Example for arm alignment Sample Clauses

Example for arm alignment. Size indication The dynamic tests shall be conducted with the largest dummy and the smallest dummy as defined in the following tables according to the size range indicated by the manufacturer for the Enhanced Child Restraint System. size range indication ≤ 60 60 < x ≤ 75 75 < x ≤ 87 87 < x ≤ 105 105 < x ≤ 13525 >13525 Dummy Q0 Q1 Q1.5 Q3 Q6 Q101 1 No lateral impact test is required for size range over 135 cm until Q10 dummy injury criteria for the lateral impact test are established. Where the Enhanced Child Restraint System requires substantial modification for different sizes (e.g., convertible Enhanced Child Restraint System) or if the size range cover more than 3 size ranges a relevant intermediate dummy(ies) shall be tested in addition to the dummy(ies) defined above. If the Enhanced Child Restraint System is designed for two or more children, one test shall be carried out with the heaviest dummies occupying all seatingpositions. A second test with the lightest and the heaviest dummies specified above shall be carried out. The tests shall be conducted using the test benchas shown in Annex 6, Appendix 3, Figure 3. The laboratory conducting the tests may, if it deems it advisable, add a third test with any combination of dummies or empty seat positions. If the i-Size Enhanced Child Restraint System uses a top tether, one test shall be carried out with the smallest dummy with the shorter distance of the top tether (anchorage point G1). A second test shall be carried out with the heavier dummy with the longer distance of the top tether (anchorage point G2). Adjust the top tether to achieve a tension load of 50 ± 5 N. For side lateral impact the ISOFIX child restraint shall be tested with only the shorter distance of the top tether. If the i-Size Enhanced Child Restraint System uses a support-leg, as an anti-rotation device the hereafter mentioned dynamic tests shall be carried out as follows: The tests for frontal impact shall be conducted with the support-leg adjusted to its maximum adjustment compatible with the positioning of the trolley floor pan. The tests for rear impact shall be conducted with the worst case position selected by the Technical Service. During the tests the support-leg shall be supported by the trolley floor pan as described in Annex 6, Appendix 32, figure 2; In the case of support-legs out of the plane of symmetry, the worst case shall be selected by the Technical Service for the test; In the case of "specific vehicle ISOFIX" catego...
AutoNDA by SimpleDocs

Related to Example for arm alignment

  • Uncontrollable Forces Tariff Provisions Section 14.1 of the CAISO Tariff shall be incorporated by reference into this Agreement except that all references in Section 14.1 of the CAISO Tariff to Market Participants shall be read as a reference to the Participating Generator and references to the CAISO Tariff shall be read as references to this Agreement.

  • Separation of Components The SOFTWARE PRODUCT is licensed as a single product. Its component parts may not be separated for use on more than one computer.

  • System for Award Management (XXX) Requirement Alongside a signed copy of this Agreement, Grantee will provide Florida Housing with a XXX.xxx proof of registration and Commercial and Government Entity (CAGE) number. Grantee will continue to maintain an active XXX registration with current information at all times during which it has an active award under this Agreement.

  • Individual Flexibility Arrangement 12.1 The Employer and an Employee covered by this Agreement, may agree to make an Individual Flexibility Arrangement to vary the following terms of this Agreement if: (a) the arrangement deals with one or more of the following matters: (i) arrangements about where and when work is performed; (ii) overtime rates; (iii) penalty rates; (iv) allowances; or (v) annual leave loading; (b) the arrangement must meet the genuine needs of the Employer and Employee in relation to one or more of the matters mentioned in subclause 14.1 (a); and (c) the arrangement is genuinely agreed to by the Employer and the Employee. 12.2 The Employer must ensure that the terms of the Individual Flexibility Arrangement: (a) are about permitted matters under section 172 of the Act; (b) are not unlawful terms under section 194 of the Act; (c) result in the Employee being better off overall than the Employee would be if no agreement was made. 12.3 The Employer must ensure that the Individual Flexibility Arrangement: (a) is in writing; (b) includes the name of the Employer and the Employee; (c) is signed by the Employer and the Employee, and if the Employee is under 18 years of age, signed by a parent or guardian of the Employee; (d) Includes details of: (i) the terms of the Agreement that will be varied by the arrangement; (ii) how the arrangement will vary the effect of the terms; (iii) how the Employee will be better off overall in relation to the terms and conditions of their employment as a result of the arrangement; and (e) states the day on which the arrangement commences; 12.4 The Employer must give the Employee a copy of the Individual Flexibility Arrangement within 14 days after it is agreed to. 12.5 The Employer or Employee may terminate the Individual Flexibility Arrangement; (a) by giving no more than 28 days written notice to the other party to the arrangement; or (b) if the Employer and the Employee agree in writing – at any time.

  • Individual Flexibility Arrangements 38.1 Where the Employer wants to enter into a individual flexibility arrangement (IFA) it must provide a written proposal to the Employee. Where the Employee’s understanding of written English is limited, the Employer must take measures, including translation into an appropriate language, to ensure the Employee understands the proposal. 38.2 The Employer and an Employee covered by this Agreement may agree to make an IFA to vary the effect of terms of the Agreement if: (a) it deals with one or more of the following matters: (i) Time between which ordinary hours are worked; (ii) Salary sacrifice Agreements; (iii) Reduction in ordinary hours; (iv) Increase in annual leave accrual each year; (v) Increase in rate of accrual of Rostered days off; (vi) Increase in wages; (vii) Increase in training leave (Union or otherwise); (b) The IFA meets the genuine needs of the Employer and the Employee covered by this Agreement in relation to one or more of the matters mentioned in paragraph (a) above; and (c) The IFA is genuinely agreed to by the Employer and the Employee. 38.3 The Employer must ensure that the terms of the IFA: (a) are about permitted matters under section 172 of the FW Act; and (b) are not unlawful terms under section 194 of the FW Act; and (c) result in the Employee being better off overall than the Employee would be if no IFA was made. 38.4 The Employer must also ensure that any such IFA is: (a) in writing (including details of the terms that will be varied, how the IFA will vary the effect of the Enterprise Agreement terms, how the Employee will be better off overall in relation to the terms and conditions of his or her employment as a result of the IFA, and the day on which the IFA commences); (b) includes the name of the Employer and Employee; (c) signed by the Employer and the Employee, and if the Employee is under 18, by a parent or guardian of the Employee; and (d) provided to the Employee within 14 days after it is agreed to. 38.5 The Employer or Employee may terminate the IFA by either the Employer or Employee giving written notice of not more than 28 days, or at any time by both parties agreeing in writing. 38.6 Where any of the requirements of ss 202 and 203 of the FW Act are not met, the IFA is of no effect.

  • Description of Change in Terms A. Modification(s)

  • Program Changes Contractor agrees to inform the County of any alteration in program or service delivery at least thirty (30) days prior to the implementation of the change, or as soon as reasonably feasible.

  • Master Feeder Structure If permitted by the 1940 Act, the Board of Trustees, by vote of a majority of the Trustees, and without a Shareholder vote, may cause the Trust or any one or more Series to convert to a master feeder structure (a structure in which a feeder fund invests all of its assets in a master fund, rather than making investments in securities directly) and thereby cause existing Series of the Trust to either become feeders in a master fund, or to become master funds in which other funds are feeders.

  • MINOR CHANGES IN THE WORK If permitted in the agreement between Owner and Architect, the Architect has authority to order minor changes in the Work not involving adjustment in the Contract Sum or extension of the Contract Time and not inconsistent with the intent of the Contract Documents.

  • Implementation of Changes If Tenant: (i) approves in writing the cost or savings and the estimated extension in the time for completion of Landlord’s Work, if any, and (ii) deposits with Landlord any Excess TI Costs required in connection with such Change, Landlord shall cause the approved Change to be instituted. Notwithstanding any approval or disapproval by Tenant of any estimate of the delay caused by such proposed Change, the TI Architect’s determination of the amount of Tenant Delay in connection with such Change shall be final and binding on Landlord and Tenant.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!