Defective Work Work that, for any reason, is not in compliance with the Contract Documents. Defective Work is usually identified in a Notice of Non-Compliant Work.
Maximum Liability The provisions of this Loan Guaranty are severable, and in any action or proceeding involving any state corporate law, or any state, federal or foreign bankruptcy, insolvency, reorganization or other law affecting the rights of creditors generally, if the obligations of any Loan Guarantor under this Loan Guaranty would otherwise be held or determined to be avoidable, invalid or unenforceable on account of the amount of such Loan Guarantor’s liability under this Loan Guaranty, then, notwithstanding any other provision of this Loan Guaranty to the contrary, the amount of such liability shall, without any further action by the Loan Guarantors or the Lenders, be automatically limited and reduced to the highest amount that is valid and enforceable as determined in such action or proceeding (such highest amount determined hereunder being the relevant Loan Guarantor’s “Maximum Liability”. This Section with respect to the Maximum Liability of each Loan Guarantor is intended solely to preserve the rights of the Lenders to the maximum extent not subject to avoidance under applicable law, and no Loan Guarantor nor any other person or entity shall have any right or claim under this Section with respect to such Maximum Liability, except to the extent necessary so that the obligations of any Loan Guarantor hereunder shall not be rendered voidable under applicable law. Each Loan Guarantor agrees that the Guaranteed Obligations may at any time and from time to time exceed the Maximum Liability of each Loan Guarantor without impairing this Loan Guaranty or affecting the rights and remedies of the Lenders hereunder, provided that, nothing in this sentence shall be construed to increase any Loan Guarantor’s obligations hereunder beyond its Maximum Liability.
Liability for defects 5.1 The Customer is required to inspect the delivered Products without undue delay after delivery and to report any defects.
5.2 The delivered Products are deemed to have been approved if XXXX, with regard to obvious defects, obvious shortages or other defects which were or would have been identifiable in the course of an immediate, careful inspection, has not received notifi- cation of the defect within 7 days of delivery of the product, or otherwise – in the case of unclear or hidden defects – within 7 days of the discovery of the defect or the time at which the defect was identifiable to the Customer in the course of normal use of the Product without closer inspection.
5.3 In the event of a justified complaint, the Customer will be entitled to two attempts to rectify defects or make a replacement delivery at XXXX'x discretion free of charge within a reasonable period of time. Shortages will be delivered subsequently. If two attempts to rectify defects or make a replacement delivery within a reasonable period of time are unsuccessful, the Customer will be entitled to the statutory rights, subject to the provisions of clause 7. Subsequent performance will include neither removal of the defective item nor reassembly if XXXX was not originally required to carry out assembly. The expenses required for the purpose of inspection and subsequent performance, in particular transport, travel, labour and material costs (not: removal and assembly costs), insofar as these are not increased because the subject matter of the contract is located at a place other than our Customer's place of performance, will be borne by XXXX if there is actually a defect. Otherwise, XXXX may demand compensation from the Customer for the costs incurred by the unjustified request for rectification of the defect (in particular inspection and transport costs), unless the lack of defectiveness was not identifiable for the Customer. XXXX can refuse to rectify defects or make a replacement delivery if the Customer does not fulfil its payment obligations towards XXXX to an extent that corresponds to the defect-free part of the service provided.
5.4 No warranty will be assumed, in particular, in the following cases: Unsuitable or in- correct use by the Customer or by third parties instructed by the Customer, in particular through the use of insufficiently qualified personnel, faulty assembly or commission- ing, natural wear and tear (wearing parts), faulty or negligent handling, improper maintenance, unsuitable operating materials, defective construction work, unsuitable construction land, chemical, electrochemical or electrical influences, provided XXXX is not responsible for these circumstances.
5.5 XXXX is also not required to provide a warranty insofar as defects of Products are based on defective materials supplied by the Customer or insofar as defects of Products are based on the fact that the Customer has prescribed the execution of the order ac- cording to construction plans of third parties.
5.6 A delivery of used Products agreed with the Customer in the individual case is made to the exclusion of any warranty, unless XXXX has caused the defect intentionally or through gross negligence or has fraudulently concealed the defect.
5.7 The warranty period will be one year from delivery or, where acceptance was stipu- lated, from acceptance. Replaced parts will become our property and must be sent to us at our request. If shipping, assembly or commissioning is delayed through no fault of our own, our liability will expire no later than twelve months after the transfer of risk.
5.8 The right of recovery in accordance with sections 445a, 445b German Civil Code (BGB) is excluded, unless XXXX has caused the defect intentionally or by gross neg- ligence or has fraudulently concealed the defect.
Warranty; Limitation of Liability 6.1 Nothing in this Agreement shall be deemed a warranty and any and all warranties in respect of the Program are exclusively set forth in the warranty policy available at xxx.xxxxxxxxxxx.xxx or upon Licensee's request.
6.2 In no event shall Licensor (including its officers, directors, employees and agents and its suppliers and licensors) be liable to Licensee (including any other entity or person related to or affiliated with Licensee) for any incidental, consequential, indirect, special or punitive damages whatsoever, or for any lost profits or revenue, lost business opportunities, lost or inaccessible data or information, or other pecuniary loss, arising out of or relating to this Agreement or the subject matter hereof, whether liability is asserted in contract or tort (including negligence or strict product liability) or otherwise, and irrespective of whether Licensor (including its officers, directors, employees and agents and its suppliers and licensors) has been advised of the possibility of any such damage or loss.
6.3 In no event shall Licensor's (including its officers, directors, employees and agents and its suppliers and licensors) aggregate liability under or arising out of or relating to this Agreement or the subject matter hereof exceed the Fees paid by Licensee to Licensor hereunder for the license of the applicable Program. LICENSEE ACKNOWLEDGES THAT THE PRICING OF THE PROGRAM AND THE OTHER TERMS AND CONDITIONS OF THIS AGREEMENT REFLECT THE ALLOCATION OF RISK SET FORTH IN THIS AGREEMENT AND THAT LICENSOR WOULD NOT ENTER INTO THIS AGREEMENT WITHOUT THESE LIMITATIONS OF ITS LIABILITY.
6.4 The limitations of liability in Sections 6.1 and 6.2 above do not apply (a) with respect to product liability arising under laws implementing Council Directive 85/374/EEC of 25 July 1985 on the approximation of the laws, regulations and administrative provisions of the Member States concerning liability for defective products, to the extent liability cannot be contractually limited or disclaimed under such laws, (b) with respect to bodily injury, and (c) to the extent such damage or loss is the result of Licensor's intentional or grossly negligent conduct. Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to Licensee.
Nonconforming Work 5.6.1 Rejection, Removal and Replacement of Nonconforming Work
Compensation for Damage or Loss 1. When investments made by investors of either Contracting Party suffer loss or damage owing to war or other armed conflict which is not a result of the activities of the Contracting Party to which the investors belong, civil disturbances, revolution, riot or similar events in the territory of the latter Contracting Party, they shall be accorded by the latter Contracting Party, treatment, as regards restitution, indemnification, compensation or any other settlement, not less favourable than that that the latter Contracting Party accords to its own investors or to investors of any third State, whichever is most favourable to the investors concerned.
2. Without prejudice to paragraph 1 of this Article, investors of one Contracting Party who in any of the events referred to in that paragraph suffer damage or loss in the territory of the other Contracting Party resulting from:
a) requisitioning of their property or part thereof by its forces or authorities;
b) destruction of their property or part thereof by its forces or authorities which was not caused in combat action or was not required by the necessity of the situation, shall be accorded a prompt restitution, and where applicable prompt, adequate and effective compensation for damage or loss sustained during the period of requisitioning or as a result of destruction of their property. Resulting payments shall be made in freely convertible currency without delay.
3. Investor whose investments suffer damage or loss in accordance to paragraph 2. of this Article, shall have the right to prompt review of its case by a judicial or other competent authority of that Contracting Party and of valuation of its investments and payment of compensation in accordance with the principles set out in paragraph 2. of this Article.
Exceptions from Liability Without limiting the generality of any other provisions hereof, neither the Custodian nor any Domestic Subcustodian shall be under any duty or obligation to inquire into, nor be liable for:
Aggregate Liability The aggregate liability of either: (a) Customer, its Affiliates and Participating Entities; or (b) Verizon and its Affiliates, to the others collectively for any and all Events in an Annual Period is limited to an amount equal to 12 times the Average Monthly Charges during the Annual Period in which an Event first occurred. For the purpose of this clause and calculation, where: (i) an Event gives rise to a number of separate liabilities, claims or causes of action, and/or (ii) there is a series of connected Events, such will be considered a single Event and will be deemed to have occurred in the Annual Period in which the first Event occurred.
Extent of Liability; Contribution (a) Notwithstanding anything herein to the contrary, each Borrower’s liability under this Section 5.11 shall be limited to the greater of (i) all amounts for which such Borrower is primarily liable, as described below, and (ii) such Borrower’s Allocable Amount.
(b) If any Borrower makes a payment under this Section 5.11 of any Obligations (other than amounts for which such Borrower is primarily liable) (a “Guarantor Payment”) that, taking into account all other Guarantor Payments previously or concurrently made by any other Borrower, exceeds the amount that such Borrower would otherwise have paid if each Borrower had paid the aggregate Obligations satisfied by such Guarantor Payments in the same proportion that such Borrower’s Allocable Amount bore to the total Allocable Amounts of all Borrowers, then such Borrower shall be entitled to receive contribution and indemnification payments from, and to be reimbursed by, each other Borrower for the amount of such excess, pro rata based upon their respective Allocable Amounts in effect immediately prior to such Guarantor Payment. The “Allocable Amount” for any Borrower shall be the maximum amount that could then be recovered from such Borrower under this Section 5.11 without rendering such payment voidable under Section 548 of the Bankruptcy Code or under any applicable state fraudulent transfer or conveyance act, or similar statute or common law.
(c) Nothing contained in this Section 5.11 shall limit the liability of any Borrower to pay Loans made directly or indirectly to that Borrower (including Loans advanced to any other Borrower and then re-loaned or otherwise transferred to, or for the benefit of, such Borrower), LC Obligations relating to Letters of Credit issued to support such Borrower’s business, and all accrued interest, fees, expenses and other related Obligations with respect thereto, for which such Borrower shall be primarily liable for all purposes hereunder. Agent and Lenders shall have the right, at any time in their discretion, to condition Loans and Letters of Credit upon a separate calculation of borrowing availability for each Borrower and to restrict the disbursement and use of such Loans and Letters of Credit to such Borrower.
Defects Liability Period (i) The Contractor shall be responsible for all the Defects and deficiencies, except usual wear and tear in the Project Highway or any Section thereof, till the expiry of a period of commencing from the date of Completion Certificate (the “Defects Liability Period”) as specified below:
(a) 5 (five) years from the date of completion in case of a road being constructed with flexible pavement;
(b) 10 (ten) years from the date of completion in case of road being constructed with rigid pavement;
(c) 10 (ten) years from the date of completion in case of road being constructed with flexible pavement using perpetual design;
(d) 10 (ten) years from the date of completion in case of all stand-alone structures, e.
