may be, reserves in accordance with GAAP with respect thereto), and provided further that, in any case, such noncompliance, and any other noncompliance with applicable Environmental Law, individually or in the aggregate, could not reasonably be expected to have a Material Adverse Effect.
(b) Promptly comply in all material respects with all lawful orders and directives of all Governmental Authorities regarding applicable Environmental Laws, except to the extent that the validity thereof is currently being contested in good faith by appropriate proceedings and (to the extent required by GAAP) reserves in accordance with GAAP with respect thereto have been provided on the books of the Company or any of its Subsidiaries, as the case may be.
(c) Defend, indemnify and hold harmless the Administrative Agent and the Lenders, and their respective parents, subsidiaries, affiliates, employees, agents, officers and directors, from and against any claims, demands, penalties, fines, liabilities, settlements, damages, costs and expenses of whatever kind or nature, known or unknown, contingent or otherwise, arising out of, or in any way relating to the violation of, noncompliance with or liability under any Environmental Laws applicable to the Company or any of its Subsidiaries or any of their respective operations or properties, or any orders, requirements or demands of Governmental Authorities related thereto, including, without limitation, attorney’s and consultant’s fees, investigation and laboratory fees, response costs, court costs and litigation expenses, except to the extent that any of the foregoing arise out of the gross negligence or willful misconduct of (or, as determined pursuant to a claim initiated by the Company, breach in bad faith of its express obligations under the applicable Loan Documents by) the party seeking indemnification therefor, in each case, as determined by a final non-appealable judgment by a court of competent jurisdiction. This indemnity shall continue in full force and effect regardless of the termination of this Agreement.
Quality Standards Each Party agrees that the nature and quality of its products and services supplied in connection with the other Party's Marks will conform to quality standards set by the other Party. Each Party agrees to supply the other Party, upon request, with a reasonable number of samples of any Materials publicly disseminated by such Party which utilize the other Party's Marks. Each Party will comply with all applicable laws, regulations, and customs and obtain any required government approvals pertaining to use of the other Party's marks.
Operating Standards (A) Distributor and its Dealer(s) shall conduct the operation of their respective businesses related to the resale of the Product(s) in a clean and safe manner and shall otherwise conduct no business which could interfere with the sale of Product(s) or damage the goodwill of the Valero brand or the Marks. Without limiting the foregoing, Distributor and its Dealer(s) shall, at all times during the term of this Agreement, fully comply with VMSC’s then current “Basic Operational Requirements” which Distributor acknowledges have been received and reviewed by Distributor. Furthermore, without limiting any provision to the contrary herein, Distributor and its Dealer(s) shall fully comply with VMSC’s “Commitment to Excellence Requirements”, which Distributor acknowledges have been received and reviewed by Distributor. As of the Commencement Date, Distributor and its Dealer(s) agree to participate in the Commitment to Excellence Program (“CTE Program”). The CTE Program provides that each Station meets the established Commitment to Excellence Requirements which consists of requirements from each of the following VMSC documents: VMSC’s Basic Image Requirements, Wholesale Branding Manual, and Basic Operational Requirements. VMSC reserves the right to amend, change, or otherwise modify the “Basic Operational Requirements”, “Commitment to Excellence Requirements” and the “CTE Program” from time to time, in VMSC’s sole and absolute discretion.
(B) Distributor and its Dealer(s) shall comply with all Laws of any governing authority or agency having jurisdiction or purporting to have jurisdiction relating to the handling, storage, testing, sale, distribution, transportation, and/or use of the Product(s) and shall further comply with all rules, guidelines, and procedures of VMSC in connection with the loading, transportation, handling, storing, testing, selling, dispensing, and/or use of the Product(s).
(C) Subject to Paragraph 12 of this Agreement, Distributor and its Dealer(s) shall continuously offer at least three grades of “Valero” branded gasoline at each Station.
(D) Distributor and its Dealer(s) will utilize and maintain updated point of sale systems as required by VMSC. VMSC also reserves the right to install, and Distributor and its Dealer(s) agree to utilize, update and maintain, other automated systems, at Distributor’s cost, as required by VMSC, including but not limited, such systems necessary to poll, at frequencies determined by VMSC, each Station’s Product sales.
(E) VMSC may inspect or review compliance by Distributor and its Dealer(s) with the requirements of this Paragraph 8 in any reasonable manner that VMSC determines, including, but not limited to, announced and unannounced visits.
(F) Distributor expressly understands and agrees that a confidential relationship is established between VMSC and Distributor under this Agreement and that, as a result thereof, VMSC will be disclosing and transmitting to Distributor certain confidential and proprietary information in connection with the Distributor’s operation of the Station. Distributor hereby agrees that Distributor shall not, during the term of this Agreement or thereafter, communicate, divulge or use for the benefit of any other person, persons, partnership, association or corporation and, following the expiration or termination of this Agreement, shall not use for the benefit of Distributor, or any of its principals, any confidential information, knowledge or know-how concerning the methods of operation (including pricing) of the Station which may be communicated to Distributor or its principals or of which they may be apprised in connection with the operation of the Station(s) under the terms of this Agreement. Distributor shall divulge such confidential information only to such of Distributor’s employees as must have access to it in order to operate the Station(s). Any and all information, knowledge, know-how, techniques and any materials used in or related to the Station which VMSC provides to Distributor in connection with this Agreement shall be deemed confidential for purposes of this Agreement. Such confidential information does not include information that, at the time it was disclosed to or learned by Distributor, was part of the public domain, nor information that, after the time it was disclosed to or learned by Distributor, became part of the public domain through disclosure, publication or communication by persons other than Distributor or its employees. Distributor shall not at any time, without VMSC’s prior written consent, copy, duplicate, record or otherwise reproduce such materials or information, in whole or in part, nor otherwise make the same available to any unauthorized person.
(G) Distributor acknowledges that strict compliance with the terms and conditions of this Paragraph 8 is a material and important part of the consideration for this Agreement.
OCCUPATIONAL HEALTH & SAFETY (a) It is a mutual interest of the parties to promote health and safety in workplaces and to prevent and reduce the occurrence of workplace injuries and occupational diseases. The parties agree that health and safety is of the utmost importance and agree to promote health and safety and wellness throughout the organization. The employer shall provide orientation and training in health and safety to new and current employees on an ongoing basis, and employees shall attend required health and safety training sessions. Accordingly, the parties fully endorse the responsibilities of employer and employee under the Occupational Health and Safety Act, making particular reference to the following:
Safety Standards Performance of the Contract for all commodities or contractual services must comply with requirements of the Occupational Safety and Health Act and other applicable State of Florida and federal requirements.
