Fixed Shift System. A fixed shift system shall be maintained by the Corporation during the life of the Collective Agreement.
Fixed Shift System Sample Clauses
Related to Fixed Shift System
Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers. 5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem. 5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.
Hour Shifts When the Employer deems it necessary to implement a twelve (12) hour work day, affected employees shall be notified pursuant to Clause 14.05. The following Clauses shall be replaced or added to the Collective Agreement where appropriate.
Day Shift The standard work day will consist of eight (8) hours worked between the hours of 7:00 a.m. and 4:30 p.m. with a designated thirty (30) minute lunch period. Starting and stopping times to be determined by mutual agreement between the Company and the shop employees.
Shift Rotation Routine shift rotation is not an approach to staffing endorsed by the Employer. Except for emergency situations where it may be necessary to provide safe patient care, shift rotation will not be utilized without mutual consent. If such an occasion should ever occur, volunteers will be sought first. If no one volunteers, the Employer will rotate shifts on an inverse seniority basis until the staff vacancies are filled.
Hour Shift An eight (8) hour tour shall be inclusive of an unpaid one-half (1/2) hour meal period, and two fifteen (15) minute paid relief periods.
Shift Trades 6.16.01 Employees may arrange for another employee to work their shift subject to the Manager's approval, consistent with the following: 6.16.01.01 Other than in exceptional circumstances, advice of the trade will be provided to the Manager in writing, in advance, and will be signed by the employees involved. 6.16.01.02 The employee who works a traded shift will be paid for the time worked at his/her rate of pay. 6.16.01.03 Overtime worked prior to or following a traded shift and premium credits on a holiday, in accordance with Article 7.03 and Article 13 respectively, will be credited to the employee who worked the shift as though the shift had been the employee's scheduled shift. 6.16.01.04 All recall credits will be credited to the employee who is recalled. 6.16.01.05 All time debits will be deducted from the employee who agreed to work the shift. 6.16.01.06 Company sick leave provisions will apply to the employee who agreed to work the shift and only to the amount provided for in such regulations. All time not worked in excess of one (1) full shift during a work day shall be debited in accordance with Article 6.16.01.05. 6.16.01.07 Shift trades may only be arranged between employees working in the same location except that, at locations with thirty (30) or less full-time employees, shift trades may be arranged by employees at these locations with employees at other locations within the same base and classification. Such shift trades may be granted subject to the employees concerned being qualified to perform the work function of the other party. 6.16.01.08 An employee's ability to trade shifts is not intended to allow employees to be absent from the work place for extended periods of time nor to take alternate employment. 6.16.01.09 Partial shift trades are permitted provided that no shift is split into more than two (2) parts. No more than two (2) employees may cover a single shift. Partial 6.16.01.10 It will be the sole responsibility of the employees to ensure that the introduction of partial shift trades has absolutely no adverse operational and customer service impact. 6.16.01.11 Under no circumstances shall an employee be allowed to leave his/her assigned duties or work area until their task is completed. His/her “shift trade partner” must be present and ready to take over their next assignment. This transition needs to be seamless to the customer. 6.16.01.12 There will not be additional meal or rest periods assigned to a shift subject to a partial shift trade. Meal and rest periods will be taken as scheduled. 6.16.01.13 A minimum of one (1) hour must be worked by one of the employees involved with a partial shift trade. 6.16.01.14 Any violation of the terms set out herein will result in the immediate suspension of the “partial shift trade privileges” for the employee. Such a measure will be deemed to be of an administrative nature and will not be grievable under any circumstances except as provided below. 6.16.01.15 Notwithstanding the above, the Union may file a grievance only to allege that the violation for which the partial shift trade privileges were revoked did not occur. The Union will bear the onus of the burden of proof in such circumstances. 6.16.01.16 Rules governing such other matters as deadlines for, and approval of, partial shift trade requests will be adopted locally.
Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.
Afternoon Shift (i) Afternoon Shift is any shift where the normal ceasing time is later than 6.00 p.m. but not later than midnight. (ii) The additional loading for ordinary hours only shall be twenty-five percent (25%) of the all purpose rate applying to the Employees' classification.
Usage Measurement Usage measurement for calls shall begin when answer supervision or equivalent Signaling System 7 (SS7) message is received from the terminating office and shall end at the time of call disconnect by the calling or called subscriber, whichever occurs first.
Switching System Hierarchy and Trunking Requirements For purposes of routing ECI traffic to Verizon, the subtending arrangements between Verizon Tandem Switches and Verizon End Office Switches shall be the same as the Tandem/End Office subtending arrangements Verizon maintains for the routing of its own or other carriers’ traffic (i.e., traffic will be routed to the appropriate Verizon Tandem subtended by the terminating End Office serving the Verizon Customer). For purposes of routing Verizon traffic to ECI, the subtending arrangements between ECI Tandem Switches and ECI End Office Switches shall be the same as the Tandem/End Office subtending arrangements that ECI maintains for the routing of its own or other carriers’ traffic.
